Selective Catalytic Behavior Induced by Crystal-Phase Transformation in Well-Defined Bimetallic Pt-Sn Nanocrystals

The Pt-Sn bimetallic system is a much studied and commercially used catalyst for propane dehydrogenation. The traditionally prepared catalyst, however, suffers from inhomogeneity and phase separation of the active Pt-Sn phase. Colloidal chemistry offers a route for the synthesis of Pt-Sn bimetallic nanoparticles (NPs) in a systematic, well-defined, tailored fashion over conventional methods. Here, the successful synthesis of well-defined ≈2 nm Pt, PtSn, and Pt₃ Sn nanocrystals with distinct crystallographic phases is reported; hexagonal close packing (hcp) PtSn and fcc Pt₃ Sn show different activity and stability depending on the hydrogen-rich or poor environment in the feed. Moreover, face centred cubic (fcc) Pt₃ Sn/Al₂ O₃ , which exhibited the highest stability compared to hcp PtSn, shows a unique phase transformation from an fcc phase to an L1₂ -ordered superlattice. Contrary to PtSn, H₂ cofeeding has no effect on the Pt₃ Sn deactivation rate. The results reveal structural dependency of the probe reaction, propane dehydrogenation, and provide a fundamental understanding of the structure-performance relationship on emerging bimetallic systems.

Carbon Monoxide Tolerant Pt-Based Electrocatalysts for H2-PEMFC Applications: Current Progress and Challenges

The activity degradation of hydrogen-fed proton exchange membrane fuel cells (H2-PEMFCs) in the presence of even trace amounts of carbon monoxide (CO) in the H2 fuel is among the major drawbacks currently hindering their commercialization. Although significant progress has been made, the development of a practical anode electrocatalyst with both high CO tolerance and stability has still not occurred. Currently, efforts are being devoted to Pt-based electrocatalysts, including (i) alloys developed via novel synthesis methods, (ii) Pt combinations with metal oxides, (iii) core–shell structures, and (iv) surface-modified Pt/C catalysts. Additionally, the prospect of substituting the conventional carbon black support with advanced carbonaceous materials or metal oxides and carbides has been widely explored. In the present review, we provide a brief introduction to the fundamental aspects of CO tolerance, followed by a comprehensive presentation and thorough discussion of the recent strategies applied to enhance the CO tolerance and stability of anode electrocatalysts. The aim is to determine the progress made so far, highlight the most promising state-of-the-art CO-tolerant electrocatalysts, and identify the contributions of the novel strategies and the future challenges.

A novel fuel cell design foroperandoenergy-dispersive x-ray absorption measurements

A polymer electrolyte fuel cell has been designed to allowoperandox-ray absorption spectroscopy (XAS) measurements of catalysts. The cell has been developed to operate under standard fuel cell conditions, with elevated temperatures and humidification of the gas-phase reactants, both of which greatly impact the catalyst utilisation. X-ray windows in the endplates of the cell facilitate collection of XAS spectra during fuel cell operation while maintaining good compression in the area of measurement. Results of polarisation curves and cyclic voltammograms showed that theoperandocell performs well as a fuel cell, while also providing XAS data of suitable quality for robust XANES analysis. The cell has produced comparable XAS results when performing a cyclic voltammogram to an establishedin situcell when measuring the Pt LIII edge. Similar trends of Pt oxidation, and reduction of the formed Pt oxide, have been presented with a time resolution of 5 s for each spectrum, paving the way for time-resolved spectral measurements of fuel cell catalysts in a fully-operating fuel cell.

Contrasting the EXAFS obtained under air and H2 environments to reveal details of the surface structure of Pt-Sn nanoparticles

Understanding the surface structure of bimetallic nanoparticles is crucial for heterogeneous catalysis. Although surface contraction has been established in monometallic systems, less is known for bimetallic systems, especially of nanoparticles. In this work, the bond length contraction on the surface of bimetallic nanoparticles is revealed by XAS in H2 at room temperature on dealloyed Pt-Sn nanoparticles, where most Sn atoms were oxidized and segregated to the surface when measured in air. The average Sn-Pt bond length is found to be ∼0.09 Å shorter than observed in the bulk. To ascertain the effect of the Sn location on the decrease of the average bond length, Pt-Sn samples with lower surface-to-bulk Sn ratios than the dealloyed Pt-Sn were studied. The structural information specifically from the surface was extracted from the averaged XAS results using an improved fitting model combining the data measured in H2 and in air. Two samples prepared so as to ensure the absence of Sn in the bulk were also studied in the same fashion. The bond length of surface Sn-Pt and the corresponding coordination number obtained in this study show a nearly linear correlation, the origin of which is discussed and attributed to the poor overlap between the Sn 5p orbitals and the available orbitals of the Pt surface atoms.

Phase Segregated Pt-SnO2 /C Nanohybrids for Highly Efficient Oxygen Reduction Electrocatalysis

Strengthening the interfacial interaction in heterogeneous catalysts can lead to a dramatic improvement in their performance and allow the use of smaller amounts of active noble metal, thus decreasing the cost without compromising their activity. In this work, a facile phase-segregation method is demonstrated for synthesizing platinum-tin oxide hybrids supported on carbon black (PtSnO₂ /C) in situ by air annealing PtSn alloy nanoparticles on carbon black. Compared with a control sample formed by preloading SnO₂ on carbon support followed by deposition of Pt nanoparticles, the phase-segregation-derived PtSnO₂ /C exhibits a more strongly coupled PtSnO₂ interface with lattice overlap of Pt (111) and SnO₂ (200), along with enhanced electron transfer from SnO₂ to Pt. Furthermore, the PtSnO₂ active sites show a strong ability to degrade reactive oxygen species. As a result, the PtSnO₂ /C nanohybrids exhibit both excellent activity and stability as a catalyst for the oxygen reduction reaction, with an overall performance which is superior to both the control sample and commercial Pt/C catalyst. This phase-segregation method can be expected to be applicable in the preparation of other strongly coupled nanohybrids and offers a new route to high-performance heterogeneous catalysts for low-cost energy conversion devices.

Structurally ordered PtSn intermetallic nanoparticles supported on ATO for efficient methanol oxidation reaction

The development of cost-effective methanol oxidation reaction (MOR) catalysts with a high activity and stability is highly desirable for direct methanol fuel cells. In this study, the structurally ordered PtSn intermetallic nanoparticles supported on Sb-doped SnO₂ (ATO) have been successfully synthesized in ethylene glycol (EG) solution at 200 °C. Pt NPs were firstly formed on ATO, followed by the transformation from Pt into hexagonal PtSn on the surface of ATO. The obtained structurally ordered PtSn intermetallic NPs supported on ATO demonstrate significantly enhanced MOR activity and durability in comparison with commercial Pt/C. Our PtSn intermetallic NPs supported on ATO show a MOR activity 4.1 times higher than that of commercial Pt/C catalysts. Accelerated durability tests indicate that the commercial Pt/C catalysts lose about 50% of their initial current density after 500 cycles while the Pt/ATO-200-3 h catalyst loses only about 15% of its initial current density. Our PtSn intermetallic NPs supported on ATO are also found to have higher CO tolerance than commercial Pt/C. This work demonstrates an important strategy to rationally design high-performance structurally ordered Pt-based intermetallic NP catalysts for fuel cells and other applications.

Regioselective generation and reactivity control of subnanometric platinum clusters in zeolites for high-temperature catalysis

Subnanometric metal species (single atoms and clusters) have been demonstrated to be unique compared with their nanoparticulate counterparts. However, the poor stabilization of subnanometric metal species towards sintering at high temperature (>500 °C) under oxidative or reductive reaction conditions limits their catalytic application. Zeolites can serve as an ideal support to stabilize subnanometric metal catalysts, but it is challenging to localize subnanometric metal species on specific sites and modulate their reactivity. We have achieved a very high preference for localization of highly stable subnanometric Pt and PtSn clusters in the sinusoidal channels of purely siliceous MFI zeolite, as revealed by atomically resolved electron microscopy combining high-angle annular dark-field and integrated differential phase contrast imaging techniques. These catalysts show very high stability, selectivity and activity for the industrially important dehydrogenation of propane to form propylene. This stabilization strategy could be extended to other crystalline porous materials.