Resolving phenylephrine HCl and guaifenesin enantiomers on cellulose-based chiral stationary phases: Separation of four enantiomers on 50-mm column

Chiral high performance liquid chromatographic technique usually employs polysaccharide-based stationary phases in a normal phase mode. This frequently generates large waste of organic solvents. Using shorter columns of 50 mm length as well as a mobile phase with a high water percentage are common approaches for greening this analytical technique. In this context, a new chiral chromatographic technique was developed for simultaneous enantio-separation of phenylephrine HCl and guaifenesin racemates. Four 50 mm cellulose-based columns were experimented to separate the four enantiomers in a reversed phase mode. A face centered design was then employed to optimize the mobile phase acetonitrile% and flow rate on Lux Cellulose-1 (50 × 4.6 mm, 5 μm). The simultaneous resolution of the cited drugs enantiomers was achieved using acetonitrile-water (30:70, by volume), with a flow rate of 0.5 ml min-1 . These optimized chromatographic conditions separate the enantiomers in 7 min running time, generating about 1.0 ml acetonitrile per run. The proposed method was favorably compared with other reported chiral ones in terms of waste volume generated and analysis time required.

Simultaneous determination of guaifenesin enantiomers and ambroxol HCl using 50-mm chiral column for a negligible environmental impact

Chiral stationary phases are conveniently used for enantiomeric separation of drugs by liquid chromatography. Consumption of large volumes of hazardous solvents is considered as a common challenge for the sustainability of this technique. To this end, a columnar chromatography has been adopted using 50-mm-length stationary phases. The study comprised five Phenomenex Lux cellulose- and amylose-based columns for the separation of guaifenesin (GUA) enantiomers. In addition, an experimental design was used to optimize the gradient profile for the separation of racemic GUA and ambroxol HCl (AMB) binary mixture. The chromatographic method was achieved using Lux Cellulose-1 (50 × 4.6 mm) as a chiral stationary phase and ethanol/water as a mobile phase with linear gradient elution of 20% to 70% ethanol in 6 minutes at a flow rate of 1.0 mL min^-1 and UV detection at 270 nm. Linearity ranges were found to be 50 to 1000 μg mL^-1 and 15 to 450 μg mL^-1 for each GUA enantiomer and AMB, respectively. Environmental, health and safety tool was used to assess and compare greenness of the proposed and reported methods. Short column indeed reduces the environmental impact by decreasing waste by about 60% and utilizing only 1-mL ethanol in the mobile phase. The proposed method is a safer alternative for the simultaneous determination of drugs in their combined pharmaceutical formulation. The method has been validated and compared favorably with a reported one.

Experimental Design Methodologies for the Optimization of Chiral Separations: An Overview

In this chapter, the application of design of experiments (DoE) for chiral separation optimization using supercritical fluid chromatography (SFC), liquid chromatography (LC), capillary electrophoresis (CE), and capillary electrochromatography (CEC) methods is reviewed. Both screening and optimization steps are covered, including a discussion of each aspect, such as factor-, level-, and response selection. Different designs are also presented, highlighting their applications.

Advanced chemometrics manipulation of UV-spectroscopic data for determination of three co-formulated drugs along with their impurities in different formulations using variable selection and regression model updating

Multivariate calibration models manipulating UV-spectroscopic data of three anti-productive cough drugs namely ambroxol, guaifenesin and theophylline were constructed for the intent of simultaneous determination in presence of their impurities; guaiacol and caffeine. Both interval partial least squares (iPLS) and synergy interval partial least square (siPLS) algorithms were adopted for variables selection to extract useful information and improve the models' performance. The optimal spectral range and their combinations were assigned according to the lowest value of Root Mean Square Error of Prediction (RMSEP), Standard Error of Prediction (SEP) and Correlation Coefficient (R²). The results obtained from full spectrum PLS were compared with those obtained by iPLS and siPLS. The siPLS method exhibited better performance. The combination of four subintervals, 2, 9, 13, and 16, showed the best effect, with RMSEP of 0.1039, 0.3548 and 0.207 μg/mL, for ambroxol, guaifenesin and theophylline, respectively and correlation coefficient of 0.9999, 0.9975 and 0.9994 for ambroxol, guaifenesin and theophylline, respectively. The proposed methods were used for the simultaneous determination of the three drugs in presence of their impurities in bulk powder and in pharmaceutical formulation.

A turn-on FRET sensor based on dichlorofluorescein and AuNPs for rapid and ultrasensitive detection of ambroxol hydrochloride in urine

Schematic illustration for the detection of ambroxol based on FRET between the AuNPs and DCF.