In situ small-angle X-ray and neutron scattering measurements on a blend of deuterated and hydrogenated polyethylenes during uniaxial drawing

The Effect of Crystallinity on Compressive Properties of Al-PTFE

Al-PTFE (Al-polytetrafluoroethene) is an important kind of Reactive Material (RM), however only limited importance was placed to the effect of crystallinity of PTFE on the mechanical and reactive behavior. This paper investigated the influence of crystallinity on the compression behavior of Al-PTFE at strain rates range from 10⁻² to 3 × 10³ s⁻¹. Two kinds of samples were prepared by different sintering procedures to acquire different crystallinity. The samples’ crystallinity was characterized by the density method and X-ray diffraction method. The samples were tested using an electro-hydraulic press for quasi-static loading, and split Hopkinson pressure bars (SHPBs) for high strain rates. Low crystalline samples have consistently higher strength and toughness than the high crystalline samples. The phenomenon was explained by an “elastic-plastic network” model combined with the effect of chain entanglement density. A bilinear dependence of true stress on log ε˙ was observed, and Johnson-Cook models were fitted separately according to the different strain rate sensitivity. Finally, a close connection between fracture and initiation of Al-PTFE was confirmed in quasi-static tests, SHPB tests, and drop weight tests. It was hypothesized that the high temperature at the crack tips of PTFE is an important promoting factor of initiation.

Ultra-small-angle neutron scattering with azimuthal asymmetry

Small-angle neutron scattering (SANS) measurements from thin sections of rock samples such as shales demand as great a scattering vector range as possible because the pores cover a wide range of sizes. The limitation of the scattering vector range for pinhole SANS requires slit-smeared ultra-SANS (USANS) measurements that need to be converted to pinhole geometry. The desmearing algorithm is only successful for azimuthally symmetric data. Scattering from samples cut parallel to the plane of bedding is symmetric, exhibiting circular contours on a two-dimensional detector. Samples cut perpendicular to the bedding show elliptically dependent contours with the long axis corresponding to the normal to the bedding plane. A method is given for converting such asymmetric data collected on a double-crystal diffractometer for concatenation with the usual pinhole-geometry SANS data. The aspect ratio from the SANS data is used to modify the slit-smeared USANS data to produce quasi-symmetric contours. Rotation of the sample about the incident beam may result in symmetric data but cannot extract the same information as obtained from pinhole geometry.

Inducing uniform single-crystal like orientation in natural rubber with constrained uniaxial stretch

The effect of flow on crystallization is commonly attributed to entropic reduction, which is caused by stretch and orientation of polymer chains but overlooks the role of flow on final-state free energy. With the aid of in situ synchrotron radiation wide-angle X-ray diffraction (WAXD) and a homemade constrained uniaxial tensile testing machine, polycrystals possessing single-crystal-like orientation rather than uniaxial orientation are found during the constrained stretch of natural rubber, whereas the c-axis and a-axis align in the stretch direction (SD) and constrained direction (CD), respectively. Molecular dynamics simulation shows that aligning the a-axis of crystal nuclei in CD leads to the lowest free energy increase and favors crystal nucleation. This indicates that the nomenclature of strain-induced crystallization may not fully account for the nature of flow-induced crystallization (FIC) as strain mainly emphasizes the entropic reduction of initial melt, whereas stress rather than strain plays the dominant role in crystal deformation. The current work not only contributes to a comprehensive understanding of the mechanism of flow-induced crystallization but also demonstrates the potential application of constrained uniaxial tensile stretch for the creation of functional materials containing polycrystals that possess single-crystal-like orientation.