Room-temperature subnanosecond waveguide lasers in Nd:YVO4 Q-switched by phase-change VO2: A comparison with 2D materials

Femtosecond laser direct writing of few-mode depressed-cladding waveguide lasers

We report on mirrorless laser operation of Nd:YVO₄ single- and double-cladding waveguides fabricated by femtosecond laser direct writing. Fundamental- (LP₀₁) and high-order-mode (LP₀₃, LP₀₅) guiding and lasing have been observed in waveguides with different geometries and sizes. Double-cladding waveguides exhibit good guiding and lasing performance via inheriting advantages respectively from individual single cladding. As a result, continuous-wave lasing with a threshold as low as 59 mW is obtained, depending on the optical feedback provided only by Fresnel reflections at the waveguide end faces. By using few-layer graphene as saturable absorber, passively Q-switched operation in fabricated waveguides is also achieved.

Investigation of structural mechanisms of laser-written waveguide formation through third-harmonic microscopy

The mechanisms of laser-induced modification of transparent materials are complex combinations of different processes that depend on the material itself and a range of processing parameters. As such, the mechanisms are still subject to ongoing study. We use a custom-built adaptive third-harmonic generation (THG) microscope to study those mechanisms. New femtosecond-laser-written phenomena are revealed through this method of imaging. This Letter, together with previous reports by Miyamoto Opt. Express24, 25718 (2016)OPEXFF1094-408710.1364/OE.24.025718 and Fernandez J. Phys. D48, 155101 (2015)JPAPBE0022-372710.1088/0022-3727/48/15/155101 suggest that the distribution of the generated plasma during writing is responsible for the newly revealed phenomena.

Passive Q-Switching by Cr4+:YAG Saturable Absorber of Buried Depressed-Cladding Waveguides Obtained in Nd-Doped Media by Femtosecond Laser Beam Writing

We report on laser performances obtained in Q-switch mode operation from buried depressed-cladding waveguides of circular shape (100 μm diameter) that were inscribed in Nd:YAG and Nd:YVO₄ media by direct writing with a femtosecond laser beam. The Q-switch operation was realized with a Cr⁴⁺:YAG saturable absorber, aiming to obtain laser pulses of moderate (few μJ) energy at high (tens to hundreds kHz) repetition rate. An average power of 0.52 W at 1.06 μm consisting of a train of pulses of 7.79 μJ energy at 67 kHz repetition rate, was obtained from a waveguide realized in a 4.8 mm long, 1.1-at % Nd:YAG ceramics; the pulse peak power reached 1.95 kW. A similar waveguide that was inscribed in a 3.4 mm long, 1.0-at % Nd:YVO₄ crystal yielded laser pulses with 9.4 μJ energy at 83 kHz repetition rate (at 0.77 W average power) and 1.36 kW peak power. The laser performances obtained in continuous-wave operation were discussed for each waveguide used in the experiments. Thus, a continuous-wave output power of 1.45 W was obtained from the circular buried depressed-cladding waveguide inscribed in the 1.1-at %, 4.8 mm long Nd:YAG; the overall optical-to-optical efficiency, with respect to the absorbed pump power, was 0.21. The waveguide inscribed in the 1.0-at %, 3.4 mm long Nd:YVO₄ crystal yielded 1.85 W power at 0.26 overall optical efficiency. This work shows the possibility to build compact laser systems with average-to-high peak power pulses based on waveguides realized by a femtosecond (fs) laser beam direct writing technique and that are pumped by a fiber-coupled diode laser.