Mechanism and stability of an Fe-based 2D MOF during the photoelectro-Fenton treatment of organic micropollutants under UVA and visible light irradiation

This work reports the novel application of an Fe-based 2D metal-organic framework (MOF), prepared with 2,2'-bipyridine-5,5'-dicarboxylate (bpydc) as organic linker, as highly active catalyst for heterogeneous photoelectro-Fenton (PEF) treatment of the lipid regulator bezafibrate in a model matrix and urban wastewater. Well-dispersed 2D structures were successfully synthesized and their morphological, physicochemical and photocatalytic properties were assessed. UV/Vis PEF using an IrO₂/air-diffusion cell with an extremely low catalyst concentration (0.05 g L^-1, tenfold lower than reported 3D MOFs) outperformed electro-oxidation with electrogenerated H₂O₂, electro-Fenton and visible-light PEF. Its excellent performance was explained by: (i) the enhanced mass transport of H₂O₂ (and organic molecules) at the 2D structure, providing active sites for heterogeneous Fenton's reaction and in-situ Fe(II) regeneration; (ii) the ability of photoinduced electrons to reduce H₂O₂ to ^•OH, and Fe(III) to Fe(II); and (iii) the enhanced charge transfer and excitation of Fe-O clusters, which increased the number of electron-hole pairs. LC-QToF-MS and GC-MS allowed the identification of 16 aromatic products of bezafibrate. The complete removal of four micropollutants mixed in urban wastewater at pH 7.4 revealed the great potential of (Fe-bpydc)-catalyzed PEF process.

A double basic Sr-amino containing MOF as a highly stable heterogeneous catalyst

A novel metal-organic framework (MOF) based on strontium alkaline-earth metal and 2-amino-1,4-benzenedicarboxylic acid (NH₂-bdc) has been developed. This material is formed by a linear succession of face-sharing strontium polyhedra bridged by an organic ligand molecule to give a three-dimensional network with rhombohedral one-directional channels. This MOF is stable in polar organic solvents and up to 250 °C. The basic catalytic activity of both strontium metal nodes and amino groups of the ligand was tested in Knoevenagel condensation reactions. The influence of the temperature and reaction solvent over the catalytic performance of the MOF catalyst was demonstrated. The strontium/amino-containing MOF material evidenced a remarkable activity as compared to other conventional alkaline oxides typically used as reference basic solid catalysts. The novel MOF material showed remarkable activity and structural stability during five consecutive catalytic runs with no evidence of activity loss under the best reaction conditions found in this study.

Structural Transformation Pathways of Alkaline Earth Family Coordination Polymers Containing 3,3',5,5'-Biphenyl Tetracarboxylic Acid

The understanding of crystal stepwise transformation is very important to enclose the "black box" in the preparation of crystal materials. In this work, different structural intermediates were isolated prior to the formation of the final alkali earth coordination polymers (CPs) during the preparation of three pairs of alkali earth CPs through solvothermal method and convenient oil-bath reactions. Single crystal X-ray diffraction analysis demonstrated the structural transformation from a 0 D to 1 D inorganic connectivity for the Ca-CPs and Sr-CPs, but a 1 D to 0 D inorganic connectivity for Ba-CPs, involving the breakage/formation of chemical bonds in the reaction solutions. Further analyses indicated that these two different structural transformation pathways are determined by the deprotonation of organic acid, competitive balance between the inorganic and organic connectivity, and the twist of the linker. FT-IR spectra, thermogravimetric and luminescence behaviors agree with their structural characteristics.

The Effect of Materials Architecture in TiO2 /MOF Composites on CO2 Photoreduction and Charge Transfer

CO₂ photoreduction to C₁ /C₁₊ energized molecules is a key reaction of solar fuel technologies. Building heterojunctions can enhance photocatalysts performance, by facilitating charge transfer between two heterojunction phases. The material parameters that control this charge transfer remain unclear. Here, it is hypothesized that governing factors for CO₂ photoreduction in gas phase are: i) a large porosity to accumulate CO₂ molecules close to catalytic sites and ii) a high number of "points of contact" between the heterojunction components to enhance charge transfer. The former requirement can be met by using porous materials; the latter requirement by controlling the morphology of the heterojunction components. Hence, composites of titanium oxide or titanate and metal-organic framework (MOF), a highly porous material, are built. TiO₂ or titanate nanofibers are synthesized and MOF particles are grown on the fibers. All composites produce CO under UV-vis light, using H₂ as reducing agent. They are more active than their component materials, e.g., ≈9 times more active than titanate. The controlled composites morphology is confirmed and transient absorption spectroscopy highlights charge transfer between the composite components. It is demonstrated that electrons transfer from TiO₂ into the MOF, and holes from the MOF into TiO₂ , as the MOF induces band bending in TiO₂ .

A Sr2+-metal-organic framework with high chemical stability: synthesis, crystal structure and photoluminescence property

Metal-organic frameworks (MOFs) are typically built by assembly of metal centres and organic linkers, and have emerged as promising crystalline materials in a variety of fields. However, the stability of MOFs is a key limitation for their practical applications. Herein, we report a novel Sr 2+: -MOF [Sr₄(Tdada)₂(H₂O)₃(DMF)₂] (denoted as NKU- 105: , NKU = Nankai University; H₄Tdada = 5,5'-((thiophene-2,5-dicar bonyl)bis(azanediyl))diisophthalic acid; DMF = N,N-dimethylformamide) featuring an open square channel of about 6 Å along the c-axis. Notably, NKU- 105: exhibits much outstanding chemical stability against common organic solvents, boiling water, acids and bases, relative to most MOF materials. Furthermore, NKU- 105: is an environment-friendly luminescent material with a bright cyan emission.This article is part of the themed issue 'Coordination polymers and metal-organic frameworks: materials by design'.

Lanthanide metal–organic frameworks based on the 4,4′-oxybisbenzoic acid ligand: synthesis, structures and physical properties

Using solvothermal synthesis, eight new 3D microporous lanthanide-ions-based MOFs constructed from 4,4′-oxybisbenzoic acid were obtained and displayed two types of architecture.