Carbon Dots Embedded Hybrid Microgel with Phenylboronic Acid as Monomer for Fluorescent Glucose Sensing and Glucose-Triggered Insulin Release at Physiological pH

A multifunctional and biocompatible hybrid microgel (poly(VPBA-AAm)-CD) using N, S-doped carbon dots (CDs) and ethylene glycol dimethacrylate (EGDMA) as cross-linking agents, and 4-vinylbenzene boronic acid (VPBA) and acrylamide (AAm) as monomers, was designed in this work. This microgel can be easily prepared by a simple one-pot radical dispersion polymerization of the reactants using a rationally designed hydrogen-bonded complex method. The hybrid microgels were spherical particles with a smooth surface and an average particle size of 234 ± 8 nm. The poly(VPBA-AAm)-CD microgel displayed the glucose-responsive swelling within a clinically concerned range at a physiological pH and could realize the controllable release of insulin. In addition, the release rate of insulin in the hybrid microgel (poly(VPBA-AAm)-CD) could be triggered by glucose concentrations in the solution, and the increasing glucose concentrations can accelerate the insulin release. Further in vitro cytotoxicity studies showed that the microgel had good biocompatibility and no obvious toxicity to the cells. These indicate that the prepared microgel (poly(VPBA-AAm)-CD) may supply a new pattern for the self-regulating therapy of insulin deficiency in diabetes.

One-pot HTST synthesis of responsive fluorescent ZnO@apo-enzyme composite microgels for intracellular glucometry

One-pot high-temperature short-time heating synthesis allows harnessing of dynamic profile of apo-GOx on ZnO@apo-enzyme composite microgels for intracellular glucometry.

Responsive crosslinked polymer nanogels for imaging and therapeutics delivery

Nanogels are water-soluble crosslinked polymer networks with tremendous potential in targeted imaging and controlled drug and gene delivery.

NIR upconversion fluorescence glucose sensing and glucose-responsive insulin release of carbon dot-immobilized hybrid microgels at physiological pH

This work reports the preparation of multifunctional hybrid microgels based on the one-pot free radical dispersion polymerization of hydrogen-bonding complexes in water, formed from hydroxyl/carboxyl bearing carbon dots with 4-vinylphenylboronic acid and acrylamide comonomers, which can realize the simultaneous optical detection of glucose using near infrared light and glucose-responsive insulin delivery.

Stimuli-responsive nanogel composites and their application in nanomedicine

Nanogels are nanosized crosslinked polymer networks capable of absorbing large quantities of water. Specifically, smart nanogels are interesting because of their ability to respond to biomedically relevant changes like pH, temperature, etc. In the last few decades, hybrid nanogels or composites have been developed to overcome the ever increasing demand for new materials in this field. In this context, a hybrid refers to nanogels combined with different polymers and/or with nanoparticles such as plasmonic, magnetic, and carbonaceous nanoparticles, among others. Research activities are focused nowadays on using multifunctional hybrid nanogels in nanomedicine, not only as drug carriers but also as imaging and theranostic agents. In this review, we will describe nanogels, particularly in the form of composites or hybrids applied in nanomedicine.

Bioinspired synthesis of poly(phenylboronic acid) microgels with high glucose selectivity at physiological pH

A microgel that is more sensitive towards glucose than to other saccharides is made of 4-vinylphenylboronic acid crosslinked withN,N′-bis(propene)perylene-3,4,9,10-tetracarboxyldiimide.

Immobilization of Carbon Dots in Molecularly Imprinted Microgels for Optical Sensing of Glucose at Physiological pH

Nanosized carbon dots (CDs) are emerging as superior fluorophores for biosensing and a bioimaging agent with excellent photostability, chemical inertness, and marginal cytotoxicity. This paper reports a facile one-pot strategy to immobilize the biocompatible and fluorescent CDs (∼6 nm) into the glucose-imprinted poly(N-isopropylacrylamide-acrylamide-vinylphenylboronic acid) [poly(NIPAM-AAm-VPBA)] copolymer microgels for continuous optical glucose detection. The CDs designed with surface hydroxyl/carboxyl groups can form complexes with the AAm comonomers via hydrogen bonds and, thus, can be easily immobilized into the gel network during the polymerization reaction. The resultant glucose-imprinted hybrid microgels can reversibly swell and shrink in response to the variation of surrounding glucose concentration and correspondingly quench and recover the fluorescence signals of the embedded CDs, converting biochemical signals to optical signals. The highly imprinted hybrid microgels demonstrate much higher sensitivity and selectivity for glucose detection than the nonimprinted hybrid microgels over a clinically relevant range of 0-30 mM at physiological pH and benefited from the synergistic effects of the glucose molecular contour and the geometrical constraint of the binding sites dictated by the glucose imprinting process. The highly stable immobilization of CDs in the gel networks provides the hybrid microgels with excellent optical signal reproducibility after five repeated cycles of addition and dialysis removal of glucose in the bathing medium. In addition, the hybrid microgels show no effect on the cell viability in the tested concentration range of 25-100 μg/mL. The glucose-imprinted poly(NIPAM-AAm-VPBA)-CDs hybrid microgels demonstrate a great promise for a new glucose sensor that can continuously monitor glucose level change.

Synthesis and characterization of ammonia-responsive polymer microgels

We report a polymer microgel that can undergo rapid, reversible, and highly-sensitive volume phase transitions upon varying ammonia concentrations in milieu.

Switchable glucose-responsive volume phase transition behavior of poly(phenylboronic acid) microgels

We report a poly(phenylboronic acid) microgel that can display switchable glucose-responsive volume phase transition behavior with temperature as a trigger.

Synthesis and volume phase transition of concanavalin A-based glucose-responsive nanogels

A glucose-responsive nanogel that can undergo reversible and rapid volume phase transitions is made of ConA interpenetrated in a poly(NIPAM) network.

Responsive materials for self-regulated insulin delivery

With diabetes mellitus becoming an important public health concern, insulin-delivery systems are attracting increasing interest from both scientific and technological researchers. This feature article covers the present state-of-the-art glucose-responsive insulin-delivery system (denoted as GRIDS), based on responsive polymer materials, a promising system for self-regulated insulin delivery. Three types of GRIDS are discussed, based on different fundamental mechanisms of glucose-recognition, with: a) glucose enzyme, b) glucose binding protein, and c) synthetic boronic acid as the glucose-sensitive component. At the end, a personal perspective on the major issues yet to be worked out in future research is provided.

Construction of near-infrared photonic crystal glucose-sensing materials for ratiometric sensing of glucose in tears

Noninvasive monitoring of glucose in tears is highly desirable in tight glucose control. The polymerized crystalline colloidal array (PCCA) that can be incorporated into contact lens represents one of the most promising materials for noninvasive monitoring of glucose in tears. However, low sensitivity and slow time response of the PCCA reported in previous arts has limited its clinical utility. This paper presents a new PCCA, denoted as NIR-PCCA, comprising a CCA of glucose-responsive sub-micrometered poly(styrene-co-acrylamide-co-3-acrylamidophenylboronic acid) microgels embedded within a slightly positive charged hydrogel matrix of poly(acrylamide-co-2-(dimethylamino)ethyl acrylate). This newly designed NIR-PCCA can reflect near-infrared (NIR) light, whose intensity (at 1722 nm) would decrease evidently with increasing glucose concentration over the physiologically relevant range in tears. The lowest glucose concentration reliably detectable was as low as ca. 6.1 μg/dL. The characteristic response time τ(sensing) was 22.1±0.2s when adding glucose to 7.5 mg/dL, and the higher the glucose concentration is, the faster the time response. Such a rationally designed NIR-PCCA is well suited for ratiometric NIR sensing of tear glucose under physiological conditions, thereby likely to bring this promising glucose-sensing material to the forefront of analytical devices for diabetes.