Large and pristine films of reduced graphene oxide

Graphene-coated microballs for a hyper-sensitive vacuum sensor

Reduced graphene oxide (RGO)-coated microballs of poly (methyl methacrylate) (PMMA) used for fabricating three-dimensional sensor (3D sensor), which are expected to exhibit high sensitivity compared with conventional two-dimensional (2D) sensors, were prepared using a reaction-based assembly process. The sheet resistance and transmittance of the RGO-coated balls decreased with increasing number of coatings, implying that the RGO was well adhered to the ball by the assembly method. Two types of vacuum pressure sensors using multiple balls and a single ball were fabricated using lift-off and air-blowing methods, respectively. At pressures <1 torr, the sensors showed an increased resistance value due to the bending of graphene sheets by the Van der Waals attractive force. Further, the pressure versus resistance values at the logarithmic scale showed a linear relation, with a pressure reading error <6%. Compared with the 2D sensor fabricated using RGO, the multiball sensor exhibited almost 4-5 times higher RRC value. The single-ball sensor showed reasonable reproducibility at various temperatures. Given the size and pressure reading range of the sensor, the sensitivity of the single-ball sensor at 100 °C was approximately 6,000 times greater than that of the sensor with the highest sensitivity reported in the literature. The increase in surface area and the geometric effect of the sensing part of the single-ball sensor appeared to be responsible for its abnormally high sensitivity.

Ultra-sensitive graphene sensor for measuring high vacuum pressure

We demonstrate here that several different graphene nanoribbon (GNR) samples can be separated from the GNR mixture synthesized by conventional methods. The sheet resistance of the purified GNR gradually decreased with decreasing pressure at 30 °C, whereas it increased at 100 °C. A hypothesis based on van der Waals attractive interactions between GNR sheets was introduced to explain this finding. This hypothesis verified by the shifted main peaks in vacuum X-ray diffraction spectra: 0.022 nm and 0.041 nm shifts were observed for reduced graphene oxide (RGO) and GNR, respectively. Theoretical calculations indicated that, for RGO, the shifted distance was similar to the calculated distance. The response of the GNR sensor to pressure changes occurred rapidly (in seconds). The normalized response time of each sample indicated that sensor using GNR reduced the tailing of the response time by shortening the diffusion path of gas molecules. The sensitivity of the GNR sensor was three times that of RGO in the given pressure range. Moreover, the sensitivity of GNR was much larger than those of the most popularly studied pressure sensors using Piezoresistivity, and the sensor could detect vacuum pressures of 8 × 10^–7 Torr.

Self-assembled and intercalated film of reduced graphene oxide for a novel vacuum pressure sensor

We report a new method for measuring vacuum pressures using Van der Waals (VDW) interactions between reduced graphene oxide (RGO) sheets. For this purpose, we utilized a reaction-based self-assembly process to fabricate various intercalated RGO (i-RGO) films, and monitored their electrical behavior with changing pressure and temperature. Pumping to remove gas from a vacuum chamber produced a decrease in the sheet resistance of i-RGO. With further pumping, distinctly different sheet resistance behaivors were observed depending on the measurement temperature. With increasing vacuum pressure, the resistance increased at 100 °C, whereas it decreased at 30 °C. Two types of VDW interactions are proposed to explain these features: a local VDW interaction between RGO sheets that resulted in V-shaped curves of sheet resistance with pressure changes and broad VDW interactions that occur between RGO sheets when the elastic force required to bend carbon clusters on an RGO sheet exceeds their vibrational energy at low temperatures. On the basis of the results, we propose that the resistance behavior of i-RGO as a function of vacuum pressure can be interpreted as the sum of the two different VDW interactions.