Pyrolytic urban mining of waste printed circuit boards: an enviro-economic analysis

E-waste, a global environmental concern resulting from supply chain inefficiency, also offers the opportunity to recover valuable materials, including general and rare earth metals. Waste printed circuit boards (WPCBs) are integral components of e-waste that contains substantial amounts of precious metals, making them a valuable waste category. Pyrolysis has emerged as a promising method for material recovery from WPCBs. Hence, pyrolytic urban mining of WPCBs offers an excellent avenue for resource recovery, redirecting valuable materials back into the supply chain. Under the current study, experimental investigation has been conducted to explore the recovery of materials from WPCBs through pyrolysis followed by process simulation, economic analysis, and life cycle assessment (LCA). An Aspen Plus simulation was conducted to model the pyrolysis of WPCBs and subsequent product recovery using a non-equilibrium kinetic model, which represents a unique approach in this study. Another distinct aspect is the comprehensive assessment of environmental and economic sustainability. The economic analysis has been carried out using Aspen economic analyzer whereas the LCA of WPCB pyrolysis has been conducted using the SimaPro software. The experimental investigation reveals yield of solid residues are about 75-84 wt.%, liquid yields of 6-13 wt.%, and gas yields of 4-21 wt.%, which is in well agreement with the Aspen Plus simulation results. The economic analysis for an e-waste pyrolysis plant with an annual feed rate of 2000 t reveals that the total capital cost of a pyrolysis plant is nearly $51.3 million, whereas the total equipment cost is nearly $2.7 million and the total operating cost is nearly $25.6 million. The desired rate of return is 20% per year and the payback period is 6 years with a profitability index of 1.25. From the LCA, the major impact categories are global warming, fossil resource scarcity, ozone formation in human health, ozone formation in terrestrial ecosystems, fine particulate matter formation, and water consumption. The findings of this study can serve as a guideline for e-waste recyclers, researchers, and decision-makers in establishing circular economy.

Synergistic Effects of Catalyst Mixtures on Biomass Catalytic Pyrolysis

This paper studied the synergistic effects of catalyst mixtures on biomass catalytic pyrolysis in comparison with the single catalyst in a microwave reactor and a TGA. In general, positive synergistic effects were identified based on increased mass loss rate, reduced activation energy, and improved bio-oil quality compared to the case with a single catalyst at higher catalyst loads. 10KP/10Bento (a mixture of 10% K₃PO₄ and 10% bentonite) increased the mass loss rate by 85 and 45% at heating rates of 100 and 25°C/min, respectively, compared to switchgrass without catalyst. The activation energy for 10KP/10Bento and 10KP/10Clino (a mixture of 10% K₃PO₄ and 10% clinoptilolite) was slightly lower or similar to other catalysts at 30 wt.% load. The reduction in the activation energy by the catalyst mixture was higher at 100°C/min than 25°C/min due to the improved catalytic activity at higher heating rates. Synergistic effects are also reflected in the improved properties of bio-oil, as acids, aldehydes, and anhydrosugars were significantly decreased, whereas phenol and aromatic compounds were substantially increased. 30KP (30% K₃PO₄) and 10KP/10Bento increased the content of alkylated phenols by 341 and 207%, respectively, in comparison with switchgrass without catalyst. Finally, the use of catalyst mixtures improved the catalytic performance markedly, which shows the potential to reduce the production cost of bio-oil and biochar from microwave catalytic pyrolysis.