Facile one-pot method of AuNPs/PEDOT/CNT composites for simultaneous detection of dopamine with a high concentration of ascorbic acid and uric acid

In this research, a facile one-pot method was used to synthesize gold/poly-3,4-ethylene-dioxythiophene/carbon nanotube (AuNPs/PEDOT/CNTs) composite material. The composite material was investigated by Fourier Transform Infrared spectroscopy (FTIR), X-ray diffraction (XRD) and Scanning Electron Microscopy (SEM). Then the synthesized nanocomposite material was dropped on a bare glassy carbon electrode (GCE) to improve the detection performance of dopamine with a high concentration of ascorbic acid and uric acid. The electrochemical behavior of AuNPs/PEDOT/CNTs/GCE was studied by Cyclic Voltammetry (CV), Differential Pulse Voltammetry (DPV) and electrochemical impedance spectroscopy (EIS). Under optimum conditions, AuNPs/PEDOT/CNTs/GCE showed a good linear response in the concentration range from 9.14 to 29.704 μM with a detection limit (LOD) and sensitivity of 0.283 μM and 1.557 μA μM-1, respectively. This sensor was applied to detect practical samples with good average recovery. It also exhibited good reproducibility and stability.

Biosensing platform on ferrite magnetic nanoparticles: Synthesis, functionalization, mechanism and applications

Ferrite magnetic nanoparticles (FMNPs) are gaining popularity to design biosensors for high-performance clinical diagnosis. The fusion of information shows that FMNPs based biosensors require well-tuned FMNPs as detection probes to produce large and specific biological signals with minimal non-specific binding. Nevertheless, there is a noticeable lacuna of information to solve the issues related to suitable synthesis route, particle size reduction, functionalization, sensitivity towards targeted intercellular biological tiny particles, and lower signal-to-noise ratio. Therefore it allows exploring unique characteristics of FMNPs to design a suitable sensing device for intracellular measurements and diseases detection. This review focuses on the extensively used synthesis routes, their advantages and limitations, crystalline structure, functionalization, along with recent applications of FMNPs in biosensors, taking into consideration their analytical figures of merit and range of linearity. This work also addresses the current progress, key factors for sensitivity, selectivity and productivity improvement along with the challenges, future trends and perspectives of FMNPs based biosensors.

Electrospun γ-Fe2O3 nanofibers as bioelectrochemical sensors for simultaneous determination of small biomolecules

Nanofibers of α-Fe₂O₃ and γ-Fe₂O₃ have been obtained after the controlled calcination of precursor nanofibers synthesized by electrospinning. α-Fe₂O₃ nanofibers showed an irregular toruloid structure due to the decomposition of poly (4-vinyl) pyridine in air while γ-Fe₂O₃ nanoparticles decorated nanofibers were observed after the calcination under N₂ atmosphere. Electrochemical measurements showed that different electrochemical behaviors were observed on the glassy carbon electrodes modified by α-Fe₂O₃ and γ-Fe₂O₃ nanofibers. The electrode modified by γ-Fe₂O₃ nanofibers exhibited high electrocatalytic activities toward oxidation of dopamine, uric acid and ascorbic acid while α-Fe₂O₃ nanofibers cannot. Furthermore, the γ-Fe₂O₃ modified electrode can realize the selective detection of biomolecules in ternary electrolyte solutions. The synthesis of nanofibers of α-Fe₂O₃ and γ-Fe₂O₃ and their electrochemical sensing properties relationship have been discussed and analyzed based on the experimental results.

Development of an Fe3O4@Cu silicate based sensing platform for the electrochemical sensing of dopamine

Abnormal levels of dopamine (DA) in body fluids is an indication of serious health issues, hence development of highly sensitive platforms for the precise detection of DA is highly essential. Herein, we demonstrate an Fe₃O₄@Cu silicate based electrochemical sensing platform for the detection of DA. Morphology and BET analysis shows the formation of ∼320 nm sized sea urchin-like Fe₃O₄@Cu silicate core–shell nanostructures with a 174.5 m² g⁻¹ surface area. Compared to Fe₃O₄ and Fe₃O₄@SiO₂, the Fe₃O₄@Cu silicate urchins delivered enhanced performance towards the electrochemical sensing of DA in neutral pH. The Fe₃O₄@Cu silicate sensor has a 1.37 μA μM⁻¹ cm⁻² sensitivity, 100–700 μM linear range and 3.2 μM limit of detection (LOD). In addition, the proposed Fe₃O₄@Cu silicate DA sensor also has good stability, selectivity, reproducibility and repeatability. The presence of Cu in Fe₃O₄@Cu silicate and the negatively charged surface of the Cu silicate shell play a vital role in achieving high selectivity and sensitivity during DA sensing. The current investigation not only represents the development of a highly selective DA sensor but also directs towards the possibility for the fabrication of other Cu silicate based core–shell nanostructures for the precise detection of DA.

Abnormal levels of dopamine (DA) in body fluids is an indication of serious health issues, hence development of highly sensitive platforms for the precise detection of DA is highly essential.

Iron-Based Nanomaterials/Graphene Composites for Advanced Electrochemical Sensors

Iron oxide nanostructures (IONs) in combination with graphene or its derivatives-e.g., graphene oxide and reduced graphene oxide-hold great promise toward engineering of efficient nanocomposites for enhancing the performance of advanced devices in many applicative fields. Due to the peculiar electrical and electrocatalytic properties displayed by composite structures in nanoscale dimensions, increasing efforts have been directed in recent years toward tailoring the properties of IONs-graphene based nanocomposites for developing more efficient electrochemical sensors. In the present feature paper, we first reviewed the various routes for synthesizing IONs-graphene nanostructures, highlighting advantages, disadvantages and the key synthesis parameters for each method. Then, a comprehensive discussion is presented in the case of application of IONs-graphene based composites in electrochemical sensors for the determination of various kinds of (bio)chemical substances.