Critically coupled Fabry-Perot cavity with high signal contrast for refractive index sensing

Broadband-Tunable Vanadium Dioxide (VO2)-Based Linear Optical Cavity Sensor

Sensors fabricated by using a silicon-on-insulator (SOI) platform provide promising solutions to issues such as size, power consumption, wavelength-specific nature of end reflectors and difficulty to detect ternary mixture. To address these limitations, we proposed and investigated a broadband-thermally tunable vanadium dioxide (VO2)-based linear optical cavity sensor model using a finite element method. The proposed structure consists of a silicon wire waveguide on a silicon-on-insulator (SOI) platform terminated with phase-change vanadium oxide (VO2) on each side to provide light confinement. A smooth transmission modulation range of 0.8 (VO2 in the insulator state) and 0.03 (VO2 in the conductive phase state) in the 125 to 230 THz spectral region was obtained due to the of Fabry-Pérot (FP) effect. For the 3.84 μm cavity length, the presented sensor resulted in a sensitivity of 20.2 THz/RIU or 179.56 nm/RIU, which is approximately two orders of magnitude higher than its counterparts in the literature. The sensitivity of the 2D model showed direct relation with the length of the optical cavity. Moreover, the change in the resonating mode line width Δν of approximately 6.94 THz/RIU or 59.96 nm/RIU was also observed when the sensor was subjected to the change of the imaginary part k of complex refractive index (RI). This property of the sensor equips it for the sensing of aternary mixture without using any chemical surface modification. The proposed sensor haspotential applications in the areas of chemical industries, environmental monitoring and biomedical sensing.

Active Fano resonance switch using dual-layer graphene in an embedded dielectric metasurface

We propose an active optical Fano switch (OFS) based on an embedded dielectric metasurface (EDM) including dual-layer graphene (DLG). An EDM is a dielectric grating overlapped by two cladding layers, and it excites a Fano resonance. DLG is positioned inside the upper cladding layer to maximize light-graphene interaction. Thus, with a small change of the chemical potential (µ_c) of graphene, a resonance wavelength is tuned to switch the OFS on and off. First, a red-parity asymmetric Fano resonance is realized, and a sharp asymmetric lineshape is achieved by controlling the structural parameters of the EDM and the interaction between the Fano resonance and additional weak Fabry-Perot interference for efficient switching. The distance of a peak-to-dip wavelength (Δλ_p-d) and the change of chemical potential (Δµ_c) for switching is analyzed by varying the duty cycle (DC) and grating thickness (t_g) of the EDM. Furthermore, switching contrast as a figure of merit (FoM) is analyzed. With DC of 0.5 and t_g of 70 nm, the OFS requires Δλ_p-d of 7.3 nm and Δµ_c of 0.25 eV. The FoM of 0.97 is achieved. By adjusting the two parameters, the switching condition is tuned. In the case of a blue parity, the effect of the two parameters exhibits a similar trend to that of the red parity. The FoM, however, is lower due to the reversed parity.

Direct detection of virus-like particles using color images of plasmonic nanostructures

We propose a measurement method for sensitive and label-free detections of virus-like particles (VLPs) using color images of nanoplasmonic sensing chips. The nanoplasmonic chip consists of 5×5 gold nanoslit arrays and the gold surface is modified with specific antibodies for spike protein. The resonant wavelength of the 430-nm-period gold nanoslit arrays underwater environment is about 570 nm which falls between the green and red bands of the color CCD. The captured VLPs by the specific antibodies shift the plasmonic resonance of the gold nanoslits. It results in an increased brightness of green pixels and decreased brightness of red pixels. The image contrast signals of (green - red) / (red + green) show good linearity with the surface particle density. The experimental tests show the image contrast method can detect 100-nm polystyrene particles with a surface density smaller than 2 particles/µm². We demonstrate the application for direct detection of SARS-CoV-2 VLPs using a simple scanner platform. A detection limit smaller than 1 pg/mL with a detection time less than 30 minutes can be achieved.