Wettability modified nanoporous ceramic membrane for simultaneous residual heat and condensate recovery

Early-Stage Liquid Infiltration in Nanoconfinements

Liquid infiltration is one of the commonly adapted flow mechanisms in microscale/nanoscale heat-transfer applications. The theoretical modeling of dynamic infiltration profile in the microscale/nanoscale requires a deep study, because the acting forces are entirely different from those of a large-scale system. Herein, a model equation is developed from the fundamental force balance at the microscale/nanoscale level, to capture the dynamic infiltration flow profile. Molecular kinetic theory (MKT) is used to predict the dynamic contact angle. Molecular dynamics (MD) simulations are performed to study the capillary infiltration in two different geometries. The infiltration length is computed from the simulation results. The model is also evaluated over surfaces having different surface wettability. The generated model provides a better estimation of the infiltration length, compared to the well-established models. The developed model is expected to aid in the designing of microscale/nanoscale devices where liquid infiltration plays a key role.

Recent Advances in Molten-Carbonate Membranes for Carbon Dioxide Separation: Focus on Material Selection, Geometry, and Surface Modification

Membranes for carbon dioxide permeation have been recognized as potential candidates for CO₂ separation technology, particularly in the energy sector. Supported molten-salt membranes provide ionic routes to facilitate carbon dioxide transport across the membrane, permit the use of membrane at higher temperature, and offer selectivity based on ionic affinity of targeted compound. In this review, molten-carbonate ceramic membranes have been evaluated for CO₂ separation. Various research studies regarding mechanisms of permeation, properties of molten salt, significance of material selection, geometry of support materials, and surface modifications have been assessed with reference to membrane stabilities and operational flux rates. In addition, the outcomes of permeation experiments, stability tests, selection of the compatible materials, and the role of interfacial reactions for membrane degradation have also been discussed. At the end, major challenges and possible solutions are highlighted along with future recommendations for fabricating efficient carbon dioxide separation membranes.

Experimental Study on a Ceramic Membrane Condenser with Air Medium for Water and Waste Heat Recovery from Flue Gas

Ceramic membrane condensers that are used for water and waste heat recovery from flue gas have the dual effects of saving water resources and improving energy efficiency. However, most ceramic membrane condensers use water as the cooling medium, which can obtain a higher water recovery flux, but the waste heat temperature is lower, which is difficult to use. This paper proposes to use the secondary boiler air as the cooling medium, build a ceramic membrane condenser with negative pressure air to recover water and waste heat from the flue gas, and analyze the transfer characteristics of flue gas water and waste heat in the membrane condenser. Based on the experimental results, it is technically feasible for the ceramic membrane condenser to use negative pressure air as the cooling medium. The flue gas temperature has the most obvious influence on the water and heat transfer characteristics. The waste heat recovery is dominated by latent heat of water vapor, accounting for 80% or above. The negative pressure air outlet temperature of the ceramic membrane condenser can reach 50.5 °C, and it is in a supersaturated state. The research content of this article provides a new idea for the water and waste heat recovery from flue gas.

Experimental Study on Water Recovery from Flue Gas Using Macroporous Ceramic Membrane

In this work, a ceramic membrane tube with a pore size of 1 μm was used to conduct experimental research on moisture and waste heat recovery from flue gas. The length, inner/outer diameter, and porosity were 800 mm, 8/12 mm, and 27.2%, respectively. In the experiments, the flue gas, which was artificially prepared, flowed on the shell side of membrane module. The water coolant passed through the membrane counter-currently with the gas. The effects of flue gas flow rate, flue gas temperature, water coolant flux, and water coolant temperature on the membrane recovery performance were analyzed. The results indicated that, upon increasing the flue gas flow rate and its temperature, both the amount of recycled water and the recovered heat increased. The amount of recycled water, recycled water rate, recovered heat, and heat recovery rate all decreased as the water coolant temperature increased. When the water coolant temperature exceeded 30 °C, the amount of recycled water dropped sharply. The maximum amounts of recycled water, recovered heat, and total heat transfer coefficient were 2.93 kg/(m²·h), 3.63 kW/m², and 224.3 W/(m²·K), respectively.

Dynamic Behaviors of Condensing Clusters Based on Rayleigh Scattering Experiment

Condensation is a common physical process which widely exists in natural phenomena and thermal energy systems. In a condensation process, cluster is considered as the important bridge between vapor body and condensates. However, limited by the minimum imaging dimension of traditional measurements, early experimental studies about initial stages of condensation process are not sufficient. This paper provides a powerful optical platform for the study of dynamic clusters process. Based on the Rayleigh law, optical experiments were firstly introduced to investigate the clusters spatial distribution close to and far from condensation surface. The results show that clusters are mainly generated in the vicinity of the condensation surface within the thickness of 200 μm. When they move away from the condensation surface, clusters progressively vanish and they have a life cycle of a fraction of a millisecond. Though scattering intensity is proportional to the 6th power of cluster radius r and cluster number density N _c theoretically, the scattering intensity does not increase sharply with the increase of subcooling degree from the experimental results, so we can infer that the cluster number density plays a dominate role in this process and the effect of cluster radius almost can be ignored.Zhong Lan and Di Wang contributed equally to this work.