A polylactic acid-carbon nanofiber-based electro-conductive sensing material and paper-based colorimetric sensor for detection of nitrates

Plastics are ubiquitous in today's lifestyle, and their indiscriminate use has led to the accumulation of plastic waste in landfills and oceans. The waste accumulates and breaks into micro-particles that enter the food chain, causing severe threats to human health, wildlife, and the ecosystem. Environment-friendly and bio-based degradable materials offer a sustainable alternative to the vastly used synthetic materials. Here, a polylactic acid and carbon nanofiber-based membrane and a paper-based colorimetric sensor have been developed. The membrane had a surface area of 3.02 m2 g-1 and a pore size of 18.77 nm. The pores were evenly distributed with a pore volume of 0.0137 cm3 g-1. The membrane was evaluated in accordance with OECD guidelines and was found to be safe for tested aquatic and terrestrial models. The activated PLA-CNF membrane was further used as a bio-based electrode for the electrochemical detection of nitrates (NO3-) in water samples with a detection limit of 0.046 ppm and sensitivity of 1.69 × 10-4 A ppm-1 mm-2, whereas the developed paper-based colorimetric sensor had a detection limit of 156 ppm for NO3-. This study presents an environment-friendly, low-carbon footprint disposable material for sensing applications as a sustainable alternative to plastics.

Chitosan-carbon nanofiber based disposable bioelectrode for electrochemical detection of oxytocin

Bioelectrodes with low carbon footprint can provide an innovative solution to the surmounting levels of e-waste. Biodegradable polymers offer green and sustainable alternatives to synthetic materials. Here, a chitosan-carbon nanofiber (CNF) based membrane has been developed and functionalized for electrochemical sensing application. The surface characterization of the membrane revealed crystalline structure with uniform particle distribution, and surface area of 25.52 m²/g and pore volume of 0.0233 cm³/g. The membrane was functionalized to develop a bioelectrode for the detection of exogenous oxytocin in milk. Electrochemical impedance spectroscopy was employed to determine oxytocin in a linear concentration range of 10 to 10⁵ ng/mL. The developed bioelectrode showed an LOD of 24.98 ± 11.37 pg/mL and sensitivity of 2.77 × 10^-10 Ω / log ng mL^-1/mm² for oxytocin in milk samples with 90.85-113.34 percent recovery. The chitosan-CNF membrane is ecologically safe and opens new avenues for environment-friendly disposable materials for sensing applications.

Nanostructured manganese oxides as highly active catalysts for enhanced hydrolysis of bis(4-nitrophenyl)phosphate and catalytic decomposition of methanol

The nanostructured manganese oxides (MnOx) exhibited high catalytic activities for hydrolysis of phosphate diester-based substrate bis(4-nitrophenyl)phosphate and decomposition of methanol to carbon monoxide and hydrogen as a potential alternative fuel.

Synthesis and characterization of TiO2/Mg(OH)2 composites for catalytic degradation of CWA surrogates

Surface catalyzed reactions can be a convenient way to deactivate toxic chemical warfare agents (CWAs) and remove them from the contaminated environment. In this study, pure titanium oxide, magnesium hydroxide, and their composites TiO₂/Mg(OH₂) were prepared by thermal decomposition and precipitation of the titanium peroxo-complex and/or magnesium nitrate in an aqueous solution. The as-prepared composites were examined by XRD, XPS, HRTEM, and nitrogen physisorption. Their decontamination ability was tested on CWA surrogates and determined by high-performance liquid chromatography (HPLC) and gas chromatography coupled with mass spectrometry (GC-MS). Dimethyl methyl phosphonate (DMMP) was used as a G simulant for the nerve agents sarin (GB) and soman (GD) while 2-chloroethyl ethyl sulfide (2-CEES) and 2-chloroethyl phenyl sulfide (2-CEPS) were used as surrogates of sulfur mustard (HD). The activity of the as-prepared composites was correlated with acid–base properties determined by potentiometric titrations and pyridine adsorption studied by in situ DRIFTS. The mixing of Ti and Mg led to an increase of the surface area and the amount of surface –OH groups (with an increasing amount of Ti) that caused improved degradation of DMMP.

Surface catalyzed reactions can be a convenient way to deactivate toxic chemical warfare agents (CWAs) and remove them from the contaminated environment.

Comparison of Co(ii) adsorption by a crosslinked carboxymethyl chitosan hydrogel and resin: behaviour and mechanism

This article studies the possible chemical and physical adsorption mechanism for Co(ii) onto the crosslinked carboxymethyl chitosan hydrogel and resin.

New in situ generated acylhydrazidate-coordinated complexes and acylhydrazide molecules: Synthesis, structural characterization and photoluminescence property

By utilizing the hydrothermal in situ acylation of organic acids with N2H4, three acylhydrazidate-coordinated compounds [Mn(L1)2(H2O)2] (L1=2,3-quinolinedicarboxylhydrazidate; HL1=2,3-dihydropyridazino[4,5-b] quinoline-1,4-dione) 1, [Mn2(ox)(L2)2(H2O)6]·2H2O (L2=benzimidazolate-5,6-dicarboxylhydrazide; HL2=6,7-dihydro-1H-imidazo[4,5-g]phthalazine-5,8-dione; ox=oxalate) 2, and [Cd(HL3)(bpy)] (L3=4,5-di(3'-carboxylphenyl)phthalhydrazidate; H3L3=6,7-dihydro-1H-imidazo[4,5-g]phthalazine-5,8-dione; bpy=2,2'-bipyridine) 3, as well as two acylhydrazide molecules L4 (L4=oxepino[2,3,4-de:7,6,5-d'e']diphthalazine-4,10(5H,9H)-dione) 4 and L5 (L5=4,5-dibromophthalhydrazide; L5=6,7-dibromo-2,3-dihydrophthalazine-1,4-dione) 5 were obtained. X-ray single-crystal diffraction analysis reveals that (i) 1 only possesses a mononuclear structure, but it self-assembles into a 2-D supramolecular network via the NhydrazineH⋯Nhydrazine and OwH⋯Ohydroxylimino interactions; (ii) 2 exhibits a dinuclear structure. Ox acts as the linker, while L2 just serves as a terminal ligand; (iii) In 3, L3 acts as a 3-connected node to propagate the 7-coordinated Cd(2+) centers into a 1-D double-chain structure; (iv) 4 is a special acylhydrazide molecule. Two OH groups for the intermediates 3,3'-biphthalhydrazide further lose one water molecule to form 4; (v) 5 is a common monoacylhydrazide molecule. Via the NhydrazineH⋯Ohydrazine, OhydroxyliminoH⋯Oacylamino and the π⋯π interactions, it self-assembles into a 2-D supramolecular network. The photoluminescence analysis reveals that 4 emits light with the maxima at 510nm.

Improving the properties of poly(arylene ether nitrile) composites reinforced by covalently modified multi-walled carbon nanotubes

To develop high-performance carbon nanotube (CNT)-based polymer nanocomposites, both the interface control and the dispersion of CNTs within the polymer hosts need to be considered. In this study, we show an effective way to modify the surface of multi-walled CNTs (MWCNTs) by applying a cyclization reaction between nitrile-modified MWCNTs and bis-phthalonitrile. Fourier transform infrared spectroscopy, ultraviolet–visible spectroscopy, Raman spectroscopy, scanning electron microscopy, and transmission electron microscopy were used to examine the structure and morphology of as-prepared functional CNTs. Phthalocyanines (Pcs) were found to be evenly coated on the surface of MWCNTs, resulting in good dispersion and strong interfacial adhesion between MWNCTs and the poly(arylene ether nitrile) (PEN) matrix. Compared with neat PEN, the tensile strength and tensile modulus of PEN nanocomposites with 2 wt% MWCNTs–Pc increased from 85.6 MPa to 108 MPa and from 2300 MPa to 3350 MPa, respectively. Furthermore, surface-functionalized CNTs can also form the physical MWCNT network within the PEN matrix, as confirmed by rheological and thermal stability tests. Additionally, a low rheological percolation threshold of 0.69 wt% was obtained, and the dielectric constant of PEN nanocomposites was increased from 3.3 for neat PEN to 16.6 with 5 wt% MWCNTs–Pc.

The highly effective removal of Cs⁺ by low turbidity chitosan-grafted magnetic bentonite

Chitosan-grafted magnetic bentonite (CS-g-MB) was successfully synthesized via a plasma-induced method. The CS-g-MB composite shows good magnetic properties, low turbidity, and high stability in aqueous solution and exhibits significant adsorption capacity for Cs(+) ions. The adsorption of Cs(+) by CS-g-MB is dependent on both pH and ionic strength. In the presence of Mg(2+), K(+), Li(+), and Na(+) ions, the Cs(+) exchange is constrained in the order of Li(+)≈Mg(2+)<Na(+)<K(+), primarily as a result of the hydrated radii and hydration energies of these cations in aqueous solution. The stability of the CS-g-MB composite in simulated groundwater and in actual seawater was also investigated and this material was found to be a good candidate for the remediation of both types of water. These results demonstrate that enhanced coagulation achieved by plasma modification represents a viable yet advanced technology for wastewater management, and is capable of synthesizing new adsorbents that can be readily separated from solution and that avoid increasing the turbidity and color of the water being treated.

Design of Chitosan-Grafted Carbon Nanotubes: Evaluation of How the -OH Functional Group Affects Cs+ Adsorption

In order to explore the effect of –OH functional groups in Cs⁺ adsorption, we herein used the low temperature plasma-induced grafting method to graft chitosan onto carbon nanotubes (denoted as CTS-g-CNTs), as raw-CNTs have few functional groups and chitosan has a large number of –OH functional groups. The synthesized CTS-g-CNT composites were characterized using different techniques. The effect of –OH functional groups in the Cs⁺ adsorption process was evaluated by comparison of the adsorption properties of raw-CNTs with and without grafting chitosan. The variation of environmental conditions such as pH and contact time was investigated. A comparison of contaminated seawater and simulated groundwater was also evaluated. The results indicated that: (1) the adsorption of Cs⁺ ions was strongly dependent on pH and the competitive cations; (2) for CNT-based material, the –OH functional groups have a positive effect on Cs⁺ removal; (3) simulated contaminated groundwater can be used to model contaminated seawater to evaluate the adsorption property of CNTs-based material. These results showed direct observational evidence on the effect of –OH functional groups for Cs⁺ adsorption. Our findings are important in providing future directions to design and to choose effective material to remedy the removal of radioactive cesium from contaminated groundwater and seawater, crucial for public health and the human social environment.

Mussel inspired functionalization of carbon nanotubes for heavy metal ion removal

Polyethylenimine functionalized carbon nanotubes were prepared through mussel inspired chemistry and the Michael addition reaction, and utilized for the adsorption of Cu²⁺ from water.