AFM study of the stability of a dense affinity-bound liposome layer

Sizing Single Particles at the Orifice of a Nanopipette

Developing new methods and techniques for the size analysis of particles in a solution is highly desirable not only for the industrial screening of particles but also for single biological entity analysis (e.g., single cells or single vesicles). Herein, we report a new technique for sizing single particles in a solution with a nanopipette. The rationale is essentially based on ion-current blockage when the particles approach the proximity of a nanopipette orifice. By rationally controlling the geometry of the nanopipette and the applied potential, the spike-type ion current transient generated from the motion of particles in the process of "collision and departure" is employed for sizing single particles. The results show that both the relative ion-current change (ΔI/I₀) and the dwell time (Δt) of spike-type transient are dependent on particle size. Differently, Δt is also related to an externally applied voltage. Statistical analysis shows that ΔI/I₀ is proportional to the particle diameter, and this linear relationship is further understood by finite-element simulations. This study not only provides a new principle for sizing single particles in a solution but also is helpful to understand the motion of a particle near the orifice of the nanopipette.

Glucosamine sulphate-loaded distearoyl phosphocholine liposomes for osteoarthritis treatment: combination of sustained drug release and improved lubrication

Osteoarthritis (OA) is a chronic joint disease resulting from joint inflammation and damage. In this study, we employed a boundary lubricant known as a 1,2-distearoyl-sn-glycero-3-phosphocholine (DSPC) liposome for loading of an anti-inflammatory drug d-glucosamine sulphate (GAS) to construct a treatment strategy allowing for sustained anti-inflammation and reduced damage. This kind of drug-loaded nanocarrier integrates the anti-inflammatory effect of the GAS and the lubrication ability of DSPC liposomes without the involvement of complex synthesis processes leading to easier popularization. Our experimental results indicated that the GAS-loaded DSPC liposomes could release GAS in a sustained manner while providing good lubrication in pure water (H2O) and phosphate buffered saline (PBS). Moreover, the GAS-loaded DSPC liposomes prepared at a 2 : 8 molar ratio in PBS exhibited a greater entrapment efficiency, lower GAS release rate and smaller friction coefficient as compared to those prepared in H2O. The superiority of the drug release and lubrication ability achieved with the GAS-loaded DSPC liposomes in PBS were elucidated on the basis of salt-induced enhancement in liposomal stability and hydration lubrication by the hydrated salt ions. Such GAS release accelerated the viability and proliferation of primary mouse chondrocytes while also providing the anti-inflammatory and chondroprotective potential for tumor necrosis factor (TNF-α) induced chondrocyte degeneration through the down-regulation of pro-inflammatory cytokines, pain related gene and catabolic proteases, as well as the up-regulation of anabolic components. We envision that the GAS-loaded DSPC liposomes could represent a promising new strategy for clinical treatment of OA in the future.

Methods for the physical characterization and quantification of extracellular vesicles in biological samples

BACKGROUND

Our body fluids contain a multitude of cell-derived vesicles, secreted by most cell types, commonly referred to as extracellular vesicles. They have attracted considerable attention for their function as intercellular communication vehicles in a broad range of physiological processes and pathological conditions. Extracellular vesicles and especially the smallest type, exosomes, have also generated a lot of excitement in view of their potential as disease biomarkers or as carriers for drug delivery. In this context, state-of-the-art techniques capable of comprehensively characterizing vesicles in biological fluids are urgently needed.

SCOPE OF REVIEW

This review presents the arsenal of techniques available for quantification and characterization of physical properties of extracellular vesicles, summarizes their working principles, discusses their advantages and limitations and further illustrates their implementation in extracellular vesicle research.

MAJOR CONCLUSIONS

The small size and physicochemical heterogeneity of extracellular vesicles make their physical characterization and quantification an extremely challenging task. Currently, structure, size, buoyant density, optical properties and zeta potential have most commonly been studied. The concentration of vesicles in suspension can be expressed in terms of biomolecular or particle content depending on the method at hand. In addition, common quantification methods may either provide a direct quantitative measurement of vesicle concentration or solely allow for relative comparison between samples.

GENERAL SIGNIFICANCE

The combination of complementary methods capable of detecting, characterizing and quantifying extracellular vesicles at a single particle level promises to provide new exciting insights into their modes of action and to reveal the existence of vesicle subpopulations fulfilling key biological tasks.

Determination of exosome concentration in solution using surface plasmon resonance spectroscopy

Exosomes are cell-secreted nanometer-sized extracellular vesicles that have been reported to play an important role in intercellular communication. They are also considered potential diagnostic markers for various health disorders, and intense investigations are presently directed toward their use as carriers in drug-delivery and gene-therapy applications. This has generated a growing need for sensitive methods capable of accurately and specifically determining the concentration of exosomes in complex biological fluids. Here, we explore the use of label-free surface-based sensing with surface plasmon resonance (SPR) read-out to determine the concentration of exosomes in solution. Human mast cell secreted exosomes carrying the tetraspanin membrane protein CD63 were analyzed by measuring their diffusion-limited binding rate to an SPR sensor surface functionalized with anti-CD63 antibodies. The concentration of suspended exosomes was determined by first converting the SPR response into the surface-bound mass. The increase in mass uptake over time was then related to the exosome concentration in solution using a formalism describing diffusion-limited binding under controlled flow conditions. The proposed quantification method is based on a calibration and control measurements performed with proteins and synthetic lipid vesicles and takes into account (i) the influence of the broad size distribution of the exosomes on the surface coverage, (ii) the fact that their size is comparable to the ∼150 nm probing depth of SPR, and (iii) possible deformation of exosomes upon adsorption. Under those considerations, the accuracy of the concentration determination was estimated to be better than ±50% and significantly improve if the exosome deformation is negligible.

Sirolimus encapsulated liposomes for cancer therapy: physicochemical and mechanical characterization of sirolimus distribution within liposome bilayers

Sirolimus has recently been introduced as a therapeutic agent for breast and prostate cancer. In the current study, conventional and Stealth liposomes were used as carriers for the encapsulation of sirolimus. The physicochemical characteristics of the sirolimus liposome nanoparticles were investigated including the particle size, zeta potential, stability and membrane integrity. In addition atomic force microscopy was used to study the morphology, surface roughness and mechanical properties such as elastic modulus deformation and deformation. Sirolimus encapsulation in Stealth liposomes showed a high degree of deformation and lower packing density especially for dipalmitoyl-phosphatidylcholine (DPPC) Stealth liposomes compared to unloaded. Similar results were obtained by differential scanning calorimetry (DSC) studies; sirolimus loaded liposomes were found to result in a distorted state of the bilayer. X-ray photon electron (XPS) analysis revealed a uniform distribution of sirolimus in multilamellar DPPC Stealth liposomes compared to a nonuniform, greater outer layer lamellar distribution in distearoylphosphatidylcholine (DSPC) Stealth liposomes.

Surface immobilization of bio-functionalized cubosomes: sensing of proteins by quartz crystal microbalance

A strategy for tethering lipid liquid crystalline submicrometer particles (cubosomes) to a gold surface for the detection of proteins is reported. Time-resolved quartz crystal microbalance (QCM-D) was used to monitor the cubosome-protein interaction in real time. To achieve specific binding, cubosomes were prepared from the nonionic surfactant phytantriol, block-copolymer, Pluronic F-127, and a secondary biotinylated lipid, 1,2-distearoyl-sn-glycero-3-phosphoethanolamine-N-[biotinyl(polyethyleneglycol)-2000], which enabled attachment of the particles to a neutravidin (NAv)-alkanethiol monolayer at the gold surface of the QCM sensor chip. A second set of cubosomes was further functionalized with addition of the glycolipid (G(M1)) to facilitate a specific binding uptake of the protein, cholera toxin B subunit (CT(B)), from solution. QCM-D confirmed the specificity of the cubosome-NAv binding. The analysis of titration experiments, also performed with QCM, suggests that an optimal concentration of cubosomes is required for the efficient packing of the particles at the surface: high cubosome concentrations lead to chaotic cubosome binding onto the surface, sterically inhibiting surface attachment, or require significant reorganization to permit uniform cubosome coverage. The methodology enabled the straightforward preparation of a complex nanostructured edifice, which was then used to specifically capture analyte proteins (cholera toxin B subunit or free NAv) from solution, supporting the potential for development of this approach as a biosensing platform.

Liposome characterization by quartz crystal microbalance measurements and atomic force microscopy

This chapter reviews liposome characterization by quartz crystal microbalance (QCM) measurements and atomic force microscopy (AFM). In many studies, AFM imaging is simply used to image liposomes with resolution often that does not allow morphological analysis. Although liposome size can be obtained by processing AFM images, it is found that liposomes flatten upon surface adsorption or immobilization. Liposome stability and stiffness have been characterized by using AFM imaging or AFM force measurements, although the latter method, using a microsphere attached on the AFM cantilever, seems more appropriate to limit liposome damage and to obtain more quantitative analysis, such as the Young's modulus. Investigation of liposome layers by QCM revealed that liposomes can be detected from a combined analysis of frequency and bandwidth shifts. However, QCM by itself provides only limited information on liposomes. QCM can be used to assess the presence of a layer and also to discriminate between rigid and viscoelastic ones. Liposome properties have been derived from QCM curves, but often this requires making hypotheses that are difficult to assess. AFM and QCM analyses need to be combined with other techniques to provide complementary information.

Atomic force microscopy: a tool to study the structure, dynamics and stability of liposomal drug delivery systems

Much work has been done during the past few decades to develop effective drug delivery systems (DDS), many of which are based on nanotechnology science. Liposomes are the most attractive lipid vesicles for drug delivery. The multifunctional properties of liposomes have a key role in modifying the bioavailability profile of a therapeutic agent. Different analytical techniques can be used to describe liposomes, not least applied scanning probe microscopy (SPM) techniques. Atomic force microscopy (AFM) seems to be one of the most effectively applied SPM techniques. This review article outlines the applications of AFM in evaluating the physical characteristics and stability of liposomal DDSs. Other well-known microscopy techniques used in evaluating liposome physical characteristics are also mentioned, and the contribution of AFM to evaluating liposomal stability is discussed. Among the advantages of AFM in examining the physicochemical properties of liposomal DDSs is its ability to provide morphological and metrology information on liposome properties. AFM thus appears to be a promising tool in technological characterization of liposomal DDSs.

Layer-by-layer technique as a new approach to produce nanostructured films containing phospholipids as transducers in sensing applications

Phospholipids are widely used as mimetic systems to exploit interactions involving biological membranes and pharmacological drugs. In this work, the layer-by-layer (LbL) technique was used as a new approach to produce multilayered thin films containing biological phospholipids applied as transducers onto Pt interdigitated electrodes forming sensing units of an electronic tongue system. Low concentrations (nM level) of a phenothiazine compound were detected through impedance spectroscopy. Both negative 1,2-dipalmitoyl-sn-3-glycero-[phosphor-rac-(1-glycerol)] (DPPG) and zwitterionic l-alpha-1,2-dipalmitoyl-sn-3-glycero-phosphatidylcholine (DPPC) phospholipids were used to produce the LbL films, whose molecular architecture was monitored combining spectroscopy and microscopy at micro and nanoscales. The sensor array was complemented by Langmuir-Blodgett (LB) monolayers of DPPG and DPPC deposited onto Pt interdigitated electrodes as well. It was found that the distinct molecular architecture presented by both LbL and LB films plays a key role on the sensitivity of the sensor array with the importance of the LbL films being demonstrated by principal component analysis (PCA).