Sunlight driven photocatalytic degradation of organic pollutants using a MnV2O6/BiVO4 heterojunction: mechanistic perception and degradation pathways

In the field of photocatalysis, fabrication of a heterojunction structure with effective charge separation at the interface and charge shift to enhance the photocatalytic activity has acquired extensive consideration. In the present investigation, MnV2O6/BiVO4 heterojunction samples with excellent photocatalytic performance under sunlight irradiation were conveniently synthesized by a hydrothermal technique, and characterized by UV-Vis, FTIR, XRD, FESEM, HRTEM, PL, BET and XPS techniques. The prepared samples were investigated as photocatalysts for degrading MB and RhB dyes under sunlight. Among various samples of MnV2O6/BiVO4, the S-V hetero-junction sample exhibited maximum photocatalytic activity with 98% and 96% degradation of MB and RhB dyes, respectively, in 6 and 35 min. The high photocatalytic activity of MnV2O6/BiVO4 may be due to the successful generation and shift of charges in the presence of visible light. The average reduction of chemical oxygen demand (COD) was found to be 75% after irradiation with direct sunlight. In the degradation process of dyes, superoxide anion radicals were the main responsive species, as revealed by trapping experiments. The degradation efficiency of MnV2O6/BiVO4 heterojunction did not diminish even after four cycles. In addition, the catalytic performance of the fabricated heterojunction was also explored for reducing 4-nitrophenols (4-NP) by using NaBH4. Absolute conversion of 4-NP to 4-aminophenol (4-AP) occurred without the production of intermediate byproducts.

Understanding the Structural-Dependent Photocatalytic Antibacterial Activity: a Case Study of Ag Modified BiVO4

In this work, Ag/BiVO₄ heterostructural photocatalysts were developed in order to reveal exceptional structural-dependent photoinduced charge migration kinetics as well as the underlying photocatalytic antibacterial dynamic process. The structure-dependent interface of BiVO₄ and Ag nanoparticles was successfully constructed to improve the photoinduced interface charge transfer efficiency and interface correlation. DFT calculation indicated that a net charge of about 0.33 e between Ag and tz-BiVO₄ was achieved by extraordinary interface charge transfer, being far larger than that between Ag and ms-BiVO₄. Larger net charge has consequences on mobility of charge carriers of tz-BiVO₄ that can raise the migration and separation of charge carriers for Ag/tz-BiVO₄ heterojunction. Fine interfacial contact between Ag and tz-BiVO₄ led to the optimized photocatalytic performance toward E. coli inactivation, being predominately higher than that of tz-BiVO₄, ms-BiVO₄, and Ag/ms-BiVO₄ catalysts. Besides photocatalytic activity, the thermocatalytic inactivation activity of Ag/tz-BiVO₄ also exhibited a factor of about 7.2 and 3.1 times higher than that of tz-BiVO₄ and Ag/ms-BiVO₄. Trapping and EPR measurements suggested that the structural-dependent photocatalytic activity of Ag/BiVO₄ mainly originated from the pronounced variation of the capability to produce H₂O₂ active species, where the capability of generating H₂O₂ over Ag/tz-BiVO₄ is highly accelerated. Moreover, it cannot be ignored that this study provides an ideal candidate for many aspects, such as environmental and water pollution caused by pathogenic microorganisms and disinfection of medical materials, food packaging, household materials, and public places, etc.

Synergistic effects of multi-active sites in silver modified Bi°-BiVO4 toward efficient reduction of aromatic nitrobenzene

In this work, we report on the preparation of silver nanoparticles modified bismuth/bismuth vanadate (Bi°-BiVO₄) catalyst with multi-active sites toward efficient reduction of aromatic nitrobenzene, aiming to tailor the synergistic effects of multi-active sites and specify the underlying catalytic mechanism. The as-prepared catalysts were characterized by powder X-ray diffraction, scanning electron microscopy, transmission electron microscopy, energy-dispersive X-ray and X-ray photoelectron spectroscopy. It is observed that Ag nanoparticles with diameter of ˜30 nm were anchored evenly on the surface of rod-shaped BiVO₄, which offered multi-active sites to contact with the reactants effectively and transfer interfacial electron to 4-nitrophenol (4-NP) rapidly. The activity factor k of Ag/Bi°-BiVO₄ for 4-NP reduction is estimated to ˜3933.4 min^-1 g^-1, which is much higher than that obtained from pristine BiVO₄ catalyst, Bi° and noble metal Ag nanoparticles. According to the experimental results, the reaction mechanism and reaction path of 4-NP reduction for BiVO₄, Bi and Ag were studied through the density functional theory (DFT) theoretical calculation, which suggested that they exhibit synergistic catalytic effect in the reaction process. This work may provide a feasible foundation for the mechanism research of semiconductor reduction to 4-nitrophenol.

Modification strategies for enhancing the visible light responsive photocatalytic activity of the BiPO4nano-based composite photocatalysts

The present issues related to environmental purification have led to a great need for the development of a superior oxidation process to solve the life-threatening problem. The use of the BiPO₄nanomaterial in photocatalysis is one of the best methods for the treatment of wastewater due to its less harmful nature.

Fabrication of Ag-decorated BiOBr-mBiVO4 dual heterojunction composite with enhanced visible light photocatalytic performance for degradation of malachite green

A visible light active Ag-decorated BiVO₄-BiOBr dual heterojunction photocatalyst was prepared using a facile hydrothermal method, followed by the photodeposition of Ag. The photocatalytic activity of the synthesized samples was investigated by monitoring the change in malachite green (MG) concentration upon visible light irradiation. The synthesized sample was highly effective for the degradation of non-biodegradable MG. The enhanced activity observed was ascribed to the efficient separation and transfer of charge carriers across the dual heterojunction structure as verified by photoluminescence measurements. The removal of MG was primarily initiated by hydroxyl radicals and holes based on scavenger's effect. To gain insight into the degradation mechanism, both high performance liquid chromatography and high resolution-quantitative time of flight, electrospray ionization mass spectrometry measurements during the degradation process were carried out. The degradation primarily followed the hydroxylation and N-demethylation process. A possible reaction pathway is proposed on the basis of all the information obtained under various experimental conditions.

Mechanisms for ·[Formula: see text] and ·OH Production on Flowerlike BiVO4 Photocatalysis Based on Electron Spin Resonance

Many studies have focused on the use of BiVO4 as a photocatalyst, but few have investigated the production of free radicals during the photocatalytic process. Following synthesis of flowerlike BiVO4 and characterization by X-ray diffraction (XRD), Raman spectroscopy, Scanning electron microscopy (SEM) Scanning electron microscopy (EDX), UV-Vis and XPS, we successfully prepared BiVO4. Then we used electron spin resonance (ESR) to determine the production and degradation of individual active free radicals, including the superoxide radical (·[Formula: see text]) and the hydroxyl radical (·OH). In the first experiment, we used ESR to detect the signals of free radicals (·[Formula: see text] and ·OH) under varying oxygen conditions. The results shown that in addition to production by ·[Formula: see text], ·OH could also be produced by oxidation of h+ to OH-. In the next experiment, we detected ·OH under varying pH to identify the result of the first experiment, and found that signal intensities increased with increasing pH, indicating the mechanism for ·OH production. Finally, we conducted a trapping experiment to examine free radical degradation mechanisms. We identified ·OH and h+ as the main active free radicals and showed the complete production about ·OH. These results improve current knowledge of free radical production mechanisms, which can be used to enhance the photocatalytic performance of BiVO4.

Visible-light-induced Ag/BiVO4 semiconductor with enhanced photocatalytic and antibacterial performance

An Ag-loaded BiVO₄ visible-light-driven photocatalyst was synthesized by the microwave hydrothermal method followed by photodeposition. The photocatalytic performance of the synthesized samples was evaluated on a mixed dye (methylene blue and rhodamine B), as well as bisphenol A in aqueous solution. Similarly, the disinfection activities of synthesized samples towards the Gram-negative Escherichia coli (E. coli) in a model cell were investigated under irradiation with visible light (λ ≥ 420 nm). The synthesized samples have monoclinic scheelite structure. Photocatalytic results showed that all Ag-loaded BiVO₄ samples exhibited greater degradation and a higher mineralization rate than the pure BiVO₄, probably due to the presence of surface plasmon absorption that arises due to the loading of Ag on the BiVO₄ surface. The optimum Ag loading of 5 wt% has the highest photocatalytic performance and greatest stability with pseudo-first-order rate constants of 0.031 min^-1 and 0.023 min^-1 for the degradation of methylene blue and rhodamine B respectively in a mixture with an equal volume and concentration of each dye. The photocatalytic degradation of bisphenol A reaches 76.2% with 5 wt% Ag-doped BiVO₄ within 180 min irradiation time. Similarly, the Ag-loaded BiVO₄ could completely inactivate E. coli cells within 30 min under visible light irradiation. The disruption of the cell membrane as well as degradation of protein and DNA exhibited constituted evidence for antibacterial activity towards E. coli. Moreover, the bactericidal mechanisms involved in the photocatalytic disinfection process were systematically investigated.

Visible-enhanced photocatalytic performance of CuWO4/WO3 hetero-structures: incorporation of plasmonic Ag nanostructures

A new plasmonic Ag hybridized CuWO₄/WO₃ heterostructured nanocomposite was successfully synthesized via a ligand-assisted sol gel method and the photocatalytic activity was evaluated by photo-degradation of methylene blue (MB) under visible light irradiation.

A new V-doped Bi2(O,S)3 oxysulfide catalyst for highly efficient catalytic reduction of 2-nitroaniline and organic dyes

A new type of convenient, and environmentally friendly, Vanadium (V)-doped Bi₂(O,S)₃ oxysulfide catalyst with different V contents was successfully synthesized via a simple and facile method. The obtained V-doped Bi₂(O,S)₃ solid solution catalysts were fully characterized by conventional methods. The catalytic performance of the samples was tested by using the reduction of 2-nitroaniline (2-NA) in aqueous solution. The reduction/decolorization of methylene blue (MB) and rhodamine B (RhB) was also chosen to evaluate the universality of catalysts. It was observed that the introduction of V can improve the catalytic performance, and 20%V-Bi₂(O,S)₃ was found to be the optimal V doping concentration for the reduction of 2-NA, MB, and RhB dyes. For comparative purposes, a related V-free Bi₂(O, S)₃ oxysulfide material was synthesized and tested as the catalyst. The superior activity of V-doped Bi₂(O,S)₃ over pure Bi₂(O,S)₃ was ascribed mainly to an increase in active sites of the material and also due to the presence of synergistic effects. The presence of V⁵⁺ as found from XPS analysis may interact with Bi atoms and enhancing the catalytic activity of the sample. In the catalytic reduction of 2-NA, MB and RhB, the obtained V-doped Bi₂(O,S)₃ oxysulfide catalyst exhibited excellent catalytic activity as compared with other reported catalysts. Furthermore this highly efficient, low-cost and easily reusable V-doped Bi₂(O,S)₃ catalyst is anticipated to be of great potential in catalysis in the future.

Synthesis of Bi₂S₃/BiVO₄ Heterojunction with a One-Step Hydrothermal Method Based on pH Control and the Evaluation of Visible-Light Photocatalytic Performance

The band gaps of bismuth vanadate (BiVO₄) and bismuth sulfide (Bi₂S₃) are about 2.40 eV and 1.30 eV, respectively. Although both BiVO₄ and Bi₂S₃ are capable of strong visible light absorption, electron–hole recombination occurs easily. To solve this problem, we designed a one-step hydrothermal method for synthesizing a Bismuth sulfide (Bi₂S₃)/Bismuth vanadate (BiVO₄) heterojunction using polyvinylpyrrolidone K-30 (PVP) as a structure-directing agent, and 2-Amino-3-mercaptopropanoic acid (l-cysteine) as a sulfur source. The pH of the reaction solution was regulated to yield different products: when the pH was 7.5, only monoclinic BiVO₄ was produced (sample 7.5); when the pH was 8.0 or 8.5, both Bi₂S₃ and BiVO₄ were produced (samples 8.0 and 8.5); and when the pH was 9.0, only Bi₂S₃ was produced (sample 9.0). In sample 8.0, Bi₂S₃ and BiVO₄ were closely integrated with each other, with Bi₂S₃ particles formed on the surface of concentric BiVO₄ layers, but the two compounds grew separately in a pH solution of 8.5. Visible-light photocatalytic degradation experiments demonstrated that the degradation efficiency of the Bi₂S₃/BiVO₄ heterojunction was highest when prepared under a pH of 8.0. The initial rhodamine B in the solution (5 mg/L) was completely degraded within three hours. Recycling experiments verified the high stability of Bi₂S₃/BiVO₄. The synthesis method proposed in this paper is expected to enable large-scale and practical use of Bi₂S₃/BiVO₄.