Site-selective nanoscale-polymerization of pyrrole on gold nanoparticles via plasmon induced charge separation

Site-selective introduction of MnO2 co-catalyst onto gold nanocubes via plasmon-induced charge separation and galvanic replacement for enhanced photocatalysis

For energy harvesting with plasmonic photocatalysis, it is important to optimize geometrical arrangements of plasmonic nanomaterials, electron (or hole) acceptors, and co-catalysts so as to improve the charge separation efficiency and suppress charge recombination. Here we employ a photocatalytic system with Au nanocubes on TiO2, and introduced MnO2 as an oxidation co-catalyst onto the nanocubes via site-selective oxidation based on plasmon-induced charge separation (PICS). However, it has been known that PbO2 is the only material that can be deposited onto Au nanomaterials through PICS with sufficient site-selectivity. Here we addressed this issue by introducing an indirect approach for MnO2 deposition via site-selective PbO2 deposition and subsequent galvanic replacement of PbO2 with MnO2. The indirect approach gave nanostructures with MnO2 introduced at around the top part, bottom part, or the entire surface of the Au nanocubes on a TiO2 electrode. The activity of those plasmonic photocatalysts was strongly dependent on the location of MnO2. The key to improving the activity is to separate MnO2 from TiO2 to prevent recombination of the positive charges in MnO2 with the negative ones in TiO2.

Plasmonic-redox controlled atom transfer radical polymerization

Plasmonic-ATRP has been developed in which Cu(i) species are (re)generated via photo-redox reactions both directly by hot electrons and indirectly by hot holes, in which the polymerization degree and molecular weight can be regulated by controlling the rate of plasmonic hot carrier extraction.

Spatial distribution of active sites for plasmon-induced chemical reactions triggered by well-defined plasmon modes

Plasmon-induced chemical reactions triggered by near-infrared light illumination might enable efficient photo energy conversion. Here, electrochemical oxidative polymerization of a conductive polymer was conducted on plasmonic photoconversion electrodes. The absolute electrochemical potential of the generated holes was estimated from the redox potentials of the monomers. In addition, well-defined plasmonic structures were examined to better understand the relationship between the excited plasmon mode and spatial distribution of reaction active sites. Rod structures with various lengths had distinct spatial distributions of reaction active sites that depended on the higher plasmon modes, as visualized by Raman measurements.

Visualization of nano-localized and delocalized oxidation sites for plasmon-induced charge separation

Oxidation reaction sites for plasmon-induced charge separation at Au nanocubes on TiO2 were visualized on the basis of deposition and dissolution reactions. For Pb2+ oxidation, PbO2 was deposited selectively at resonance sites of the nanocube, while oxidation polymerization of pyrrole to polypyrrole and oxidative dissolution of Au took place over the entire nanocube surface. The localized and delocalized reaction sites are explained in terms of a relationship between oxidation potentials of the electron donors and potentials of the entire nanocube and localized holes.

Current trends in pyrrole and porphyrin-derived nanoscale materials for biomedical applications

This article is written to provide an up-to-date review of pyrrole-based biomedical materials. Porphyrins and other tetrapyrrolic molecules possess unique magnetic, optical and other photophysical properties that make them useful for bioimaging and therapy. This review touches briefly on some of the synthetic strategies to obtain porphyrin- and tetrapyrrole-based nanoparticles, as well as the variety of applications in which crosslinked, self-assembled, porphyrin-coated and other nanoparticles are utilized. We explore examples of these nanoparticles' applications in photothermal therapy, drug delivery, photodynamic therapy, stimuli response, fluorescence imaging, photoacoustic imaging, magnetic resonance imaging, computed tomography and positron emission tomography. We anticipate that this review will provide a comprehensive summary of pyrrole-derived nanoparticles and provide a guideline for their further development.

Plasmon-assisted grafting of anisotropic nanoparticles - spatially selective surface modification and the creation of amphiphilic SERS nanoprobes

Amphiphilic nanoparticles (NPs) with a spatially selective distribution of grafted functional groups have great potential in the field of sensing, advanced imaging, and therapy due to their unique surface properties. The main techniques for the spatially selective functionalization of NPs utilize the surface-assisted approaches, which significantly restrict their production throughput. In this work, we propose an alternative plasmon-based route for the spatially selective grafting of anisotropic gold nanorods (AuNRs) using iodonium and diazonium salts. Utilization of longer laser wavelengths leads to the excitation of longitudinal plasmon resonances on AuNR tips, plasmon-assisted homolysis of the C-I bond in iodonium salts and the formation of aryl radicals, which are further grafted to the tips of AuNRs. The sides of AuNRs were subsequently decorated through spontaneous diazonium surface grafting. As a result, the AuNRs with spatially separated functional groups were prepared in a versatile way, primarily in solution and without the need for a sophisticated technique of NP immobilization or surface screening. The versatility of the proposed approach was proved on three kinds of AuNRs with different architectures and wavelength positions of plasmon absorption bands. Moreover, the applicability of the prepared amphiphilic AuNRs was shown by efficient trapping and SERS sensing of amphiphilic biomolecules.

Polaron and bipolaron induced charge carrier transportation for enhanced photocatalytic H2 production

Photocatalysis is one of the facile approaches for efficient solar energy conversion and storage. However, rapid charge carrier recombination considerably decreases solar to energy conversion efficiency. Herein, polaron and bipolaron rich polypyrrole (PPy) has been utilized as a solid support for effective photogenerated charge carrier separation. Simple oxidative polymerization using a high concentration of ammonium persulfate (APS) induces radical cation/bipolaron formation in PPy due to the cleavage of π-bonds as confirmed by electron paramagnetic resonance spectroscopy (EPR). The formation of radical cations led to an increase of the dielectric constant which retards the charge carrier recombination and thereby enhances the conductivity. Moreover, the polarons and bipolarons induced charge carrier separation in photocatalytic H₂ production was studied with the well-known g-C₃N₄ photocatalyst. It is worth mentioning that compared to bare g-C₃N₄, the PPy supported system showed a drastically enhanced photocatalytic H₂ production rate. A maximum H₂ production rate of 1851 μmoles per g is achieved, which is ∼51 times higher than that of the bare g-C₃N₄ catalyst due to efficient charge carrier separation assisted by radical cations/bipolarons. Thus, utilizing this simple polaron and bipolaron rich PPy solid support could be an effective strategy and alternative for using noble metal cocatalysts to enhance charge carrier separation.

Plasmonic hole ejection involved in plasmon-induced charge separation

Since the finding of plasmon-induced charge separation (PICS) at the interface between a plasmonic metal nanoparticle and a semiconductor, which has been applied to photovoltaics including photodetectors, photocatalysis including water splitting, sensors and data storage in the visible/near-infrared ranges, injection of hot electrons (energetic electrons) into semiconductors has attracted attention almost exclusively. However, it has recently been found that behaviours of holes are also important. In this review, studies on the hot hole ejection from plasmonic nanoparticles are described comprehensively. Hole ejection from plasmonic nanoparticles on electron transport materials including n-type semiconductors allows oxidation reactions to take place at more positive potentials than those involved in a charge accumulation mechanism. Site-selective oxidation is also one of the characteristics of the hole ejection and is applied to photoinduced nanofabrication beyond the diffraction limit. Hole injection into hole transport materials including p-type semiconductors (HTMs) in solid-state cells, hole ejection through a HTM for stabilization of holes, hole ejection to a HTM for efficient hot electron ejection, voltage up-conversion by the use of hot carriers and electrochemically assisted hole ejection are also described.

Surface-Plasmon- and Green-Light-Induced Polymerization in Mesoporous Thin Silica Films

The near-field of surface plasmon resonances at planar metal surfaces is confined to the nanoscale, but its resonance wavelength is located in the visible light range, making it interesting for confining polymer functionalization of surfaces but incompatible with the majority of polymerization reactions. Here, fluorescein as a polymerization initiator allowing dye-sensitized polymerization with green light (438-540 nm) is demonstrated to allow polymer functionalization of mesoporous films deposited onto planar silver metal layers. The fluorescein-induced polymer functionalization of mesoporous silica films is investigated with respect to the influence of irradiation power and irradiation time and its potential to generate polymer gradients. Finally, the polymer functionalization of mesoporous films upon surface-plasmon-initiated polymerization is demonstrated. Polymer functionalization thereby determines pH-responsive ionic mesopore accessibility. Consequently, these results present a sound basis for further nanoscale near-field-induced polymer functionalization of porous films.

Accelerated site-selective photooxidation on Au nanoparticles via electrochemically-assisted plasmonic hole ejection

In order to induce electrochemical reactions by localized surface plasmon resonance (LSPR), semiconductors have been employed as electron or hole acceptors for plasmon-induced charge separation (PICS) in most cases. Here we replaced a semiconductor with a potential-controlled transparent electrode, and achieved accelerated photooxidation reactions at selected local sites on plasmonic metal nanoparticles. We demonstrate site-selective PbO₂ deposition at the tips and sides of Au nanorods and PbO₂ deposition and Au dissolution at the top and bottom of Au nanocubes, through the selective excitation of different LSPR modes. Energetic electron-hole pairs are generated at a plasmonic resonance site, and oxidation reactions are driven by hole ejection at the site. The complementary electrons are removed via the positively biased electrode, and consumed at a counter electrode by reduction reactions. In the case of the PbO₂ deposition, formation of PbO₂ nuclei is triggered by the hole ejection, and PbO₂ is grown further in an electrochemical manner at an improved rate.

Solvent-Exchange Strategy toward Aqueous Dispersible MoS2 Nanosheets and Their Nitrogen-Rich Carbon Sphere Nanocomposites for Efficient Lithium/Sodium Ion Storage

Major challenges in developing 2D transition-metal disulfides (TMDs) as anode materials for lithium/sodium ion batteries (LIBs/SIBs) lie in rational design and targeted synthesis of TMD-based nanocomposite structures with precisely controlled ion and electron transport. Herein, a general and scalable solvent-exchange strategy is presented for uniform dispersion of few-layer MoS₂ (f-MoS₂ ) from high-boiling-point solvents (N-methyl-2-pyrrolidone (NMP), N,N-dimethyl formaldehyde (DMF), etc.) into low-boiling-point solvents (water, ethanol, etc.). The solvent-exchange strategy dramatically simplifies high-yield production of dispersible MoS₂ nanosheets as well as facilitates subsequent decoration of MoS₂ for various applications. As a demonstration, MoS₂ -decorated nitrogen-rich carbon spheres (MoS₂ -NCS) are prepared via in situ growth of polypyrrole and subsequent pyrolysis. Benefiting from its ultrathin feature, largely exposed active surface, highly conductive framework and excellent structural integrity, the 2D core-shell architecture of MoS₂ -NCS exhibits an outstanding reversible capacity and excellent cycling performance, achieving high initial discharge capacity of 1087.5 and 508.6 mA h g^-1 at 0.1 A g^-1 , capacity retentions of 95.6% and 94.2% after 500 and 250 charge/discharge cycles at 1 A g^-1 , for lithium/sodium ion storages, respectively.

Multi-functionalization of lithographically designed gold nanodisks by plasmon-mediated reduction of aryl diazonium salts

Plasmon-driven surface functionalization of nanoparticles is receiving increasing attention as it allows locally tailored chemical reactivity to be generated on the nanoparticle surface. The extension to surface multi-functionalization still represents a major breakthrough in chemistry. We address this issue by triggering regiospecific surface double-functionalization under plasmon excitation, using diazonium salts as surface functionalization agents.

Local trapping of energetic holes at gold nanoparticles on TiO2

Holes generated by plasmon-induced charge separation cause a local oxidation reaction at plasmonic resonance sites, which is applicable to photo-nanofabrication.

Plasmon-induced charge separation: chemistry and wide applications

Recent development of nanoplasmonics has stimulated chemists to utilize plasmonic nanomaterials for efficient and distinctive photochemical applications, and physicists to boldly go inside the "wet" chemistry world. The discovery of plasmon-induced charge separation (PICS) has even accelerated these trends. On the other hand, some confusion is found in discussions about PICS. In this perspective, we focus on differences between PICS and some other phenomena such as co-catalysis effect and plasmonic nanoantenna effect. In addition, materials and nanostructures suitable for PICS are shown, and characteristics and features unique to PICS are documented. Although it is well known that PICS has been applied to photovoltaics and photocatalysis, here light is shed on other applications that take better advantage of PICS, such as chemical sensing and biosensing, various photochromisms, photoswitchable functionalities and nanoscale photofabrication.

Site-Selective Plasmonic Etching of Silver Nanocubes

Plasmon-induced charge separation (PICS) at the interface between a plasmonic nanoparticle and semiconductor is now widely used for photovoltaics and photocatalysis. Here we take advantage of PICS for site-selective nanoetching of silver nanocubes on TiO₂ beyond the diffraction limit. A silver nanocube exhibits two resonance modes localized at the top and bottom of the nanocube (distal and proximal modes, respectively) when it is placed on TiO₂. We achieved selective etching at the top and the bottom of the nanocubes by PICS based on the distal and proximal modes, respectively. The site-selective nanophotonic etching reveals that the anodic reaction involved in PICS is induced by the plasmonic near field, which causes an external photoelectric effect. In particular, the distal mode etching at the top edges is explained in terms of ejection of energetic electrons (or hot electrons) from the distal site to TiO₂ across the nanocube.