Spectrophotometric determination of aspartame in soft drinks with ninhydrin as reagent

Flow-through Spectrophotometric Sensor for the Determination of Aspartame in Low-Calorie and Dietary Products

A very simple flow-through sensor is presented for the determination of the intense sweetener aspartame in low-calorie and dietary products. The sensor is implemented in a monochannel flow-injection system with UV spectrophotometric detection using a Sephadex CM-C25 cationic exchanger packed 20 mm high in a flow cell. This method is based on the transient retention of a cationic species of the sweetener on the solid phase when a pH 5.0 acetic acid sodium acetate buffer (0.01 M) is used as a carrier (2.6 mL(-1) min). The carrier itself elutes the analyte from the solid support, regenerating a sensing zone. Aspartame was determined by measuring its intrinsic absorbance at 219 nm at its residence time without any derivatization. Calibration graphs were linear over the range of 5.0 - 600.0 microg mL(-1) with an RSD of 0.55% (peak height). This sweetener was determined in several samples by measuring the height or peak area, obtaining recoveries ranging between 95 - 101% and 97.5 - 101%, respectively. The procedure was validated for its use in the determination of aspartame in low-calorie and dietary products, giving reproducible and accurate results.

Determination of aspartame by ion chromatography with electrochemical integrated amperometric detection

In this paper, the separation and determination of the sweetener aspartame by ion chromatography coupled with electrochemical amperometric detection is reported. Sodium saccharin, acesulfame-K and aspartame were separated using 27.5 mmol/l NaOH isocratic elution on a Dionex IonPac AS4A-SC separation column. Aspartame can be determined by integrated amperometric detection without interference from the other two sweeteners. The method can be applied to the determination of aspartame in powered tabletop, fruit juice and carbonated beverage samples, and the results obtained by integrated amperometry were in agreement with those obtained using a UV detection method. A method for determining analytes with an NH2 group by ion chromatography with integrated amperometry was developed.

Flow injection spectrophotometric determination of aspartame in dietary products

A flow injection spectrophotometric method has been developed for the determination of aspartame in dietary products using ninhydrin as a colorimetric reagent. The reaction was conducted in a 1 + 1 v/v methanol-isopropanol medium also containing potassium hydroxide. The absorbance measurements were made at 603 nm. The results obtained for the determination of aspartame in table sweetener, pudding, gelatin, and refreshment (i.e., a powder dissolved in water for drinking) are in good agreement with the results obtained using a conventional manual procedure (correlation coefficient, r = 0.9984). Thirty-six results were obtained per hour, and the relative standard deviation was less than 3.5% (n = 6) for all samples. The detection limit (three times the signal blank/slope) was 3.8 x 10(-5) mol l-1 of aspartame.