Liquid Crystalline Thermosets Based on Branched Bismethacrylates

Properties of eight methacrylated beta-cyclodextrin composite formulations

OBJECTIVES

Methacrylated beta-cyclodextrins (MCDs) are novel candidate dental monomers if all or some of the hydroxyl groups of beta-cyclodextrin are substituted with methacrylate groups. The main objective of this study was to evaluate mechanical properties of a number of composite formulations having MCDs as novel dental comonomers. The properties determined were flexural strength (FS), volumetric shrinkage (VS), and degree of conversion (DC).

METHODS

A mass fraction of 50% of MCD monomers was mixed with a mass fraction of 50% each of a series of dimethacrylate or monomethacrylate diluent comonomers to produce consistent formulations of a workable viscosity. For comparison a resin mixture of a mass fraction of 50% Bis-GMA and a mass fraction of 50% triethyleneglycol dimethacrylate (a typical dental resin mixture) was also studied. The mixtures were activated with camphorquinone and ethyl 4-dimethylamino benzoate. One part by mass of each activated resin formulation was mixed with three parts by mass of glass filler. Samples for the FS tests were prepared in (2 x 2 x 25) mm3 molds by light-curing the composites for 2 min on each side. The cured samples were immersed in 37 degrees C water for 24 h, and FS was measured with an Instron machine at a crosshead speed of 0.5 mm/min. VS was measured by a computer-controlled mercury dilatometer. DC was measured by near-infrared spectroscopy.

RESULTS

The properties of the MCD-based composites depended on the kind of diluent used. With these MCD monomers, diluents of triethyleneglycol dimethacrylate, 1,10-decamethylenediol dimethacrylate, or benzyl methacrylate yielded the best composite properties.

SIGNIFICANCE

Although not yet fully optimized, MCD-based composite formulations containing triethyleneglycol dimethacrylate, 1,10-decamethylenediol dimethacrylate, or benzyl methacrylate yielded flexural strength and volumetric shrinkage values were comparable to those of the Bis-GMA/triethyleneglycol dimethacrylate controls. These findings lend support for further development and evaluations of polymerizable cyclodextrin derivatives for use in dental materials.

Magnetic Field Orientation of Liquid Crystalline Epoxy Thermosets

The effect of magnetic fields on the orientation and properties of 4,4'-bis(2,3-epoxypropoxy)-alpha-methylstilbene cured with sulfanilamide has been studied. This epoxy system is initially isotropic and forms a smectic A phase upon curing. A magnetic field was applied during the cure reaction, resulting in alignment of the molecules along the direction of the applied field. Measurement of the orientation parameter of the fully cured material by wide-angle X-ray scattering (WAXS) showed that orientation improved with an increase in field strength. The orientation parameters of the smectic layer normals calculated from the inner reflection of the WAXS pattern attained a maximum level of approximately 0.8 at a field strength of approximately 12 T. The orientation parameters calculated from the outer reflection of the WAXS pattern were considerably lower, possibly due to the presence of amorphous regions associated with domain boundaries or the loss of molecular alignment within the smectic layers due to topological restrictions of the cross-linking sites. Orientation resulted in an anisotropic linear thermal expansion coefficient after curing, although the overall volumetric expansion was constant. The elastic tensile modulus increased with the square of the orientation parameter, attaining a maximum value of 8.1 GPa, compared to 3.1 GPa for the unoriented material. The change in modulus with orientation could be fit with a simple model for the modulus of anisotropic materials.