Fabrication and application of 2,4,6-trinitrophenol sensors based on fluorescent functional materials

2,4,6-Trinitrophenol (TNP) has been widely used for a long time. The adverse effects of TNP on ecological environment and human health have promoted researchers to develop various methods for detecting TNP. Among multifarious technologies utilized for the TNP detection, fluorescence strategy based on different functional materials has become an effective and efficient method attributed to its merits such as preferable sensitivity and selectivity, rapid response speed, simple operation, and lower cost, which is also the focus of review. This review summarizes the development status of fluorescence sensors for TNP in a detailed and systematic way, especially focusing on the research progress since 2015. The sensing properties of fluorescent materials for TNP are the core of this review, including nanomaterials, organic small molecules, emerging supramolecular systems, aggregation induced emission materials and others. Moreover, the development direction and prospect of fluorescence sensing method in the field of TNP detection are introduced and discussed at the end of review.

Synthetic Approaches, Modification Strategies and the Application of Quantum Dots in the Sensing of Priority Pollutants

Polycyclic aromatic hydrocarbons (PAHs) and nitro-aromatic compounds (NACs) are two classifications of environmental pollutants that have become a source of health concerns. As a result, there have been several efforts towards the development of analytical methods that are efficient and affordable that can sense these pollutants. In recent decades, a wide range of techniques has been developed for the detection of pollutants present in the environment. Among these different techniques, the use of semiconductor nanomaterials, also known as quantum dots, has continued to gain more attention in sensing because of the optical properties that make them useful in the identification and differentiation of pollutants in water bodies. Reported studies have shown great improvement in the sensing of these pollutants. This review article starts with an introduction on two types of organic pollutants, namely polycyclic aromatic hydrocarbons and nitro-aromatic explosives. This is then followed by different quantum dots used in sensing applications. Then, a detailed discussion on different groups of quantum dots, such as carbon-based quantum dots, binary and ternary quantum dots and quantum dot composites, and their application in the sensing of organic pollutants is presented. Different studies on the comparison of water-soluble quantum dots and organic-soluble quantum dots of a fluorescence sensing mechanism are reviewed. Then, different approaches on the improvement of their sensitivity and selectivity in addition to challenges associated with some of these approaches are also discussed. The review is concluded by looking at different mechanisms in the sensing of polycyclic aromatic hydrocarbons and nitro-aromatic compounds.

Amino-functionalized Cu metal-organic framework nanosheets as fluorescent probes for detecting TNP

Here, we report a simple and benign method to successfully fabricate amino-functionalized Cu metal-organic framework (NH₂-Cu-MOF) nanosheets. After synthesizing Cu₂O nanocubes, they were mixed with organic ligand 2-aminoterephthalic acid (NH₂BDC) solution at room temperature for 4 hours to form NH₂-Cu-MOF nanosheets. Interestingly, the prepared NH₂-Cu-MOF nanosheets have ultra-thin thickness, directional growth characteristics and excellent crystallinity. Moreover, such nanosheets showed high-intensity and high-stability fluorescence emission under excitation. As TNP in water can quench the fluorescence emission of the fluorescent probe, the NH₂-Cu-MOF nanosheet fluorescent probe was established for detecting TNP in water with high sensitivity and selectivity, which is very useful for assessing the environmental quality and safety of water bodies. Finally, the probe was used to detect TNP in actual samples with good recovery rate.

Rapid optical sensor for recognition of explosive 2,4,6-TNP traces in water through fluorescent ZnSe quantum dots

In this report, blue fluorescent zinc selenide quantum dots (ZnSe QDs) were synthesized using 3-mercaptopropionic acid through a direct aqueous route at a lower temperature of 70 °C. The photoluminescence (PL) characteristics of ZnSe QDs have been employed to recognize nitroaromatic compounds, i.e., traces of 2,4,6-TNP (picric acid) in water. The sensing of nitroaromatic compounds was performed via fluorescence techniques. The PL band of ZnSe QDs observed at 490 nm is selectively quenched with an increasing concentration of picric acid in DI water and river water. For the proposed sensing probe, the Stern-Volmer (S-V) plot shows linearity over the range of 2.0 µM-0.25 mM with the detection limit of 12.4 × 10^-6 M without any interference effect of other nitroaromatic compounds. The plausible mechanism of PL quenching is considered as the inner filter effect, based on absorption, PL and PL lifetimes.

Mimicking biological process to detect alkaline phosphatase activity using the vitamin B6 cofactor conjugated bovine serum albumin capped CdS quantum dots

This manuscript presents a novel bioanalytical approach for the selective ratiometric fluorescent sensing of enzymatic activity of the alkaline phosphatase (ALP) in the biological samples. The probe was designed by conjugating the pyridoxal 5'-phosphate (PLP) over the surface of bovine serum albumin (BSA) stabilized CdS quantum dots (QDs) through the interaction of free amine present in BSA with the aldehyde group of PLP. The conjugation of PLP quenched the emission of QDs. Upon addition of the ALP, the emission of QDs was restored due to the dephosphorylation and the conversion of the functionalized PLP in to pyridoxal. With this probe, the ALP activity can be detected down to 0.05 U/L and also successfully applied for the detection of ALP activity in biological samples such as human serum and plasma.

Fluorescent chitosan hydrogel for highly and selectively sensing of p-nitrophenol and 2, 4, 6-trinitrophenol

Nitroaromatic compounds, especially 2, 4, 6-trinitrophenol, have strong biological toxicity and explosive risks, so the detection of 2, 4, 6-trinitrophenol exhibit importantly practical and scientific significance. In this work, three fluorescence functionalized chitosan CNS 3, CNS 4 and CNS 5 were prepared using chitosan as matrix. When 2, 4, 6-trinitrophenol (TNP) and/or p-nitrophenol (4-NP) was present in spot, these fluorescent chitosan sensors produced notable fluorescence quenching. It renders the chitosan sensing ability to detect TNP and 4-NP selectively and sensitively. The sensing mechanism is investigated as well. When introduced electron-rich moieties to the fluorescent chitosan, the sensitive detecting ability could be obtained. Excellent recognition ability could reach as low as 0.28 μM. The fluorescence fictionalization cause slight influence to the gel performance of chitosan.

Amorphous Carbon Dots and their Remarkable Ability to Detect 2,4,6-Trinitrophenol

Apparently mundane, amorphous nanostructures of carbon have optical properties which are as exotic as their crystalline counterparts. In this work we demonstrate a simple and inexpensive mechano-chemical method to prepare bulk quantities of self-passivated, amorphous carbon dots. Like the graphene quantum dots, the water soluble, amorphous carbon dots too, exhibit excitation-dependent photoluminescence with very high quantum yield (~40%). The origin and nature of luminescence in these high entropy nanostructures are well understood in terms of the abundant surface traps. The photoluminescence property of these carbon dots is exploited to detect trace amounts of the nitro-aromatic explosive - 2,4,6-trinitrophenol (TNP). The benign nanostructures can selectively detect TNP over a wide range of concentrations (0.5 to 200 µM) simply by visual inspection, with a detection limit of 0.2 µM, and consequently outperform nearly all reported TNP sensor materials.

Fluorescence chemical sensor for determining trace levels of nitroaromatic explosives in water based on conjugated polymer with guanidinium side groups

A novel fluorescent conjugated polymer (poly(2-amino-N-(2-((4-ethynylphenyl) ethynyl) phenyl)-5-guanidinopentanamide)-1,4-phenylethynylene-1,4-phenyleneethynylene, PPE-Arg) was synthesized in this paper. We found that PPE-Arg could be quenched by picric acid (PA). Photoinduced electron transfer (PET) mechanism can be used to describe the fluorescence quenching of PPE-Arg. It could be speculated that the photo-induced electrons may be transferred from PPE-Arg to nitroaromatic explosives. In this paper, the experiment conditions and detection performance of PPE-Arg were systematically studied. The experiment results demonstrate PPE-Arg as a sensor for PA has a good linear range from 5 × 10^-7 to 6 × 10^-5 mol L^-1 with the calculated limit of detection (LOD) to be 1.0 × 10^-7 mol L^-1. Meanwhile, reaction time between PPE-Arg and PA is less than 1 min. This proposed sensor was applied to rapidly detect nitroaromatic explosives in environmental water samples and satisfactory results were obtained.