Cage Match: Comparing the Anion Binding Ability of Isostructural Versus Isofunctional Pairs of Metal-Organic Nanocages

Affinities of six anions (mesylate, acetate, trifluoroacetate, p-toluenecarboxylate, p-toluenesulfonate, and perfluorooctanoate) for three related Pt2+ -linked porphyrin nanocages were measured to probe the influence of different noncovalent recognition motifs (e. g., hydrogen bonding, electrostatics, π bonding) on anion binding. Two new hosts of M6 L3 12+ (1b) and M4 L2 8+ (2) composition (M=(en)Pt2+ , L=(3-py)4 porphyrin) were prepared in a one-pot synthesis and allowed comparison of hosts that differ in structure while maintaining similar N-H hydrogen-bond donor ability. Comparisons of isostructural hosts that differ in hydrogen-bonding ability were made between 1b and a related M6 L3 12+ nanoprism (1a, M=(tmeda)Pt2+ ) that lacks N-H groups. Considerable variation in association constants (K1 =1.6×103  M-1 to 1.3×108  M-1 ) and binding mode (exo vs. endo) were found for different host-guest combinations. Strongest binding was seen between p-toluenecarboxylate and 1b, but surprisingly, association of this guest with 1a was only slightly weaker despite the absence of NH⋅⋅⋅O interactions. The high affinity between p-toluenecarboxylate and 1a could be turned off by protonation, and this behavior was used to toggle between the binding of this guest and the environmental pollutant perfluorooctanoate, which otherwise has a lower affinity for the host.

Pyrene-Containing Polyamines as Fluorescent Receptors for Recognition of PFOA in Aqueous Media

The globally widespread perfluorooctanoic acid (PFOA) is a concerning environmental contaminant, with a possible toxic long-term effects on the environment and human health The development of sensible, rapid, and low-cost detection systems is a current change in modern environmental chemistry. In this context, two triamine-based chemosensors, L1 and L2, containing a fluorescent pyrene unit, and their Zn(II) complexes are proposed as fluorescent probes for the detection of PFOA in aqueous media. Binding studies carried out by means of fluorescence and NMR titrations highlight that protonated forms of the receptors can interact with the carboxylate group of PFOA, thanks to salt bridge formation with the ammonium groups of the aliphatic chain. This interaction induces a decrease in the fluorescence emission of pyrene at neutral and slightly acidic pH values. Similarly, emission quenching has also been observed upon coordination of PFOA by the Zn(II) complexes of the receptors. These results evidence that simple polyamine-based molecular receptors can be employed for the optical recognition of harmful pollutant molecules, such as PFOA, in aqueous media.

Porphyrin-based colorimetric sensing of perfluorooctanoic acid as proof of concept for perfluoroalkyl substance detection

A functionalized porphyrin receptor was prepared to bind perfluorooctanoic acid. UV-Vis spectroscopic analysis showed the receptor gave a rapid colorimetric response that could also be detected visually at environmentally relevant concentrations. Spiked soil samples were used to demonstrate detection of perfluorooctanoic acid without intensive sample pre-treatment or laboratory instrument analysis.

Extraction of PFOA from dilute wastewater using ionic liquids that are dissolved in N-octanol

Polyfluoroalkyl Substances (PFAS) such as perfluorooctanoic acid (PFOA) are resistant to biodegradation leading to adverse health outcomes. Therefore, PFAS removal from drinking water is paramount. Liquid-liquid extraction processes can remove them from water; however, the hydrophobic and oleophobic properties of PFOA lead to the low extraction efficiency and severe emulsification, especially for the ppm-levels concentration of PFOA. Therefore, we introduced ionic liquid (IL) methyltrioctylammonium bis(trifluoromethylsulfonyl)imide ([A336][NTf₂]) as extractant into octanol. We found that using hexadecyl trimethyl ammonium bromide (CTAB) as an extractant caused severe and stable emulsion. In comparison, [A336][NTf₂] could suppress the emulsification with high extraction efficiency. The extraction performance of PFOA was examined as a function of various parameters. The results showed that the extraction efficiency was strongly dependent on the concentration of IL and aqueous pH. Further research revealed the extraction mechanisms at the molecular-level, and density functional theory (DFT) and molecular dynamic (MD) simulation agreed with the trends in the experiment. We determined that the extraction efficiency of PFOA from water could be up to 88.21 wt% for the optimized condition, indicating that the extraction system of [A336][NTf₂] + octanol was efficient for separating PFOA from the diluted aqueous solution.

Rapid and Efficient Removal of Perfluorooctanoic Acid from Water with Fluorine-Rich Calixarene-Based Porous Polymers

On account of its nonbiodegradable nature and persistence in the environment, perfluorooctanoic acid (PFOA) accumulates in water resources and poses serious environmental issues in many parts of the world. Here, we present the development of two fluorine-rich calix[4]arene-based porous polymers, FCX4-P and FCX4-BP, and demonstrate their utility for the efficient removal of PFOA from water. These materials featured Brunauer-Emmett-Teller (BET) surface areas of up to 450 m² g^-1, which is slightly lower than their nonfluorinated counterparts (up to 596 m² g^-1). FCX4-P removes PFOA at environmentally relevant concentrations with a high rate constant of 3.80 g mg^-1 h^-1 and reached an exceptional maximum PFOA uptake capacity of 188.7 mg g^-1. In addition, it could be regenerated by simple methanol wash and reused without a significant decrease in performance.

Guanidinocalix[5]arene for sensitive fluorescence detection and magnetic removal of perfluorinated pollutants

Perfluorinated alkyl substances, such as perfluorooctane sulfonate (PFOS) and perfluorooctanoic acid (PFOA), are toxic materials that are known to globally contaminate water, air, and soil resources. Strategies for the simultaneous detection and removal of these compounds are desired to address this emerging health and environmental issue. Herein, we develop a type of guanidinocalix[5]arene that can selectively and strongly bind to PFOS and PFOA, which we use to demonstrate the sensitive and quantitative detection of these compounds in contaminated water through a fluorescent indicator displacement assay. Moreover, by co-assembling iron oxide nanoparticle with the amphiphilic guanidinocalix[5]arene, we are able to use simple magnetic absorption and filtration to efficiently remove PFOS and PFOA from contaminated water. This supramolecular approach that uses both molecular recognition and self-assembly of macrocyclic amphiphiles is promising for the detection and remediation of water pollution.