Controlled Copolymerization of 1-Octene and (Meth)acrylates via Organotellurium-Mediated Living Radical Polymerization (TERP)

Polymer-functionalization of carbon nanotube by in situ conventional and controlled radical polymerizations

Functionalization of carbon nanotube (CNT) with polymers has drawn much attention due to its wide range of applications. Polymer-functionalized CNT could exhibit variety of properties, such as responsivity to environmental stimuli, ability of complexation with metal ions, increased dispersibility in different solvents, higher compatibility with polymer matrix, etc. Chemical and physical methods have been developed for the preparation of polymer-functionalized CNT. Polymer chains are chemically bonded to the CNT edge or surface in the chemical methods, which results in highly stable CNT/polymer composites. "Grafting to", "grafting from", and "grafting through" methods are the most common chemical methods for polymer-functionalization of CNT. In "grafting to" method, pre-fabricated polymer chains are coupled with the either functionalized or non-functionalized CNT. In "grafting from" and "grafting through" methods, CNT is functionalized by polymers simultaneously synthesized by in situ polymerization methods. Conventional free radical polymerization (FRP) and also controlled radical polymerization (CRP) are the most promising methods for in situ tethering of polymer brushes onto the surface of CNT due to their control over the grafting density, thickness, and functionality of the polymer brushes. The main focus of this review is on the synthesis of polymer-functionalized CNT via both the "grafting from" and "grafting through" methods on the basis of FRP and CRP routs, which is commonly known as in situ polymerizations. Finally, the most important challenges and applications of the in situ polymer grafting methods are discussed, which could be interesting for the future works.

Organo-Cobalt Complexes in Reversible-Deactivation Radical Polymerization

Cobalt complexes have played an essential role in different chemical reactions. One of them that has attracted substantial attention in polymer science is cobalt mediated radical polymerization (CMRP), which is famous for its remarkable efficiency in controlling the radical polymerization of vinyl acetate (VAc) and other less active monomers (LAMs). Two pathways, reversible termination (RT) and degenerative transfer (DT), were recognized to control the polymerization in CMRP and could be further used to rationalize the mechanism of other RDRP methods. These control mechanisms were then found to be correlated to the redox potential of cobalt complexes and thus could be judged more quantitatively. The control of polymer composition and tacticity could also be achieved by using CMRP. The hybridization of CMRP and atom transfer radical polymerization (ATRP) could directly synthesize the vinyl acetate/methyl methacrylate and vinyl acetate/styrene block copolymers in one pot. The copolymer of acrylates and 1-octene could be obtained by visible-light-induced CMRP. With the addition of bulky Lewis acid, CMRP of N,N-dimethylacrylamide (DMA) showed high isotacticities with the contents of meso dyads (m) and meso triads (mm) up to 94 % and 87 %, respectively, and generated the crystalline PDMA with T_m as high as 276 °C. This personal account reviewed the development of CMRP with the mechanistic understanding, the control of composition and stereoselectivity of the polymeric products, and its perspective.

Reversible-deactivation radical polymerization of vinyl acetate mediated by tralen, an organomediator

An organic compound, tralen, has been developed as a mediator to control the radical polymerization of vinyl acetate, methyl acrylate, and N-vinyl pyrrolidone via the reversible termination mechanism.

Aluminum Tralen Complex Meditated Reversible-Deactivation Radical Polymerization of Vinyl Acetate

The Al^III(tralen)Cl complex (tralenH₂ = N,N'-di(cyclohepta-2,4,6-trien-1-one-2-yl)-1,2-diaminobenzene) has been synthesized and applied to mediate the reversible-deactivation radical polymerization (RDRP) of vinyl monomers. The polymerization of unconjugated monomers such as vinyl acetate (VAc) and N-vinylpyrrolidone (NVP) with Al^III(tralen)Cl showed the living characters of linearly increased molecular weight with conversion and formation of block copolymer. However, the control manners in the polymerization of conjugated monomers like acrylates and styrene were limited. The electron paramagnetic resonance (EPR) spectrum indicated that Al^III(tralen)BArF (BArF = tetrakis(3,5-trifluormethylphenyl)borate) and propagating radicals formed a paramagnetic dormant species, possibly PVAc-Al^III(tralen)BArF, via the single-electron transfer to the tralen ligand.

Tacticity, molecular weight, and temporal control by lanthanide triflate-catalyzed stereoselective radical polymerization of acrylamides with an organotellurium chain transfer agent

Ternary control over molecular weight, tacticity, and time was achieved in the polymerization of acrylamides by photo-induced organotellurium-mediated radical polymerization (TERP) in the presence of Y(OTf)₃ or Yb(OTf)₃ as an acid catalyst.

Metal–organic insertion light initiated radical (MILRad) polymerization: photo-initiated radical polymerization of vinyl polar monomers with various palladium diimine catalysts

The photoinitiated radical polymerization pathway of MILRad polymerization towards its ability to polymerize a variety of vinyl polar functional monomers is investigated.

Controlled Radical Polymerization of Ethylene Using Organotellurium Compounds

The first successfully controlled radical polymerization (CRP) of ethylene is reported using several organotellurium chain-transfer agents (CTAs) under mild conditions (70 °C, 200 bar of ethylene) within the concept of organotellurium-mediated radical polymerization (TERP). In contrast to preceding works on CRPs of ethylene applying reversible addition-fragmentation chain-transfer (RAFT), the TERP system provided a high livingness and chain-end functionalization of polyethylene chains. Molar-mass distributions with dispersities between 1.3 and 2.1 were obtained up to average molar masses of 5000 g mol^-1 . As in the RAFT system, the high reactivity of the growing polyethylenyl radical led to an inherent side reaction. For the presented TERP systems, however, this side reaction did not result in dead chains, while it could even be effectively suppressed by a good choice of the CTA.

Visible-light-induced living radical polymerization using in situ bromine-iodine transformation as an internal boost

A new visible-light-induced methodology, termed as “bromine-iodine transformation activated living radical polymerization”, was successfully established to build a “bridge” between ATRP and iodine-mediated LRP techniques.

A RAFT/MADIX method finely regulating the copolymerization of ethylene and polar vinyl monomers under mild conditions

A RAFT/MADIX method can not only copolymerize ethylene with a diverse range of functionally polar monomers, but can also easily tune the polar composition and the polar monomer distribution along the produced copolymer chains.

Synthesis of Multivalent Organotellurium Chain-Transfer Agents by Post-modification and Their Applications in Living Radical Polymerization

Functionalized or multivalent organotellurium chain-transfer agents (CTAs) for living radical polymerization were synthesized by post-modification, which involved the condensation between a carboxylic-acid-functionalized CTA and various amines in excellent yields without affecting the reactive tellurium moiety. The CTAs exhibited high synthetic versatility for radical polymerization and gave structurally well-controlled polymers, such as multiarmed polymers, from various monomers. Because all new CTAs are easily available on a large scale by simple purification, the current method significantly facilitates macromolecular engineering based on organotellurium-mediated radical polymerization (TERP).

Visible-light induced controlled radical polymerization of methacrylates with Cu(dap)2Cl as a photoredox catalyst

Under visible light irradiation, block copolymers of PPEGMA-b-PMMA with high molecular weights and narrow molecular weight distributions are obtained starting from a PPEGMA macroinitiator in the presence of the Cu(dap)₂Cl/Me₆TREN catalytic system.

Catalyst-free iodine-mediated living radical polymerization under irradiation over a wide visible-light spectral scope

Catalyst-free iodine-mediated photo-induced solution LRP of methyl methacrylates under LED light was successfully established over a wide range of irradiation wavelengths (390–630 nm).

Alternating copolymerization by nitroxide-mediated polymerization and subsequent orthogonal functionalization

A novel method for the preparation of functionalized alternating copolymers is presented. Nitroxide-mediated polymerization of hexafluoroisopropyl acrylate with 7-octenyl vinyl ether provides the corresponding alternating polymer, which can be chemically modified using two orthogonal polymer-analogous reactions. A thiol-ene click reaction followed by amidation provides dual-functionalized alternating copolymers. The potential of this method is illustrated by the preparation of a small library (15 examples) of functionalized alternating copolymers.

Improved photo-induced cobalt-mediated radical polymerization in continuous flow photoreactors

The implementation of cobalt-mediated radical polymerization (CMRP) for continuous microflow reactor synthesis is described.

Expanding the Scope of Controlled Radical Polymerization via Cobalt-Tellurium Radical Exchange Reaction

Cobalt-mediated radical polymerization (CMRP) and tellurium-mediated radical polymerization (TERP) were combined for the first time, offering new perspectives in the precision design of macromolecular structures. In particular, the present work highlights the benefits of this strategy for the synthesis of novel poly(vinyl acetate)-based block copolymers. A range of well-defined poly(vinyl acetate)s (PVAc) were first produced via CMRP using the bis(acetylacetonato)cobalt(II) complex (Co(acac)₂) as a regulating agent. Substitution of a methyltellanyl moiety for Co(acac)₂ at the ω-chain end of the precursor was then achieved upon treatment with dimethylditelluride. In contrast to the PVAc prepared by TERP, the ones produced by sequential CMRP and Co/Te exchange reaction almost exclusively consist of regular head-to-tail-TeMe chain-end species that can be activated by TERP. Ultimately, a series of monomers problematic in Co(acac)₂-mediated radical polymerization including N-isopropylacrylamide (NIPAM), 2-(dimethylamino)ethyl acrylate (ADAME), n-butyl acrylate (BA), isoprene (IP), and vinylimidazole (NVIm) were polymerized by TERP from the PVAc-TeMe macroinitiators leading to novel diblock copolymers that cannot be made by each technique used separately.

Organotellurium-mediated living radical polymerization under photoirradiation by a low-intensity light-emitting diode

A low-intensity (6 W) light-emitting diode (LED) effectively activated an organotellurium chain transfer agent and the dormant species, promoting well-controlled radical polymerization. The use of the LED provided many advantages over the previously reported high-intensity Hg lamp, including high energy efficiency during the polymerization, and easy availability of the low-cost light source. Structurally well-defined poly(methyl methacrylate), poly(methyl acrylate), and polystyrene, with narrow molecular weight distributions, were synthesized under LED irradiation with or without a neutral density filter.