Functional macroporous amphoteric polyelectrolyte monoliths with tunable structures and properties through emulsion-templated synthesis

HYPOTHESIS

Macroporous polyampholyte hydrogels, simultaneously bearing both the anionic and cationic groups, demonstrate immense promise over the one-sign charged polyelectrolytes, owing to a unique phenomenon known as the ˝anti-polyelectrolyte˝ effect. Thus, they are extremely promising materials, since they remain solvated and functional even in harsh conditions. Furthermore, macroporous morphology significantly enhances polyampholyte response to external stimuli, since it accelerates the solvent transport through the hydrogel.

EXPERIMENTS

A new templated-synthesis through "HIPE mixtures" is reported, where the two pre-formed high internal phase emulsions (HIPE) containing the oppositely charged monomers (2-acrylamido-2-methyl-1-propanesulfonic acid and (3-acrylamidopropyl)trimethylammonium chloride) were combined in the same mould, which after polymerization result in the formation of macroporous monoliths of different structures. The resulting frameworks were either copolymer or dual homopolymers in the form of bilayered or mixed porous structures.

FINDINGS

The co- and mixed-amphoteric polyelectrolytes exhibit 'anti-polyelectrolyte' behaviour typical of polyampholytes, while the bilayered-structure behaves like a typical polyelectrolyte. Complete and simultaneous removal of both dyes from a dye mixture was observed for the bilayered- and mixed-amphoteric polyelectrolyte, while copoly-ampholyte showed only partial dye adsorption. These results clearly reveal the benefits of a mutual combination of the HIPE-templated structure and the oppositely charged amphoteric nature in one-piece material as a promising avenue toward advanced materials.

Highly porous and chemical resistive P(TFEMA–DVB) monolith with tunable morphology for rapid oil/water separation

A facile preparation for a series of porous poly(2,2,2-trifluoroethylmethacrylate–divinylbenzene) P(TFEMA–DVB) foams is discussed in this paper. The foams have adjustable morphology utilizing a suitable commercial surfactant, Hypermer B246, as stabilizer, and were compared with traditional organic surfactants or macromolecular block-polymers. Combining the porous properties and advantages of fluorine atoms, this type of fluoropolymer exhibited superb chemical stability and hydrophobicity performances with high porosity. These porous fluoro-monoliths preserved their regular porous structure without any degradation after immersion into strong acidic or basic solution for three days, hence demonstrating an excellent potential to deal with environmental pollution caused by oil spillages in severe environments. The tunable morphology (open and closed pores) and pore sizes were achieved by investigating various parameters like surfactant concentration, amount of external crosslinker, and aqueous phase volume. Droplet sizes of HIPEs were characterized using an optical microscope under different experimental conditions. The influence of pore structure and surface properties of polyHIPE on water contact angle and oil adsorption capacity was also explored. The results indicated that the porous material has an excellent oleophilicity and hydrophobicity, with water contact angles (WCA) up to 146.4°. Additionally, the results presented a noticeable adsorption with a very fast rate towards organic oils from either a water surface or bottom with adsorption saturation achieved in about 120 s. The prepared polyHIPEs showed a good recycling ability; even after 10 adsorption–centrifugation experiments, the adsorption capacity was still more than 85%.

A facile preparation for a series of porous poly(2,2,2-trifluoroethylmethacrylate–divinylbenzene) P(TFEMA–DVB) foams is discussed in this paper.