A multi-stimuli-responsive fluorescence material based on 1,8-naphthalimide

A pair of 1,8-naphthalimides (NPIs) were designed and successfully synthesized through embellishing amino-containing NPI with 4-diethylaminosalicyladehyde and 4-diethylaminobenzaldehyde, respectively. Their structures were fully confirmed by 1H/13C NMR, HR-MS and FT-IR spectroscopic studies. Their photophysical properties were systematically investigated in different solvents of varied polarity, in THF/water mixtures with varying water fractions (fw), and in THF solvent with varying concentrations of NPIs. It inferred that the distinct differences in emission between two NPIs during self-assembled process could be ascribed that the hydroxyl-containing NPI allowed the excited-state intramolecular proton transfer process between -OH and CH=N units in the aggregation state. Interestingly, the solid of 4-diethylaminosalicyladehyde-functionalized NPI exhibited multi-stimuli-responsive fluorescence changes involving mechanofluorochromism and HCl/NH3 vapor stimulus-induced conversion. However, no remarkable change was observed in the photoluminescence (PL) spectra for the solid of 4-diethylaminobenzaldehyde-functionalized NPI under the stimuli of mechanical force and organic solvent.

α-Cyanostilbene-based Molecule with the Synergistical Mechanisms of AIE, ESIPT and TICT: A New Schiff Base Probe for Selective Detection of Fe3+ and Reversible Response to HCl/NH3 Vapor

We designed and synthesized a new Schiff base probe, which incorporated the salicylaldehyde-analogue α-cyanostilbene and benzophenone hydrazone by the imine linkage. Its chemical structure was verified by FT-IR, MALDI-TOF-MS, HR-MS and 1H/13C NMR technologies. It could exhibit a red fluorescence based on the synergistical effects of aggregation-induce emission (AIE), excited-state intramolecular proton transfer (ESIPT) and twisted intramolecular charge-transfer (TICT) in the aggregation or solid states. Interestingly, the TLC-based test strip loaded with the target compound showed the reversible fluorescence response to amine/acid vapor and on-site visual fluorescence quenching response to Fe3+. In THF/water mixtures (fw = 90%, 10 µM, pH = 7.4), the detection limit (DL) and the binding constant (Ka) of the developed probe towards Fe3+ were evaluated as 5.50 × 10- 8 M and 1.69 × 105, respectively. The developed probe was successfully applied for the detection of Fe3+ with practical, reliable, and satisfying results.

Development and Validation of a Fluorogenic Probe for Lysosomal Zinc Release

Zinc homeostasis, which allows optimal zinc utilization in diverse life processes, is responsible for the general well-being of human beings. This paper describes developing and validating an easily accessible indole-containing zinc-specific probe in the cellular milieu. The probe was synthesized from readily available starting materials and was subjected to steady-state fluorescence studies. It showed selective sensing behavior towards Zn2+ with reversible binding. The suppression of PET (Photoinduced Electron Transfer) and ESIPT (Excited State Intramolecular Proton Transfer) elicited selectivity, and the detection limit was 0.63 μM (LOQ 6.8 μM). The zinc sensing capability of the probe was also screened in the presence of low molecular weight ligands [LMWLs] and showed interference only with GSH and ATP. It is non-toxic and can detect zinc in different cell lines under various stress conditions such as inflammation, hyperglycemia, and apoptosis. The probe could stain the early and late stages of apoptosis in PAN-2 cells by monitoring the zinc release. Most experiments were conducted without external zinc supplementation, showing its innate ability to detect zinc.

Naphthaldehyde-Based Schiff Base Chemosensor for the Dual Sensing of Cu2+ and Ni2+ Ions

In this study, a simple Schiff base sensor 1-(((4-nitrophenyl)imino)methyl)naphthalen-2-ol(NNM) has been used for chemosensing of metal ions. The metal sensing properties of sensor NNM have been investigated using UV-visible and fluorescence spectroscopic approaches. The spectral investigations revealed a red shift in absorption spectra and quenching in the emission band of the ligand molecule in the presence of Cu2+ and Ni2+ ions. The binding stoichiometry of sensor NNM for the analyte (Cu2+ and Ni2+ ions) has been investigated by the Job's plot analysis and found to be 1:1 (NNM:Analyte). The data of the Benesi-Hildebrand plot demonstrated that NNM detected Cu2+ and Ni2+ ions in nanomolar quantity. The binding insights among NNM and analytes (Cu2+ and Ni2+ ions) have been confirmed by shifted IR signals. Moreover, the reusabilty of the sensor has been investigated using an EDTA solution. In addition, the sensor NNM also successfully applied to real water samples for the identification and measurement of Cu2+ and Ni2+ ions. Hence, this system could be highly applicable in environmental and biological applications.

Chromone functionalized pyridine chemosensor for cupric ions detection

A new Schiff base 2-ethoxy-3-{[(6-{[(2-ethoxy-4-hydroxy-2H-chromen-3-yl)methylidene]amino}pyridine-2-yl)imino]methyl}-2H-chromen-4-ol (CD) was synthesized as a result of the condensation of 2,6-diaminopyridine and 3-formyl chromone in 1:2 M ratio and used for cupric ions detection and characterized through FTIR, HRMS and ¹H NMR spectral techniques. The sensing capability of Schiff base for cupric ions as compared to other transition metal ions was examined by absorbance and emission studies. A considerable decrease in emission intensity appeared in Schiff base in the case of cupric ions while irrelevant changes were examined for the rest of the ions. The binding stoichiometry was obtained as 1:2 for CD: Cu²⁺ complex intended from the job's plot which was confirmed through HRMS spectral technique. DFT calculations were carried for the confirmation of structural relationships and absorption-emission data. The Regression coefficient, Limit of detection, and Association constant were obtained as 98.7%, 1.2 × 10^-6 M, and 3.26 × 10⁴ M^-1 respectively using Benesi-Hildebrand (B-H) equation. The sensing power of Schiff base CD to recognize cupric ions was unaltered by the addition of the rest of metal ions, which was authenticated through interference studies. Schiff base CD and its complex with cupric ions were found stable over an extensive time period as revealed by time-reliant studies. The data collected by pH studies revealed that the preferred pH range for detecting cupric ions by Schiff base CD was 6 to 11. The Schiff base was finally utilized for sensing cupric ions in a variety of spiked samples of water like canal water, tap water, groundwater, distilled water.

Fluorescent Sensors for Hg2+ and Cu2+ Based on Condensation Products of 4H-1,2,4 Triazole-4-Amine and Carboxylated Benzoic Acids

Mercury (Hg) causes serious health issues in its all forms. Deficiency as well as excess of copper ion (Cu²⁺) in human body is hazardous. A series of four compounds have been derived from carboxylated benzoic acids (benzoic acid, isophthalic acid, terephthalic acid and phthalic acid) and 4H-1,2,4 triazole-4-amine and characterized. Fluorescence detection of Hg²⁺ was recorded by the derivates with benzoic acid and isophthalic acid while the derivatives of terephthalic acid and phthalic acid detect Cu²⁺ by fluorescence "off" mode. Metal ions like Li⁺, Na⁺, K⁺, Zn²⁺, Al³⁺, Mg²⁺, Mn²⁺, Co²⁺, Ni²⁺, Cu²⁺, Cd²⁺, Pb²⁺ and Hg²⁺ found not to interfere. The stoichiometry of binding is 1:1 for the benzoic acid derivative with Hg²⁺ while it is 1:2 for the other three derivatives. The binding constants are ca. 10^-4.5 between the sensors and Hg²⁺ or Cu²⁺ and detection limits are around 10^-5.5 M. DFT calculation provided optimized geometries of the sensors and confirmed the stoichiometry of binding with Hg²⁺/Cu²⁺.

Condensation Product of p-anisaldehyde and L-phenylalanine: Fluorescent "on-off" Sensor for Cu2+ and IMPLICATION Logic Gate

(Z)-2-(4-methoxybenzylideneamino)-3-phenylpropanoic acid (L) synthesized by condensation of p-anisaldehyde and L-phenylalanine acts as selective fluorescent as well as voltammetric sensor for Cu²⁺ in 2:1 (v/v) CH₃OH:H₂O. The fluorescence intensity of L (λ_max 425 nm) is quenched ca. 65% by Cu²⁺. Metal ions - Li⁺, Na⁺, K⁺, Al³⁺, Cu²⁺, Zn²⁺, Cd²⁺, Hg²⁺, Mn²⁺, Ni²⁺ and Pb²⁺ do not interfere. The binding constant and the detection limits were calculated to be 0.56 × 10² M^-1 and 10^-6 M respectively. DFT and TDDFT calculations confirmed 2:1 binding stoichiometry between L and Cu²⁺ obtained from fluorescence data. The interaction between L and Cu²⁺ is reversible for many cycles with respect to ethylenediamine tetraacetate anion (EDTA^2-) which results in IMPLICATION logic gate.

Al3+ triggered aggregation induced emission of an anthracence based azine derivative in SDS medium

Single crystal X-ray structurally characterized anthracene appended unsymmetrical azine derivative, viz. 4-(anthracen-9-ylmethylene-hydrazonomethyl)-2-methoxy-phenol (L5) shows Al³⁺ assisted aggregation induced emission in SDS medium.

A novel fluoro-chromogenic Cu2+ probe for living-cell imaging based on rhodamine 6G-pyridine conjugation

A novel fluoro-chromogenic rhodamine spirolactam probe (RP) has been prepared through the condensation of rhodamine hydrazine and 2-acetylpyridine, which displayed the detection of Cu²⁺ with high selectivity over a large number of other common metal ions. It shows a "turn-on" response to paramagnetic Cu²⁺ with an about 12-fold enhancement, and a color change from colorless to red that is observable by the naked eye. These changes are ascribed to the ring-opening of the spirolactam in RP, and subsequent host-guest coordination. The 2:1 binding stoichiometry of RP to Cu²⁺ was confirmed by Job's and B-H plots. The resulting fluorescence enhancement can be used to detect Cu²⁺ at concentrations from 2.0 to 20.0 μM with a limit of detection of 0.21 μM, which was lower than the maximum allowable Cu²⁺ level set by the WHO. Finally, RP has been utilized to monitor Cu²⁺ in living cells and natural water. Graphical abstract.

Integrated optical and electrochemical detection of Cu2+ ions in water using a sandwich amino acid-gold nanoparticle-based nano-biosensor consisting of a transparent-conductive platform

In this paper, an optical-electrochemical nano-biosensor was introduced for measuring Cu2+ ion concentrations in water. A multi-step procedure was used to fabricate the transparent-conductive biosensor platform consisting of an l-cysteine-gold nanoparticle-based sandwich structure. First, colloidal gold nanoparticles (GNPs) were synthesized according to the Turkevich-Frens method with some modifications and then functionalized with l-cysteine molecules (GNP/l-cys). Then, cyclic voltammetry was preformed in buffered solutions containing HAuCl4·3H2O for gold nanoparticle electrodeposition on cleaned ITO glasses. The GNP-electrodeposited ITO glasses (ITO/GNPs) were thermally treated in air atmosphere for 1 hour at a temperature of 300 °C. Following the procedure, the gold nanoparticles on ITO/GNPs substrates were functionalized with l-cysteine to prepare ITO/GNPs/l-cys substrates. Finally, the sandwich-type substrates of ITO/GNPs/l-cys⋯Cu2+⋯l-cys/GNPs were fabricated by accumulation of Cu2+ ions using an open circuit technique performed in copper ion buffer solutions in the presence of previously produced colloidal GNP/l-cys nanoparticles. The effective parameters including GNP/l-cys solution volume, pre-concentration pH and pre-concentration time on the LSPR and SWV responses were investigated and optimized. The fabricated transparent-conductive platforms were successfully assessed as a nano-biosensor for detection of copper ions using two different methods of square wave voltammetry (SWV) and localized surface plasmon resonance (LSPR). As a result, the proposed biosensor showed a high sensitivity, selectivity and a wide detectable concentration range to copper ions. The total linear range and the limit of detection (LOD) of the nano-biosensor were 10-100 000 nM (0.6-6354.6 ppb) and below 5 nM (0.3 ppb), respectively. The results demonstrated the potential of combining two different optical and electrochemical methods for quantitation of the single analyte on the same biosensor platform and obtaining richer data. Also, these results indicated that the developed LSPR-SWV biosensor was superior to many other copper biosensors presented in the literature in terms of linear range and LOD. The developed nano-biosensor was successfully applied in the determination of trace Cu2+ concentration in actual tap water samples.