Deep slab seismicity limited by rate of deformation in the transition zone

Deep earthquakes within subducting tectonic plates (slabs) are enigmatic because they appear similar to shallow earthquakes but must occur by a different mechanism. Previous attempts to explain the depth distribution of deep earthquakes in terms of the temperature at which possible triggering mechanisms are viable, fail to explain the spatial variability in seismicity. In addition to thermal constraints, proposed failure mechanisms for deep earthquakes all require that sufficient strain accumulates in the slab at a relatively high stress. Here, I show that simulations of subduction with nonlinear rheology and compositionally dependent phase transitions exhibit strongly variable strain rates in space and time, which is similar to observed seismicity. Therefore, in addition to temperature, variations in strain rate may explain why there are large gaps in deep seismicity (low strain rate), and variable peaks in seismicity (bending regions), and, possibly, why there is an abrupt cessation of seismicity below 660 km.

Crustal evolution and mantle dynamics through Earth history

Resolving the modes of mantle convection through Earth history, i.e. when plate tectonics started and what kind of mantle dynamics reigned before, is essential to the understanding of the evolution of the whole Earth system, because plate tectonics influences almost all aspects of modern geological processes. This is a challenging problem because plate tectonics continuously rejuvenates Earth's surface on a time scale of about 100 Myr, destroying evidence for its past operation. It thus becomes essential to exploit indirect evidence preserved in the buoyant continental crust, part of which has survived over billions of years. This contribution starts with an in-depth review of existing models for continental growth. Growth models proposed so far can be categorized into three types: crust-based, mantle-based and other less direct inferences, and the first two types are particularly important as their difference reflects the extent of crustal recycling, which can be related to subduction. Then, a theoretical basis for a change in the mode of mantle convection in the Precambrian is reviewed, along with a critical appraisal of some popular notions for early Earth dynamics. By combining available geological and geochemical observations with geodynamical considerations, a tentative hypothesis is presented for the evolution of mantle dynamics and its relation to surface environment; the early onset of plate tectonics and gradual mantle hydration are responsible not only for the formation of continental crust but also for its preservation as well as its emergence above sea level. Our current understanding of various material properties and elementary processes is still too premature to build a testable, quantitative model for this hypothesis, but such modelling efforts could potentially transform the nature of the data-starved early Earth research by quantifying the extent of preservation bias.This article is part of a discussion meeting issue 'Earth dynamics and the development of plate tectonics'.

The dependence of planetary tectonics on mantle thermal state: applications to early Earth evolution

For plate tectonics to operate on a planet, mantle convective forces must be capable of forming weak, localized shear zones in the lithosphere that act as plate boundaries. Otherwise, a planet's mantle will convect in a stagnant lid regime, where subduction and plate motions are absent. Thus, when and how plate tectonics initiated on the Earth is intrinsically tied to the ability of mantle convection to form plate boundaries; however, the physics behind this process are still uncertain. Most mantle convection models have employed a simple pseudoplastic model of the lithosphere, where the lithosphere 'fails' and develops a mobile lid when stresses in the lithosphere reach the prescribed yield stress. With pseudoplasticity high mantle temperatures and high rates of internal heating, conditions relevant for the early Earth, impede plate boundary formation by decreasing lithospheric stresses, and hence favour a stagnant lid for the early Earth. However, when a model for shear zone formation based on grain size reduction is used, early Earth thermal conditions do not favour a stagnant lid. While lithosphere stress drops with increasing mantle temperature or heat production rate, the deformational work, which drives grain size reduction, increases. Thus, the ability of convection to form weak plate boundaries is not impeded by early Earth thermal conditions. However, mantle thermal state does change the style of subduction and lithosphere mobility; high mantle temperatures lead to a more sluggish, drip-like style of subduction. This 'sluggish lid' convection may be able to explain many of the key observations of early Earth crust formation processes preserved in the geologic record. Moreover, this work highlights the importance of understanding the microphysics of plate boundary formation for assessing early Earth tectonics, as different plate boundary formation mechanisms are influenced by mantle thermal state in fundamentally different ways.This article is part of a discussion meeting issue 'Earth dynamics and the development of plate tectonics'.

High-pressure rotational deformation apparatus to 135 GPa

A large-strain, torsional deformation apparatus has been developed based on diamond anvil cells at high pressures, up to 135 GPa with a help of hard nano-polycrystalline diamond anvils. These pressure conditions correspond to the base of the Earth's mantle. An X-ray laminography technique is introduced for high-pressure in situ 3D observations of the strain markers. The technique developed in this study introduces the possibility of the in situ rheological measurements of the deep Earth materials under ultrahigh-pressure conditions.

Reaction-induced rheological weakening enables oceanic plate subduction

Earth is the only terrestrial planet in our solar system where an oceanic plate subducts beneath an overriding plate. Although the initiation of plate subduction requires extremely weak boundaries between strong plates, the way in which oceanic mantle rheologically weakens remains unknown. Here we show that shear-enhanced hydration reactions contribute to the generation and maintenance of weak mantle shear zones at mid-lithospheric depths. High-pressure friction experiments on peridotite gouge reveal that in the presence of hydrothermal water, increasing strain and reactions lead to an order-of-magnitude reduction in strength. The rate of deformation is controlled by pressure-solution-accommodated frictional sliding on weak hydrous phyllosilicate (talc), providing a mechanism for the 'cutoff' of the high peak strength at the brittle-plastic transition. Our findings suggest that infiltration of seawater into transform faults with long lengths and low slip rates is an important controlling factor on the initiation of plate tectonics on terrestrial planets.