From molecular modelling to photophysics of neutral oligo- and polyfluorenes incorporated into phospholipid bilayers

Effects of Charge Density on Photophysics and Aggregation Behavior of Anionic Fluorene-Arylene Conjugated Polyelectrolytes

Three anionic fluorene-based alternating conjugated polyelectrolytes (CPEs) have been synthesized that have 9,9-bis(4-phenoxy-butylsulfonate) fluorene-2,7-diyl and 1,4-phenylene (PBS-PFP), 4,4′-biphenylene (PBS-PFP2), or 4,4″-p-terphenylene (PBS-PFP3) groups, and the effect of the length of the oligophenylene spacer on their aggregation and photophysics has been studied. All form metastable dispersions in water, but can be solubilized using methanol, acetonitrile, or dioxane as cosolvents. This leads to increases in their emission intensities and blue shifts in fluorescence maxima due to break-up of aggregates. In addition, the emission maximum shifts to the blue and the loss of vibronic structure are observed when the number of phenylene rings is increased. Debsity Functional Theory (DFT) calculations suggest that this is due to increasing conformational flexibility as the number of phenylene rings increases. This is supported by increasing amplitude in the fast component in the fluorescence decay. The nonionic surfactant n-dodecylpentaoxyethylene glycol ether (C₁₂E₅) also breaks up aggregates, as seen by changes in fluorescence intensity and maximum. However, the loss in vibrational structure is less pronounced in this case, possibly due to a more rigid environment in the mixed surfactant-CPE aggregates. Further information on the aggregates formed with C₁₂E₅ was obtained by electrical conductivity measurements, which showed an initial increase in specific conductivity upon addition of surfactants, while at higher surfactant/CPE molar ratios a plateau was observed. The specific conductance in the plateau region decreased in the order PBS-PFP3 < PBS-PFP2 < PBS-PFP, in agreement with the change in charge density on the CPE. The reverse process of aggregate formation has been studied by injecting small volumes of solutions of CPEs dissolved at the molecular level in a good solvent system (50% methanol-water) into the poor solvent, water. Aggregation was monitored by changes in both fluorescence and light scattering. The rate of aggregation increases with hydrophobicity and concentration of sodium chloride but is only weakly dependent on temperature.

Charge-Mediated Localization of Conjugated Polythiophenes in Zwitterionic Model Cell Membranes

The selective engineering of conjugated polyelectrolyte (CPE)-phospholipid interfaces is poised to play a key role in the design of advanced biomedical and biotechnological devices. Herein, we report a strategic study to investigate the relationship between the charge of the CPE side group and their association with zwitterionic phospholipid bilayers. The interaction of dipalmitoylphosphatidylcholine (DPPC) phospholipid vesicles with a series of poly(thiophene)s bearing zwitterionic, cationic, or anionic terminal groups (P3Zwit, P3TMAHT and P3Anionic, respectively) has been probed. Although all CPEs showed an affinity for the zwitterionic vesicles, the calculated partition coefficients determined using photoluminescence spectroscopy suggested preferential incorporation within the lipid bilayer in the order P3Zwit > P3Anionic ≫ P3TMAHT. The polarity probe Prodan was used to further qualify the position of the CPE inside the vesicle bilayers via Förster resonance energy transfer (FRET) studies. The varying proximity of the CPEs to Prodan was reflected in the Stern-Volmer quenching constants and decreased in the order P3Anionic > P3TMAHT ≫ P3Zwit. Dynamic light scattering measurements showed an increase in the hydrodynamic diameter of the DPPC vesicles upon addition of each poly(thiophene), but to the greatest extent for P3Anionic. Small-angle neutron scattering studies also revealed that P3Anionic specifically increased the thickness of the headgroup region of the phospholipid bilayer. Epifluorescence and atomic force microscopy imaging showed that P3TMAHT formed amorphous agglomerates on the vesicle surface, P3Zwit was buried throughout the bilayer, and P3Anionic formed a shell of protruding chains around the surface, which promoted vesicle fusion. The global data indicate three distinctive modes of interaction for the poly(thiophene)s within DPPC vesicles, whereby the nature of the association is ultimately controlled by the pendant charge group on each CPE chain. Our results suggest that charge-mediated self-assembly may provide a simple and effective route to design luminescent CPE probes capable of specific localization within phospholipid membranes.

Sequential detection of multiple phase transitions in model biological membranes using a red-emitting conjugated polyelectrolyte

Charge-mediated assembly of an anionic poly(thiophene) leads to a highly sensitive probe of membrane order.