Properties of water in the interfacial region of a polyelectrolyte bilayer adsorbed onto a substrate studied by computer simulations

Ion-Specific and Solvent Effects on PDADMA–PSS Complexation and Multilayer Formation

Among various parameters that influence the formation of polyelectrolyte complexes and multilayers, special emphasis should be placed on ion-specific and solvent effects. In our study, we systematically examined the above-mentioned effects on poly(diallyldimethylammonium chloride) (PDADMACl)-sodium poly(4-styrenesulfonate) (NaPSS) complexation in solution and at the surface by means of dynamic light scattering, ellipsometry and atomic force microscopy measurements. As solvents, we used water and water/ethanol mixture. The obtained results confirm the importance of ion-specific and solvent effects on complexes prepared in solution, as well as on multilayers built up on a silica surface. The experiments in mixed solvent solution showed that at a higher ethanol mole fraction, the decrease in monomer titrant to titrand ratio, at which the increase in the size of complexes is observed, takes place. The difference between chloride and bromide ions was more pronounced at a higher mole fraction of ethanol and in the case of positive complex formation, suggesting that the larger amount of bromide ions could be condensed to the polycation chain. These findings are in accordance with the results we obtained for polyelectrolyte multilayers and could be helpful for designing polyelectrolyte multilayers with tuned properties needed for various applications, primarily in the field of biomedicine.

PDADMAC/PSS Oligoelectrolyte Multilayers: Internal Structure and Hydration Properties at Early Growth Stages from Atomistic Simulations

We analyze the internal structure and hydration properties of poly(diallyl dimethyl ammonium chloride)/poly(styrene sulfonate sodium salt) oligoelectrolyte multilayers at early stages of their layer-by-layer growth process. Our study is based on large-scale molecular dynamics simulations with atomistic resolution that we presented recently [Sánchez et al., Soft Matter2019, 15, 9437], in which we produced the first four deposition cycles of a multilayer obtained by alternate exposure of a flat silica substrate to aqueous electrolyte solutions of such polymers at 0.1M of NaCl. In contrast to any previous work, here we perform a local structural analysis that allows us to determine the dependence of the multilayer properties on the distance to the substrate. We prove that the large accumulation of water and ions next to the substrate observed in previous overall measurements actually decreases the degree of intrinsic charge compensation, but this remains as the main mechanism within the interface region. We show that the range of influence of the substrate reaches approximately 3 nm, whereas the structure of the outer region is rather independent from the position. This detailed characterization is essential for the development of accurate mesoscale models able to reach length and time scales of technological interest.

Atomistic simulation of PDADMAC/PSS oligoelectrolyte multilayers: overall comparison of tri- and tetra-layer systems

By employing large-scale molecular dynamics simulations of atomistically resolved oligoelectrolytes in aqueous solutions, we study in detail the first four layer-by-layer deposition cycles of an oligoelectrolyte multilayer made of poly(diallyl dimethyl ammonium chloride)/poly(styrene sulfonate sodium salt) (PDADMAC/PSS). The multilayers are grown on a silica substrate in 0.1 M NaCl electrolyte solutions and the swollen structures are then subsequently exposed to varying added salt concentration. We investigated the microscopic properties of the films, analyzing in detail the differences between three- and four-layer systems. Our simulations provide insights into the early stages of growth of a multilayer, which are particularly challenging for experimental observations. We found rather strong complexation of the oligoelectrolytes, with fuzzy layering of the film structure. The main charge compensation mechanism is for all cases intrinsic, whereas extrinsic compensation is relatively enhanced for the layer of the last deposition cycle. In addition, we quantified other fundamental observables of these systems, such as the film thickness, water uptake, and overcharge fractions for each deposition layer.

The importance of chemical potential in the determination of water slip in nanochannels

We investigate the slip properties of water confined in graphite-like nanochannels by non-equilibrium molecular dynamics simulations, with the aim of identifying and analyze separately the influence of different physical quantities on the slip length. In a system under confinement but connected to a reservoir of fluid, the chemical potential is the natural control parameter: we show that two nanochannels characterized by the same macroscopic contact angle--but a different microscopic surface potential--do not exhibit the same slip length unless the chemical potential of water in the two channels is matched. Some methodological issues related to the preparation of samples for the comparative analysis in confined geometries are also discussed.

Interfacial water properties in the presence of surfactants

Water, because of its fundamental role in biology, geology, and many industrial applications and its anomalous behavior compared to that of simple fluids, continues to fascinate and attract extensive scientific interest. Building on previous studies of water in contact with different surfaces, in this study, we report results obtained from molecular dynamics simulations of water near hydrophilic and hydrophobic interfaces in the presence of nonionic and ionic amphiphilic molecules, hexaethylene glycol monododecyl ether (C12E6) and sodium dodecyl sulfate (SDS). We elucidate how these surfactants affect the packing (i.e., density profiles) and orientation of interfacial water. The results highlight the interplay of both surfactant charges and the substrate charge distribution predominantly with respect to the orientation of water molecules, up to distances longer than those expected based on simulation results on flat solid surfaces. We also quantify the dynamics of interfacial water molecules by computing the residence probability for water in contact with various substrates. We compare our results to those previously obtained for interfacial water on silica and graphite and also with experimental sum-frequency vibrational spectroscopy results at the air-water interface in the presence of surfactants. Our analysis could be useful for a better understanding of interfacial water not only near solid substrates but also near self-assembled/aggregated molecules at a variety of interfaces.

Adhesion of lactoferrin and bone morphogenetic protein-2 to a rutile surface: dependence on the surface hydrophobicity

Binding of the proteins human lactoferrin (LF) and human bone morphogenetic protein-2 (BMP2) to a hydroxylated TiO₂ rutile (110) surface has been modeled using molecular dynamics (MD) simulations.