Miscibility and morphology of binary crystalline blends of poly(L-lactide) and poly(butylene adipate)

Evaluation of the effects of starch on polyhydroxybutyrate electrospun scaffolds for bone tissue engineering applications

Efficient design for bone tissue engineering requires an understanding of the appropriate selection of biomimetic natural or synthetic materials and scalable fabrication technologies. In this research, poly (3-hydroxybutyrate) (PHB) and starch (5-15 wt%) as biological macromolecules were used to fabricate novel biomimetic scaffolds by electrospinning method. SEM results of electrospun scaffolds revealed bead-free nanofibers and three-dimensional homogenous structures with highly interconnected pores. Results of FTIR and Raman demonstrated that there were hydrogen bonds between the two polymers. The tensile strength of scaffolds was significantly improved by adding starch up to 10 wt%, from 3.05 to 15.54 MPa. In vitro degradation and hydrophilicity of the scaffolds were improved with the presence of starch. The viability and proliferation of MG-63 cells and alkaline phosphatase (ALP) activity were remarkably increased in the PHB-starch scaffolds compared to the PHB and control samples. The mineralization and calcium deposition of MG-63 cells were confirmed by alizarin red staining. It is concluded that PHB/starch electrospun scaffold could be a good candidate for bone tissue engineering applications.

Tuning the degradation profiles of poly(L-lactide)-based materials through miscibility

The effective use of biodegradable polymers relies on the ability to control the onset of and time needed for degradation. Preferably, the material properties should be retained throughout the intended time frame, and the material should degrade in a rapid and controlled manner afterward. The degradation profiles of polyester materials were controlled through their miscibility. Systems composed of PLLA blended with poly[(R,S)-3-hydroxybutyrate] (a-PHB) and polypropylene adipate (PPA) with various molar masses were prepared through extrusion. Three different systems were used: miscible (PLLA/a-PHB5 and PLLA/a-PHB20), partially miscible (PLLA/PPA5/comp and PLLA/PPA20/comp), and immiscible (PLLA/PPA5 and PLLA/PPA20) blends. These blends and their respective homopolymers were hydrolytically degraded in water at 37 °C for up to 1 year. The blends exhibited entirely different degradation profiles but showed no diversity between the total degradation times of the materials. PLLA presented a two-stage degradation profile with a rapid decrease in molar mass during the early stages of degradation, similar to the profile of PLLA/a-PHB5. PLLA/a-PHB20 presented a single, constant linear degradation profile. PLLA/PPA5 and PLLA/PPA20 showed completely opposing degradation profiles relative to PLLA, exhibiting a slow initial phase and a rapid decrease after a prolonged degradation time. PLLA/PPA5/comp and PLLA/PPA20/comp had degradation profiles between those of the miscible and the immiscible blends. The molar masses of the materials were approximately the same after 1 year of degradation despite their different profiles. The blend composition and topographical images captured at the last degradation time point demonstrate that the blending component was not leached out during the period of study. The hydrolytic stability of degradable polyester materials can be tailored to obtain different and predetermined degradation profiles for future applications.