Collaborative influence of morphology tuning and RE (La, Y, and Sm) doping on photocatalytic performance of nanoceria

Tuning morphology and doping additional rare earth (RE) cations are potential techniques to promote the photocatalytic performance of ceria (CeO₂), evaluating the collaborative effects of morphology and RE dopants is significant for producing high active ceria-based catalysts. So in this work, cubic, polyhedral and rod-like nanoceria doped with 10 mol % La (lanthanum), Y (yttrium), or Sm (samarium) were synthesized by a facile template-free hydrothermal method. Phases, morphologies, oxygen vacancies (OVs) concentration, energy band structure, photo-carriers separation/recombination, and photodegradation ratio toward methylene blue (MB) dye of as prepared ceria were studied. Results show that doped CeO₂ maintains a similar morphology structure with un-doped sample and the band gap narrows slightly. Y-doped nanoceria, with an improved separation and a reduced recombination of photo-excited electrons (e^-) and holes (h⁺), owns a higher MB photodegradation ratio than that of samples doping with La or Sm, which is measured as 79.04, 84.43, and 85.59% for Y-doped cubic, polyhedral, and rod-like CeO₂. The collaborative influence of morphology tuning and RE (La, Y, and Sm) doping on photocatalytic performance of nanoceria includes the effects of doped elements and the formation of OVs. The elevation of OVs concentration as well as the separation efficiency of photo-generated e^-/h⁺ are suggested to further enhance the photocatalytic performance of ceria.

Synergistic Effect between Ni and Ce Dual Active Centers Initiated by Activated Fullerene Soot for Electro−Fenton Degradation of Tetracycline

The degradation of a high concentration of organic pollutants has long been a challenge to water restoration, and the development of electro−Fenton catalysis offers a practical approach to solving this problem. In this study, a novel electro−Fenton catalyst, activated fullerene soot−loaded NiO−doped CeO2 (0.4(0.4NiO−CeO2)−AFS) nanoparticles, was prepared through the impregnation of 0.4NiO−CeO2 particles and activated fullerene soot (AFS). When applied for the degradation of 200 mg/L of tetracycline, this catalyst demonstrated a degradation rate as high as 99%. Even after 20 cycles, the degradation rate was more than 80%. Moreover, it was concluded that AFS could initiate the synergistic effect between Ni and Ce dual active centers in the degradation of tetracycline; this can be ascribed to the extremely large specific surface area of AFS.

Insight into the Contributions of Surface Oxygen Vacancies on the Promoted Photocatalytic Property of Nanoceria

Oxygen vacancies (OVs) have critical effects on the photoelectric characterizations and photocatalytic activity of nanoceria, but the contributions of surface OVs on the promoted photocatalytic properties are not clear yet. In this work, we synthesized ceria nanopolyhedron (P-CeO₂), ceria nanocube (C-CeO₂) and ceria nanorod (R-CeO₂), respectively, and annealed them at 600 °C in air, 30%, 60% or pure H₂. After annealing, the surface OVs concentration of ceria elevates with the rising of H₂ concentration. Photocatalytic activity of annealed ceria is promoted with the increasing of surface OVs, the methylene blue photodegradation ratio with pure hydrogen annealed of P-CeO₂, C-CeO₂ or R-CeO₂ is 93.82%, 85.15% and 90.09%, respectively. Band gap of annealed ceria expands first and then tends to narrow slightly with the rising of surface OVs, while the valence band (VB) and conductive band (CB) of annealed ceria changed slightly. Both of photoluminescence spectra and photocurrent results indicate that the separation efficiency of photoinduced electron-hole pairs is significantly enhanced with the increasing of the surface OVs concentration. The notable weakened recombination of photogenerated carrier is suggested to attribute a momentous contribution on the enhanced photocatalytic activity of ceria which contains surface OVs.

Flame Synthesis of Cu/ZnO-CeO2 Catalysts: Synergistic Metal-Support Interactions Promote CH3OH Selectivity in CO2 Hydrogenation

The hydrogenation of CO₂ to CH₃OH is an important reaction for future renewable energy scenarios. Herein, we compare Cu/ZnO, Cu/CeO₂, and Cu/ZnO–CeO₂ catalysts prepared by flame spray pyrolysis. The Cu loading and support composition were varied to understand the role of Cu–ZnO and Cu–CeO₂ interactions. CeO₂ addition improves Cu dispersion with respect to ZnO, owing to stronger Cu–CeO₂ interactions. The ternary Cu/ZnO–CeO₂ catalysts displayed a substantially higher CH₃OH selectivity than binary Cu/CeO₂ and Cu/ZnO catalysts. The high CH₃OH selectivity in comparison with a commercial Cu–ZnO catalyst is also confirmed for Cu/ZnO–CeO₂ catalyst prepared with high Cu loading (∼40 wt %). In situ IR spectroscopy was used to probe metal–support interactions in the reduced catalysts and to gain insight into CO₂ hydrogenation over the Cu–Zn–Ce oxide catalysts. The higher CH₃OH selectivity can be explained by synergistic Cu–CeO₂ and Cu–ZnO interactions. Cu–ZnO interactions promote CO₂ hydrogenation to CH₃OH by Zn-decorated Cu active sites. Cu–CeO₂ interactions inhibit the reverse water–gas shift reaction due to a high formate coverage of Cu and a high rate of hydrogenation of the CO intermediate to CH₃OH. These insights emphasize the potential of fine-tuning metal–support interactions to develop improved Cu-based catalysts for CO₂ hydrogenation to CH₃OH.

Optimal rare-earth (La, Y and Sm) doping conditions and enhanced mechanism for photocatalytic application of ceria nanorods

Morphological tuning or additional cation doping is one of the potential and simple methods to enhance the photocatalytic properties of ceria, in which rare-earth element doped ceria nanorods (CeO₂-RE NRs) are expected to be a promising photocatalyst with high activity. But the optimal doping conditions, including the variety and concentration of RE elements are ambiguous, and the contribution of doped RE ions to the enhancement of photocatalytic activity needs to be further studied. In this work, we doped La, Y and Sm with a wide range of 0%-30% into CeO₂ NRs, and investigated the phase, morphology, band gap, oxygen vacancy concentration, PL spectra and photocatalytic activity variation under different doping conditions. All synthesized CeO₂-RE NRs possessed a good nanorod morphology except the 15 and 30% Y-doped samples. The energy band gaps of the synthesized samples changed slightly; the 10% CeO₂-RE NRs with the narrowest band gaps possessed the higher photocatalytic performance. The most outstanding photocatalyst was found to be the 10% Y-doped CeO₂ NRs with a methylene blue photodegradation ratio of 85.59% and rate constant of 0.0134 min^-1, which is particularly associated with a significant higher oxygen vacancy concentration and obviously lower recombination rate of photogenerated e^-/h⁺ pairs. The doped RE ions and the promotion of oxygen vacancy generation impede the recombination of photogenerated carriers, which is proposed as the main reason to enhance the photocatalytic property of CeO₂.

Monolithic ZnxCe1−xO2 catalysts for catalytic synthesis of dimethyl carbonate from CO2 and methanol

The schematic diagram of reactor module comprised of honeycomb ceramic monolith with the catalysts for the synthesis of DMC.

Rational Design of High Surface Area Mesoporous Ni/CeO2 for Partial Oxidation of Propane

A Ni loaded catalyst on mesoporous ceria, with a large surface area, prepared through the surfactant-assisted precipitation and impregnation method was investigated as an efficient catalyst for propane partial oxidation to produce synthesis gas. The results show that 2.5 wt% Ni/CeO2 had the optimum Ni loading, exhibiting the highest catalytic propane conversion. It also showed excellent stability, with no obvious activity drop after a 10 h time-on-stream reaction and slightly decreased in H2 and CO yields. The investigation of the reactant composition effect on carbon formation showed that by decreasing the C/O2 ratio the content of accumulated carbon decreased and propane conversion increased. The good activity of the Ni/CeO2 can be ascribed to the high surface area and rich surface defects of the ceria support and a high dispersion of active sites (Ni nanoparticles).