Effectively Reinforced α-Bi2O3 MPs/PDA-RGO Sensor for Selective Modality Sensing of a Hazardous Phenolic Compound

The phenolic compound trichlorophenol (TCP) is an ingredient in fungicides and herbicides. This compound's high stability, bioaccumulation, toxicity, and poor biodegradability result in severe environmental and biological health issues. Consequently, it is crucial to have an affordable and sensitive method for detecting TCP in environmental samples. In this study, α-phase bismuth oxide microplates and polydopamine-functionalized reduced graphene oxide (α-Bi2O3 MPs/PDA-RGO) were synthesized using a simple ultrasonic method and characterized with various analytical and physical characterizations. The conversion of the catechol moieties present in the resulting PDA-RGO material into quinones facilitates productive interactions with diverse functional groups, such as hydroxyl, amine, and imine. Consequently, the compounds 2,4,6-trichlorophenol (TCP) engages in electrochemical interactions with the aforementioned functional groups. As a result, TCP shows more excellent selectivity on the designed α-Bi2O3 MPs/PDA-RGO/SPCE sensor. Under the optimized conditions, the sensor demonstrated a lower detection limit (0.0042 μM), a limit of quantification (0.0078 μM), good sensitivity (2.24 μA μM-1 cm2), a wide linear range (0.019-190.7 and 212.7-1649 μM), and pinpoint specificity. The efficacy of the sensor is additionally validated through the accurate identification of TCP residues in water, soil, and food samples.

Phase and Structural Thermal Evolution of Bi-Si-O Catalysts Obtained via Laser Ablation

Laser methods are successfully used to prepare complex functional nanomaterials, especially for biomedicine, optoelectronics, and heterogeneous catalysis. In this paper, we present complex oxide and composite nanomaterials based on Bi and Si produced using laser ablation in liquid followed by subsequent powder annealing. Two synthesis approaches were used, with and without laser post-treatment of mixed (in an atomic ratio of 2:1) laser-generated Bi and Si colloids. A range of methods were used to characterize the samples: UV-Vis diffusion reflection, IR and Raman spectroscopy, synchronous thermal analysis, X-ray diffraction, transmission electron microscopy, as well as specific surface-area evaluation. We also followed the dynamics of phase transformations, as well as composition, structure and morphology of annealed powders up to 800 °C. When heated, the non-irradiated series of samples proceeded from metallic bismuth, through β-Bi₂O₃, and resulted in bismuth silicates of various stoichiometries. At the same time, in their laser-irradiated counterparts, the formation of silicates proceeded immediately from the amorphous Bi₂SiO₅ phase formed after laser treatment of mixed Bi and Si colloids. Finally, we show their ability to decompose persistent organic molecules of Rhodamine B and phenol under irradiation with a soft UV (375 nm) source.

Electrochemical Study of Semiconductor Properties for Bismuth Silicate-Based Photocatalysts Obtained via Hydro-/Solvothermal Approach

Three bismuth silicate-based photocatalysts (composites of Bi₂SiO₅ and Bi₁₂SiO₂₀) prepared via the hydro-/solvothermal approach were studied using electrochemical methods. The characteristic parameters of semiconductors, such as flat band potential, donor density, and mobility of their charge carriers, were obtained and compared with the materials’ photocatalytic activity. An attempt was made to study the effect of solution components on the semiconductor/liquid interface (SLI). In particular, the Mott–Schottky characterization was made in a common model electrolyte (Na₂SO₄) and with the addition of glycerol as a model organic compound for photocatalysis. Thus, a medium close to those in photocatalytic experiments was simulated, at least within the limits allowed by electrochemical measurements. Zeta-potential measurements and electrochemical impedance spectroscopy were used to reveal the processes taking place at the SLI. It was found that the medium in which measurements were carried out dramatically impacted the results. The flat band potential values (E_fb) obtained via the Mott–Schottky technique were shown to differ significantly depending on the solution used in the experiment, which is explained by different processes taking place at the SLI. A strong influence of specific adsorption of commonly used sulfate ions and neutral molecules on the measured values of E_fb was shown.

pH dependent synthesis and characterization of bismuth molybdate nanostructure for photocatalysis degradation of organic pollutants

Bismuth molybdate (Bi₂MoO₆) nanostructures has attracted many researches as an advanced photocalysts for the organic contaminants. In this paper, bismuth molybdate Bi₂MoO₆ nanoparticles were synthesized using a simple hydrothermal method at varied pH (2, 4, 6, 8, and 10) for 15 h at 180 °C. The results reveal the variation pH precursor solutions have a significant impact on the morphology, phase formations, and photocatalytic activity of samples. The synthesized samples at low pH level were characterized by FESEM analysis revealing Bi₂MoO₆ nanoplates have formed while gradually convert to Bi₂MoO₆ spherical nanoparticle at high PH level as shown in energy dispersive X-ray spectroscopy (DES) peaks. The X-ray diffraction patterns reveal characteristic peaks corresponding to mixed phases of Bi₂MoO₆ and cubic Bi₄MoO₉ at high pH value. The optical absorption study exhibit Bi₂MoO₆ nanoplates absorbed visible light with blue shift when compared to the cubic Bi₄MoO₉ structures. Moreover, the photocatalytic activity results revealed that nanoplates in pH = 4 sample has excellent photocatalytic activity for degradation of rhodamine (RhB), methylene orange (MO), and phenol under visible-light irradiation (λ > 400 nm) as well as exhibit the photodegradation 90% of phenol within 300 min.

Yolk–shell structured Bi2SiO5:Yb3+,Ln3+ (Ln = Er, Ho, Tm) upconversion nanophosphors for optical thermometry and solid-state lighting

Bi₂SiO₅:Yb³⁺,Er³⁺ yolk–shell nanophosphors have been successfully synthesized, which are expected to find important applications in optical thermometry and solid-state lighting.