Substantial Seasonal Contribution of Observed Biogenic Sulfate Particles to Cloud Condensation Nuclei

Biogenic sources contribute to cloud condensation nuclei (CCN) in the clean marine atmosphere, but few measurements exist to constrain climate model simulations of their importance. The chemical composition of individual atmospheric aerosol particles showed two types of sulfate-containing particles in clean marine air masses in addition to mass-based Estimated Salt particles. Both types of sulfate particles lack combustion tracers and correlate, for some conditions, to atmospheric or seawater dimethyl sulfide (DMS) concentrations, which means their source was largely biogenic. The first type is identified as New Sulfate because their large sulfate mass fraction (63% sulfate) and association with entrainment conditions means they could have formed by nucleation in the free troposphere. The second type is Added Sulfate particles (38% sulfate), because they are preexisting particles onto which additional sulfate condensed. New Sulfate particles accounted for 31% (7 cm-3) and 33% (36 cm-3) CCN at 0.1% supersaturation in late-autumn and late-spring, respectively, whereas sea spray provided 55% (13 cm-3) in late-autumn but only 4% (4 cm-3) in late-spring. Our results show a clear seasonal difference in the marine CCN budget, which illustrates how important phytoplankton-produced DMS emissions are for CCN in the North Atlantic.

A new approach to studying aqueous reactions using diffuse reflectance infrared Fourier transform spectrometry: application to the uptake and oxidation of SO2 on OH-processed model sea salt aerosol

Diffuse reflectance infrared Fourier transform spectrometry (DRIFTS) is a powerful technique for analyzing solid powders and for following their reactions in real time. We demonstrate that it can also be applied to studying the uptake and reactions of gases in liquid films. Within the DRIFTS cell, a 10%(w/w) mixture of MgCl(2) x 6H(2)O in NaCl was equilibrated with air at 50% RH, which is above the deliquescence point of the magnesium salt but below that of NaCl. This mixture of NaCl coated with an aqueous magnesium chloride solution was then reacted with gas phase OH to generate hydroxide ions via a previously identified interface reaction. This treatment, hereafter referred to as OH-processing, was sufficient to convert some of the magnesium chloride to Mg(OH)(2) and Mg(2)(OH)(3)Cl x 4H(2)O, making the aqueous film basic and providing a reservoir of alkalinity. Subsequent addition of SO(2) to the basic processed mixture resulted in its uptake and conversion to sulfite which was measured by FTIR. The sulfite was simultaneously oxidized to sulfate by HOCl/OCl(-) that was formed in the initial OH-processing of the salt. Further uptake and oxidation of SO(2) in the aqueous film took place when the salt was subsequently exposed to O(3). These studies demonstrate that DRIFTS can be used to study the chemistry in liquid films in real time, and are consistent with the hypothesis that the reaction of gaseous OH with chloride ions generates alkalinity that enhances the uptake and oxidation of SO(2) under these laboratory conditions.