Synergistic effects of the hybridization between boron-doped carbon quantum dots and n/n-type g-C3N4 homojunction for boosted visible-light photocatalytic activity

Dye wastewater has raised a prevalent environmental concern due to its ability to prevent the penetration of sunlight through water, thereby causing a disruption to the aquatic ecosystem. Carbon quantum dots (CQDs) are particularly sought after for their highly tailorable photoelectrochemical and optical properties. Simultaneously, graphitic carbon nitride (g-C₃N₄) has gained widespread attention due to its suitable band gap energy as well as excellent chemical and thermal stabilities. Herein, a novel boron-doped CQD (BCQD)-hybridized g-C₃N₄ homojunction (CN) nanocomposite was fabricated via a facile hydrothermal route. The optimal photocatalyst sample, 1-BCQD/CN (with a 1:3 mass ratio of boron to CQD) accomplished a Rhodamine B (RhB, 10 mg/L) degradation efficiency of 96.8% within 4 h under an 18 W LED light irradiation. The kinetic rate constant of 1.39 × 10^-2 min^-1 achieved by the optimum sample was found to be 3.6- and 2.8-folds higher than that of pristine CN and un-doped CQD/CN, respectively. The surface morphology, crystalline structure, chemical composition and optical properties of photocatalyst samples were characterized via TEM, FESEM-EDX, XRD, FTIR, UV-Vis DRS and FL spectrometer. Based on the scavenging tests, it was revealed that the photogenerated holes (h⁺), superoxide anions (∙O₂^-) and hydroxyl radicals (∙OH) were the primary reactive species responsible for the photodegradation process. Overall, the highly efficient 1-BCQD/CN composite with excellent photocatalytic activity could provide a cost-effective and robust means to address the increasing concerns over global environmental pollution.

Broccoli-liked silver phosphate nanoparticles supported on green nanofiber membrane for visible-light driven photodegradation towards water pollutants

In view of the practical application, it is imperative to develop efficient, exercisable, and visible light driven water pollution treatment materials. Herein, a high-efficiency green photocatalytic membrane for water pollution treatment is proposed and fabricated conveniently. Firstly, silver phosphate (Ag₃PO₄) nanoparticles with controlled morphology were prepared by simple liquid-phase precipitation method, and then a hierarchical structured Ag₃PO₄@polylactic acid (PLA) composite nanofiber membrane was prepared by electrospinning. Using electrospun PLA nanofiber membrane as a carrier of photocatalysts can significantly improve the dispersion of Ag₃PO₄nanoparticles, and increase the contact probability with pollutants and photocatalytic activity. The prepared PLA@Ag₃PO₄composite membrane was used to degrade methylene blue (MB) and tetracycline hydrochloride (TC) under visible light irradiation. The results showed that the removal ratio of pollutants on Ag₃PO₄@PLA composite nanofiber membrane was 94.0% for MB and 82.0% for TC, demonstrating an outstanding photocatalytic activity of composite membrane. Moreover, the PLA nanofiber membrane is a self-supported and biodegradable matrix. After five cycles, it can still achieve 88.0% of the initial photocatalytic degradation rate towards MB, showing excellent recyclability. Thus, this composite nanofiber membrane is a high-efficiency and environmental-friendly visible light driven water pollution treatment material that could be used in real applications.

Fabrication of silver phosphate-ilmenite nanocomposites supported on glycol chitosan for visible light-driven degradation, and antimicrobial activities

Recently, photo-degradation process under ultraviolet-light irradiation is being used as a substantial treatment method for the removal of environmental pollution. In this study, a silver phosphate-ilmenite (Ag₃PO₄-FeTiO₃) hetero structure supported on glycol chitosan catalyst was completely prepared, also, and its structural, and optical properties were characterized. Meantime, scanning electron microscopy, X-ray diffraction, X-ray photoelectron, and UV-vis spectra were applied. The Ag₃PO₄-FeTiO₃/glycol chitosan catalyst was used to degrade metronidazole under visible-light irradiation. The degradation rate of metronidazole in 25 min by Ag₃PO₄-FeTiO₃/glycol chitosan nanocomposites was found to be 99.2% under UV light irradiation, which was higher than that by Ag₃PO₄-FeTiO₃ (72.24%) and FeTiO₃ (35.5%), respectively. The active species trapping test of Ag₃PO₄-FeTiO₃/glycol chitosan indicated that ·OH and ·O₂^- participated during the reaction. The diffusion method was evaluated to appraise the bactericidal activity of the synthesized nanomaterials when tested against both Staphylococcus aureus and Escherichia coli bacteria, with or without LED-light irradiation. The antibacterial tests show higher inhibition zones under light illumination as compared to dark conditions. The antifungal properties of the prepared nanomaterials were analyzed by fungi (Aspergillus niger, and Fusarium solani) using disc diffusion analysis. It was confirmed that the prepared nanomaterials have the best antifungal agent as compared to the standard antibiotics. When the Ag₃PO₄-FeTiO₃/glycol chitosan was used, the amount of inhibition zone was enhanced.

Electro-optic imaging enables efficient wide-field fluorescence lifetime microscopy

Nanosecond temporal resolution enables new methods for wide-field imaging like time-of-flight, gated detection, and fluorescence lifetime. The optical efficiency of existing approaches, however, presents challenges for low-light applications common to fluorescence microscopy and single-molecule imaging. We demonstrate the use of Pockels cells for wide-field image gating with nanosecond temporal resolution and high photon collection efficiency. Two temporal frames are obtained by combining a Pockels cell with a pair of polarizing beam-splitters. We show multi-label fluorescence lifetime imaging microscopy (FLIM), single-molecule lifetime spectroscopy, and fast single-frame FLIM at the camera frame rate with 10³–10⁵ times higher throughput than single photon counting. Finally, we demonstrate a space-to-time image multiplexer using a re-imaging optical cavity with a tilted mirror to extend the Pockels cell technique to multiple temporal frames. These methods enable nanosecond imaging with standard optical systems and sensors, opening a new temporal dimension for wide-field low-light microscopy.

Nanosecond imaging techniques, such as fluorescence lifetime imaging microscopy (FLIM), are limited by low efficiency of current detectors. Here, the authors implement an electro-optic approach using Pockels cells for wide-field image gating and demonstrate high throughput FLIM on standard camera sensors.

From Cubes to Dice: Solvent-Regulated Morphology Engineering of Endohedral Fullerene Microcrystals with Anomalous Photoluminescence Enhancement

Despite recent successes in preparing three-dimensional crystals of empty fullerenes, such as C₆₀ and C₇₀ , 3D endohedral fullerene crystals, and especially hollow nanostructures, have been scarcely reported. A universal approach has now been developed to prepare shape-tunable 3D crystals of several metal nitride clusterfullerenes, including cubes and dice (hollow cubes with holes at the center of each face), which can be readily switched by changing the volume ratio of good (mesitylene) and poor (isopropanol) solvents. Synchrotron-based soft X-ray nano-computed tomography was used to unambiguously identify the interior microstructure of the dice-shaped crystals of Tb₃ N@C₈₀ , and especially the depth of the hole at each face, confirming that the dice has a solid center and the holes are not interconnected. Owing to the enhanced light absorption, the dice-shaped crystals exhibit enhanced photoluminescence relative to that of the cubes.

Mechanistic Insights into Photodegradation of Organic Dyes Using Heterostructure Photocatalysts

Due to its low cost, environmentally friendly process, and lack of secondary contamination, the photodegradation of dyes is regarded as a promising technology for industrial wastewater treatment. This technology demonstrates the light-enhanced generation of charge carriers and reactive radicals that non-selectively degrade various organic dyes into water, CO2, and other organic compounds via direct photodegradation or a sensitization-mediated degradation process. The overall efficiency of the photocatalysis system is closely dependent upon operational parameters that govern the adsorption and photodegradation of dye molecules, including the initial dye concentration, pH of the solution, temperature of the reaction medium, and light intensity. Additionally, the charge-carrier properties of the photocatalyst strongly affect the generation of reactive species in the heterogeneous photodegradation and thereby dictate the photodegradation efficiency. Herein, this comprehensive review discusses the pseudo kinetics and mechanisms of the photodegradation reactions. The operational factors affecting the photodegradation of either cationic or anionic dye molecules, as well as the charge-carrier properties of the photocatalyst, are also fully explored. By further analyzing past works to clarify key active species for photodegradation reactions and optimal conditions, this review provides helpful guidelines that can be applied to foster the development of efficient photodegradation systems.