1
|
Lu Y, Lyu D, Zhao X, Men Y. Influence of Molecular Weight on the Nucleation and Growth of Different Crystal Forms in Isotactic Polypropylene: In Situ Synchrotron Microfocus X-Ray Scattering Combined with Fast-Scanning Chip Calorimetry Investigations. Macromolecules 2023. [DOI: 10.1021/acs.macromol.3c00054] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 03/31/2023]
|
2
|
Pantani R, Speranza V, Titomanlio G. Effect of flow-induced crystallization on the distribution of spherulite dimensions along cross section of injection molded parts. Eur Polym J 2017. [DOI: 10.1016/j.eurpolymj.2017.10.012] [Citation(s) in RCA: 31] [Impact Index Per Article: 4.4] [Reference Citation Analysis] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 11/26/2022]
|
3
|
Ma SJ, Wang SW, Zhang Q, Li Q. Improved Layer Mechanical Properties of Micro Injection Molded PP. INT POLYM PROC 2017. [DOI: 10.3139/217.3349] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 11/20/2022]
Abstract
Abstract
The results have been achieved by adjusting the structure to improve the performance of micro injection molded isotactic polypropylene products. Annealing was adopted to optimize the performance of isotactic polypropylene micro injection molded gears. It was found that the annealing temperature shows greater influence on the crystalline structure of the micro injection molded gears than annealing time. The layer mechanical properties were greatly improved after annealing, about 1.7-fold for modulus and 1.9-fold for hardness of the micro injection molded gears relative to the unannealed sample. This is due to the fact the state of molecular chain aggregation tends to be consistent after high temperature annealing in the micro injection molded isotactic polypropylene gear sample.
Collapse
Affiliation(s)
- S. J. Ma
- National Center for International Joint Research of Micro-Nano Molding Technology , School of Mechanics and Engineering Science, Zhengzhou University, Zhengzhou , PRC
| | - S. W. Wang
- National Center for International Joint Research of Micro-Nano Molding Technology , School of Mechanics and Engineering Science, Zhengzhou University, Zhengzhou , PRC
- State Key Laboratory Cultivation Base for Nonmetal Composites and Functional Materials , Southwest University of Science and Technology, Mianyang , PRC
| | - Q. Zhang
- State Key Laboratory Cultivation Base for Nonmetal Composites and Functional Materials , Southwest University of Science and Technology, Mianyang , PRC
| | - Q. Li
- National Center for International Joint Research of Micro-Nano Molding Technology , School of Mechanics and Engineering Science, Zhengzhou University, Zhengzhou , PRC
| |
Collapse
|