Plasma-Excited Nebulizer Gas-Assisted Electrospray Ionization: Enhancing the Sensitivity of Pesticide in Mass Spectrometry

Liquid chromatography-mass spectrometry (LC-MS) is widely used in the detection of pesticide residues. However, the detection sensitivity of low-polarity pesticides by commonly used electrospray ionization may be severely suppressed, which greatly affects the limit of detection and repeatability. Herein, a plasma-excited nebulizer gas-assisted electrospray ionization (PENG-ESI) device has been developed. By introducing the discharge plasma formed by Tesla coil into the electrospray nebulizer gas channel, the sensitivity of low-polarity pesticides was significantly increased while maintaining sensitivity to polar pesticides. Under the optimized conditions, the limit of detection for S-bioallethrin was achieved at the level of 100 pg/g with good linearity (R2 > 0.99) and precision (RSD ≤ 4.61%). The matrix effect of a series of spiked matrix samples is less than 13.1%. Finally, different pyrethroid pesticide residues were successfully analyzed without separation, highlighting that the technology has potential application prospects in food quality control, environmental monitoring, and other fields.

Rapid quantification of acetaminophen in plasma using solid-phase microextraction coupled with thermal desorption electrospray ionization mass spectrometry

RATIONALE

Solid-phase microextraction coupled with thermal desorption electrospray ionization tandem mass spectrometry (SPME-TD-ESI-MS/MS) is proposed as a novel method for the rapid quantification of acetaminophen in plasma samples from a pharmacokinetics (PK) study.

METHODS

Traces of acetaminophen were concentrated on commercial fused-silica fibers coated with a polar polyacrylate (PA) polymer using direct immersion SPME. No agitation, heating, addition of salt, or adjustment of the pH of the sample solution was applied during the extraction. Any acetaminophen absorbed on the SPME fibers was subsequently desorbed and detected by TD-ESI-MS/MS.

RESULTS

Parameters of the absorption, sensitivity, reproducibility, and linearity for the SPME-TD-ESI-MS/MS method were evaluated. The time required to complete a TD-ESI-MS/MS analysis was less than 30 seconds. Matrix-matching calibration was performed to calculate the concentration of acetaminophen in the sample. A linear calibration curve with a concentration range of 100-10,000 ng/mL was constructed to calculate the quantity of acetaminophen. The SPME-TD-ESI-MS quantification results for acetaminophen in plasma were in good agreement with those obtained by the conventional LC/MS/MS method.

CONCLUSIONS

With the proposed method, a 10-min SPME time was enough to achieve the lower limit of quantitation (i.e. 100 ng/mL) and for a complete PK profiling of acetaminophen. A shorter extraction time could be achieved by applying agitation, heating, adding salt, or adjusting the pH of the sample solution to enhance analyte absorption efficiency. The time required to detect acetaminophen on the SPME fiber was less than 30 s, allowing the rapid quantification of acetaminophen in plasma with good accuracy.

Endophytic Paenibacillus amylolyticus KMCLE06 Extracted Dipicolinic Acid as Antibacterial Agent Derived via Dipicolinic Acid Synthetase Gene

Bioactive natural compounds play pivotal roles in drug discovery and the emergence of multi-drug resistance pathogens demands the development of better/new drugs. Paenibacillus amylolyticus KMCLE06 endophytic bacterium isolated from the medicinal plant Coix lachryma-jobi were analyzed for the potential bioactive secondary metabolite compounds and its gene responsible within polyketide synthases (PKS) clusters. Ethyl acetate extraction of P. amylolyticus KMCLE06 showed significant antibacterial activity which was further processed to partial purification and characterization for bioactive compound. The foremost bioactive component in extraction was found to be dipicolinic acid (DPA). The antibacterial activity showed remarkable activity compared to the commercial standard DPA against both gram-positive and gram-negative pathogens. The MIC and MBC concentrations for partially purified extracted DPA ranged from 62.5 to 125 µg/ml and MBC from 208 to 250 µg/ml, respectively. Sequence analysis of gene amplified using degenerative primer, amplified 543 bp DNA region, revealing conserved putative open reading frame for dipicolinic acid synthetase (DpsA) key gene to produce DPA in most endospore forming bacteria. A search in the structural database for DpsA revealed significant homologous match with enoyl reductase one of the PKS type 1 module protein. This emphasizes endophytic P. amylolyticus KMCLE06 bacteria has presence of spoVF operon producing DPA via dipicolinic acid synthetase and lacks the polyketide synthase type 1 module cluster gene in its genome. And the bioactive compound DPA extracted acts as a stable remarkable antibacterial agent which can be potent compound for multi-resistance pathogens.

Improved desorption/ionization and ion transmission in surface scanning by direct analysis in real time mass spectrometry

RATIONALE

Modifications to the Direct Analysis in Real Time mass spectrometry (DART-MS) interface, its source cap and transfer tube were necessary to obtain highest efficiency in desorption and ionization from the sampling surface and in ion transmission into the MS system. These issues are crucial for the trace analysis of any surface and the hyphenation of high-performance thin-layer chromatography (HPTLC) with DART-MS.

METHODS

The ion source mounting was modified to enable short source caps to be utilized in combination with a short transfer tube. The grid voltage contact section was readjusted to increase the intensity of the metastable gas stream towards the substrate. Eighteen different cap and two transfer tube geometries (including gas-stream focusing), along with the influence of their distance from the mass spectrometer glass capillary, were investigated for best signal intensity.

RESULTS

Using shortened source caps with staged inner bore, a transfer tube with gas-stream focusing and an optimized mounting geometry for DART-MS scanning along five identical deposited bands (600 ng each) of butyl 4-hydroxybenzoate, an average signal precision of 3.6% was obtained and the signal intensity was increased by a factor of 34. The width of the gas impact area did not exceed 1.5 mm and the smallest FWHM was determined to be 0.9 mm.

CONCLUSIONS

The desorption strength, ionization efficacy and ion transmission were improved significantly giving increased detectability using this further modified DART-MS interface with reduced cap length and optimum transfer tube geometry. The resolution was comparable with state-of-the-art densitometry. With this setup, reliable HPTLC surface scanning is possible, even for substance amounts in the low-nanogram range.

Atmospheric pressure thermal ionization ion source for peptide analysis

A novel atmospheric pressure thermal ionization (APTI) ion source was developed for the analysis of liquid samples. The feasibility of the ion source was demonstrated on peptides using two configurations-assisted by hot wire or hot surface. Microalloyed molybdenum, used as a thermal ion- emitter, notably facilitated the formation of multiply-charged ions, but fragmentation products were still observed. Peptide fragmentation accompanying thermal ionization can be used for peptide identification. The described method is promising for studies of biological samples with minimal pre-treatment.

Probe Heating Method for the Analysis of Solid Samples Using a Portable Mass Spectrometer

We previously reported on the development of a portable mass spectrometer for the onsite screening of illicit drugs, but our previous sampling system could only be used for liquid samples. In this study, we report on an attempt to develop a probe heating method that also permits solid samples to be analyzed using a portable mass spectrometer. An aluminum rod is used as the sampling probe. The powdered sample is affixed to the sampling probe or a droplet of sample solution is placed on the tip of the probe and dried. The probe is then placed on a heater to vaporize the sample. The vapor is then introduced into the portable mass spectrometer and analyzed. With the heater temperature set to 130°C, the developed system detected 1 ng of methamphetamine, 1 ng of amphetamine, 3 ng of 3,4-methylenedioxymethamphetamine, 1 ng of 3,4-methylenedioxyamphetamine, and 0.3 ng of cocaine. Even from mixtures consisting of clove powder and methamphetamine powder, methamphetamine ions were detected by tandem mass spectrometry. The developed probe heating method provides a simple method for the analysis of solid samples. A portable mass spectrometer incorporating this method would thus be useful for the onsite screening of illicit drugs.

Evaluating Atmospheric pressure Solids Analysis Probe (ASAP) mass spectrometry for the analysis of low molecular weight synthetic polymers

Atmospheric pressure Solids Analysis Probe (ASAP) mass spectrometry has facilitated the ionisation of oligomers from low molecular weight synthetic polymers, poly(ethylene glycol) (PEG: M(n) = 1430) and poly(styrene) (PS: M(n) = 1770), directly from solids, providing a fast and efficient method of identification. Ion source conditions were evaluated and it was found that the key instrument parameter was the ion source desolvation temperature which, when set to 600 °C was sufficient to vapourise the heavier oligomers for ionisation. PS, a non-polar polymer that is very challenging to analyse by MALDI or ESI without the aid of metal salts to promote cationisation, was ionised promptly by ASAP resulting in the production of radical cations. A small degree of in-source dissociation could be eliminated by control of the instrument ion source voltages. The fragmentation observed through in-source dissociation could be duplicated in a controlled manner through Collision-Induced Dissociation (CID) of the radical cations. PEG, which preferentially ionises through adduction with alkali metal cations in MALDI and ESI, was observed as a protonated molecular ion by ASAP. In-source dissociation could not be eliminated entirely and the fragmentation observed resulted from cleavage of the C-C and C-O backbone bonds, as opposed to only C-O bond cleavage observed from tandem mass spectrometry.

Chemical aspects of the extractive methods of ambient ionization mass spectrometry

Ambient ionization techniques allow complex chemical samples to be analyzed in their native state with minimal sample preparation. This brings the obvious advantages of simplicity, speed, and versatility to mass spectrometry: Desorption electrospray ionization (DESI), for example, is used in chemical imaging for tumor margin diagnosis. This review on the extractive methods of ambient ionization focuses on chemical aspects, mechanistic considerations, and the accelerated chemical reactions occurring in charged liquid droplets generated in the spray process. DESI uses high-velocity solvent droplets to extract analytes from surfaces. Nano-DESI employs liquid microjunctions for analyte dissolution, whereas paper-spray ionization uses DC potentials applied to wet porous material such as paper or biological tissue to field emit charged analyte-containing solvent droplets. These methods also operate in a reactive mode in which added reagents allow derivatization during ionization. The accelerated reaction rates seen in charged microdroplets are useful in small-scale rapid chemical synthesis.

A powerful couple in the future of clinical biochemistry: in situ analysis of dried blood spots by ambient mass spectrometry

Since the early 1960s, dried blood spots (DBS) on filter paper have been used in clinical applications. The first key milestone in the use of DBS was the screening of phenylketonuria and other inborn errors of metabolism using microbiological and enzymatic analytical methods. 20 years after its introduction, advanced mass spectrometers and new soft ionization techniques have permitted the coupling of liquid chromatography with MS and tandem MS (MS/MS) and since the 1990s, DBS analysis by LC-MS/MS expanded screening to many inborn errors of metabolism simultaneously. Recently, DBS-LC-MS/MS analysis has been used in other fields such as pharmacology, toxicology and forensic sciences. Today, new ambient ionization techniques, coupled to MS, directly desorb/ionize molecules from solid samples. This presents new opportunities for the in situ analysis of DBS. Most likely, ambient MS methods will be used to analyze DBS, increasing the clinical applications of MS within the next 10 years.