Mitigating the photocurrent persistence of single ZnO nanowires for low noise photodetection applications

In this work, we investigate the optoelectronic properties of zinc oxide (ZnO) nanowires, which are good candidates for applications based on integrated optics. Single ZnO nanowire photodetectors were fabricated with ohmic contacts. By taking current transient measurements in different atmospheres (oxygen, air, vacuum and argon), and at various temperatures, we point out the importance of surface effects on the electrical behaviour. Results confirm that oxygen chemisorption is responsible for the existence of a high photoconductive gain in these devices, and for the first time a two step process in the photocurrent rise transient is reported. A maximum gain of G = 7.8 × 10⁷ is achieved. However, under certain conditions, the persistence of the photocurrent can last up to several hours and as such may prevent the device from operating at useful rates. From a knowledge of the photocurrent response mechanisms, we establish a method to restore the photodetector to its initial state, with very low dark current, by applying an appropriate gate voltage sequence. This advances the state of the art for these detectors towards commercial applications.

Role of surface defects on visible light enabled plasmonic photocatalysis in Au–ZnO nanocatalysts

Visible light photocatalytic activity of the plasmonic gold–zinc oxide (Au–ZnO) nanorods (NRs) is investigated with respect to the surface defects of the ZnO NRs, controlled by annealing the NRs in ambient at different temperatures.

Non-classical logic inverter coupling a ZnO nanowire-based Schottky barrier transistor and adjacent Schottky diode

On a single ZnO nanowire (NW), we fabricated an inverter-type device comprising a Schottky diode (SD) and field-effect transistor (FET), aiming at 1-dimensional (1D) electronic circuits with low power consumption. The SD and adjacent FET worked respectively as the load and driver, so that voltage signals could be easily extracted as the output. In addition, NW FET with a transparent conducting oxide as top gate turned out to be very photosensitive, although ZnO NW SD was blind to visible light. Based on this, we could achieve an array of photo-inverter cells on one NW. Our non-classical inverter is regarded as quite practical for both logic and photo-sensing due to its performance as well as simple device configuration.

A ZnO nanowire-based photo-inverter with pulse-induced fast recovery

We demonstrate a fast response photo-inverter comprised of one transparent gated ZnO nanowire field-effect transistor (FET) and one opaque FET respectively as the driver and load. Under ultraviolet (UV) light the transfer curve of the transparent gate FET shifts to the negative side and so does the voltage transfer curve (VTC) of the inverter. After termination of UV exposure the recovery of photo-induced current takes a long time in general. This persistent photoconductivity (PPC) is due to hole trapping on the surface of ZnO NWs. Here, we used a positive voltage short pulse after UV exposure, for the first time resolving the PPC issue in nanowire-based photo-detectors by accumulating electrons at the ZnO/dielectric interface. We found that a pulse duration as small as 200 ns was sufficient to reach a full recovery to the dark state from the UV induced state, realizing a fast UV detector with a voltage output.