Hybrid Materials Based on Keggin Phosphotungstate and Bipyridine with Valuable Hydrophobic and Redox Properties

A thorough investigation of two novel hybrid materials, namely, (2,2'-Hbpy)₃[PW₁₂O₄₀] and (4,4'-H₂bpy)_1.5[PW₁₂O₄₀]·1.5H₂O built from Keggin phosphotungstic acid (PTA) and bipyridine, describes the impact of bipyridine isomers in their formation and physicochemical properties. The hybrids' formation was confirmed by powder X-ray diffraction, while infrared spectroscopy (IR) proved the polyoxometalate (POM) structural preservation. The stoichiometric composition and thermal stability of the hybrids were solved by thermogravimetric analysis-mass spectrometry, which also revealed newly acquired hydrophobic properties. Raman and IR spectroscopies demonstrated that the POM skeleton units in both hybrids were distorted compared to the POM in PTA, which induced a decrease of their reduction potentials as observed by diffuse reflectance ultraviolet-visible spectroscopy (DR-UV-vis). The hybrids' acidity was assessed by ammonia temperature-programmed desorption, which showed no remaining acid sites compared to the strong acidic character of the pristine PTA. The properties of the hybrids were tested in the epoxidation of cyclooctene in the presence of H₂O₂. The reaction was boosted when the hybrids were pre-activated with H₂O₂.

Polyoxometalate-based metal–organic frameworks for heterogeneous catalysis

POM-based MOFs simultaneously possessing the virtues of POMs and MOFs exhibit excellent heterogeneous catalytic properties.

A Series of Compounds Based on [P2W18O62]6- and Transition Metal Mixed Organic Ligand Complexes with High Catalytic Properties for Styrene Epoxidation

Seven compounds based on [P₂W₁₈O₆₂]^6- ({P₂W₁₈}) were successfully prepared and carefully characterized. [HC₅H₅N][Cu(2,2'-bpy)₂]₂[HP₂W₁₈O₆₂]·2H₂O (bpy = bipyridine) (1) is constructed from {P₂W₁₈} bridged by [Cu(2,2'-bpy)₂]²⁺. [HC₅H₅N][Zn(2,2'-bpy)₂]₂[HP₂W₁₈O₆₂]·4H₂O (1a) is isostructural and isomorphous with compound 1. [Cu₄(2,2'-bpy)₃(nic)₃(OH)₂(H₂O)][H₃P₂W₁₈O₆₂]·0.5H₂O (nic = nicotinic acid) (2) is formed by {P₂W₁₈} and tetracopper transition metal mixed organic ligand complexes (TMMCs). [Cu₂(2,2'-bpy)₂(C₂O₄)]₃[P₂W₁₈O₆₂]·3H₂O (3) is made up of {P₂W₁₈} and bicopper TMMCs, [Cu₆(2,2'-bpy)₆(OH)₆][P₂W₁₈O₆₂]·2H₂O (4) is built up from {P₂W₁₈}, and hexacopper complexes of 2,2'-bpy and hydroxyls. [Cu(2,2'-bpy)(hnic)_0.5][Cu₃(2,2'-bpy)₃(hnic)₂(H₂O)₂][H₃P₂W₁₈O₆₂] (hnic = hydroxyl nicotinic acid) (5a) contains two different TMMCs. In addition, compound 5a is the first example of a compound that contains Cu-π interactions. [Cu₂(2,2'-bpy)₂(hnic)][H₄P₂W₁₈O₆₂]· xH₂O ( x ≈ 50) (5b) is based on {P₂W₁₈} and [Cu₂(2,2'-bpy)₂(hnic)]²⁺. We discuss the mechanisms for the formations of these compounds. All the catalytic performances of the compounds for styrene epoxidation to styrene oxide are high.

Hydrothermal synthesis and crystal structure of a bisupporting Keggin-polyoxometalate hybrid compound decorated with a copper(II) complex unit

A bisupporting Keggin-type polyoxometalate compound, {[CuII(phen)2]2[(HBW12O40)]}[CuIICl2(phen)]2· 2H2O (phen=1,10-phenathroline) (1), has been synthesized through the hydrothermal method and characterized by IR spectroscopy, elemental analysis, UV/Vis/NIR spectroscopy, and powder and single crystal X-ray diffraction. The bisupporting Keggin-polyoxometalate consists of one Keggin-type [HBW12O40]4−core and two covalently linked copper(II) complex fragments [Cu(phen)2]2+. In the crystal structure π···π interactions, C–H···Cl, O–H···Cl, O–H···O and C–H···O hydrogen bonds lead to a three-dimensional supramolecular structure.

A series of organic–inorganic hybrid compounds formed by [P2W18O62]6−and several types of transition metal complexes

A series of new organic–inorganic hybrid compounds based on [P₂W₁₈O₆₂]⁶⁻and several types of transition metal complexes have been synthesized and characterized.

The first 3D host–guest structure based on a three-fold interpenetrated Ag-pz coordination polymer network and Keggin-type aluminum tungstates with photo/electro-catalytic properties

A 3-D POMOF host–guest structure based on {AlW₁₂} and Ag-pz MOF units was prepared, which exhibit good photo- and electrocatalytic behavior.

New organic–inorganic hybrid compounds constructed from polyoxometalates and transition metal mixed-organic-ligand complexes

Five compounds constructed from different polyoxoanions and metal mixed-organic complexes of carboxylates and nitrogen-containing ligands have been synthesized and characterized.

Design and synthesis of purely inorganic 3D frameworks composed of reduced vanadium clusters and manganese linkers

Two purely inorganic three-dimensional (3D) frameworks [Mn4(H2O)11V(IV)(18)O42(PO4)](7-) (1) and [Mn2(H2O)7V(IV)(18)O42(PO4)](11-) (2) were synthesized under hydrothermal conditions and fully characterized by single-crystal X-ray structural analysis, IR spectroscopy, thermogravimetric analysis and PXRD. Structural analysis revealed that these two compounds contained a similar all reduced polyoxoanion [V(IV)(18)O42(PO4)](15-) linked by different amounts of manganese centers to form 3D framework materials. The V centers in these two compounds were all reduced to the +IV oxidation state, resulting in an all reduced polyoxoanion, which was firstly used as the building block for constructing 3D framework materials. The all reduced typical polyoxoanion [V(IV)(18)O42(PO4)](15-) with 15 negative charges supplied enough charge amount to accept TM cations. In these two structures, the anions were surrounded by 12 and 5 Mn(2+) ions, respectively, adjusted by varying the feeding amount of MnCl2·4H2O. An electrocatalytic study revealed that compound 1 exhibits electrocatalytic activity for reduction of H2O2.

Tuning the structures based on polyoxometalates from 1-D to 2-D by using different secondary organic ligands

Six new organic-inorganic hybrid compounds based on [XM12O40](4-) (X = heteroatom, M = metal atom), namely [Cu(pic)2][H2XM12O40]·2Hapy·2apy (X = Si, M = W for , X = Ge, M = W for and X = Si, M = Mo for ), [Cu(2,2'-bpy)2][Cu(2,2'-bpy)(H2O)][Cu(pic)2]0.5[XM12O40]·nH2O (X = Si, M = Mo, n = 0.5 for , X = Ge, M = W, n = 1 for ) and [Cu(phen)(H2O)]2[Cu(pic)2][GeW12O40]·2.5H2O () (pic = deprotonated picolinic acid, apy = 2-aminopyridine, 2,2'-bpy = 2,2'-bipyridine, phen = phenanthroline), have been synthesized and characterized by IR, UV-Vis, XRD, cyclic voltammetric measurements and single crystal X-ray diffraction analysis. Single crystal X-ray analysis reveals that compounds are isomorphous and isostructural, in which each is based on [H2XM12O40](2-) and [Cu(pic)2]. Compounds and are also isomorphous and isostructural, of which the structures are more interesting than those of compounds . Both structures are constructed from [XM12O40](4-) and metal mixed-organic-ligand complexes. Compound is also constructed from Keggin ions and metal mixed-organic-ligand complexes, which are, however, thoroughly different from those of compounds and . The photodegradation properties of compounds have been analyzed. Compounds also exhibit rapid absorption properties for RhB (Rhodamine B). Detailed analysis of the photodegradation properties of compounds reveals that the molybdate POM has stronger degradation ability for RhB than the tungstate one.

Architectural chemistry of polyoxometalate-based coordination frameworks constructed from flexible N-donor ligands

Polyoxometalate-based coordination frameworks (POMCFs) constructed from flexible N-donor ligands can exhibit diverse properties and fascinating architectures, extending the families of material chemistry and structural chemistry.

Heterogeneous epoxidation of alkenes with H2O2 catalyzed by a recyclable organic–inorganic polyoxometalate-based framework catalyst

PW-MOF as an efficient, recyclable and stable catalyst for the selective oxidation of alkenes with hydrogen peroxide.

A series of polyoxometalate-based compounds including infinite Ag belts and circles constructed by two tolyl-1H-tetrazole isomers

Three novel Keggin-based complexes constructed by two new isomeric ligands 5-o-tolyl-1H-tetrazole and 5-m-tolyl-1H-tetrazole have been synthesized under hydrothermal conditions via changing the types of POM anions and organic ligands.