Morphology and transport characterization of solution-processed rubrene thin films on polymer-modified substrates

Rubbing-free liquid crystal electro-optic device based on organic single-crystal rubrene

Liquid crystals (LCs) have been a vital component of modern communication and photonic technologies. However, traditional LC alignment on polyimide (PI) requires mechanically rubbing treatment to control LC orientation, suffering from dust particles, surface damage, and electrostatic charges. In this paper, LC alignment on organic single-crystal rubrene (SCR) has been studied and used to fabricate rubbing-free LC devices. A rubrene/toluene solution is spin-coated on the indium-tin-oxide (ITO) substrate and transformed thereafter to the orthorhombic SCR after annealing. Experimental result reveals that SCR-based LC cell has a homogeneous alignment geometry, the pretilt angle of LCs is low and the orientation of LCs is determined with capillary filling action of LCs. LC alignment on SCR performs a wider thermal tolerance than that on PI by virtue of the strong anchoring nature of LCs on SCR due to van der Waals and π-π electron stacking interactions between the rubrene and LCs. SCR-based LC cell performs a lower operation voltage, faster response time, and higher voltage holding ratio than the traditional PI-based LC cell. Organic SCR enables to play a role as weakly conductive alignment layer without rubbing treatment and offers versatile function to develop novel LC devices.

Flexible and Transparent Polymer-Based Optical Humidity Sensor

Thin spin-coated polymer films of amphiphilic copolymer obtained by partial acetalization of poly (vinyl alcohol) are used as humidity-sensitive media. They are deposited on polymer substrate (PET) in order to obtain a flexible humidity sensor. Pre-metallization of substrate is implemented for increasing the optical contrast of the sensor, thus improving the sensitivity. The morphology of the sensors is studied by surface profiling, while the transparency of the sensor is controlled by transmittance measurements. The sensing behavior is evaluated through monitoring of transmittance values at different levels of relative humidity gradually changing in the range 5-95% and the influence of up to 1000 bending deformations is estimated by determining the hysteresis and sensitivity of the flexible sensor after each set of deformations. The successful development of a flexible sensor for optical monitoring of humidity in a wide humidity range is demonstrated and discussed.