Microfluidic in-line dynamic light scattering with a commercial fibre optic system

We report the coupling of dynamic light scattering (DLS) in microfluidics, using a contact-free fibre-optic system, enabling the under-flow characterisation of a range of solutions, dispersions, and structured fluids. The system is evaluated and validated with model systems, specifically micellar and (dilute) polymer solutions, and colloidal dispersions of different radii (∼1-100 nm). A systematic method of flow-DLS analysis is examined as a function of flow velocity (0-16 cm s^-1), and considerations of the relative contribution of 'transit' and 'Brownian' terms enable the identification of regions where (i) a quiescent approximation suffices, (ii) the flow-DLS framework holds, as well as (iii) where deviations are found, until eventually (iv) the convection dominates. We investigate practically relevant, robust setups, namely that of a capillary connected to microdevice, as well as direct measurement on a glass microdevice, examining the role of capillary dimensions and challenges of optical alignment. We conclude with a demonstration of a continuous flow measurement of a binary surfactant/salt solution, whose micellar dimensions vary with composition, characterised with hundreds of data points (every ∼5 s) and adequate statistics, within a few minutes.

A Novel Hydrate Form of Sodium Dodecyl Sulfate and Its Crystallization Process

A novel hydrate form of sodium dodecyl sulfate (SDS) was firstly discovered through a hydrate screening with the use of organic solvents, while SDS is generally prepared solely in aqueous media. Surprisingly, a novel SDS hydrate form with needle-shaped crystals produced by adding acetonitrile to a 20 wt % SDS aqueous solution at a ratio of 3:1 (v/v) and further cooling to around 5 °C could be found with a trace amount in one of the two purchased SDS products that we examined. After comprehensive solid-state characterizations by powder X-ray diffraction (PXRD), thermogravimetric analysis (TGA), Fourier transform infrared (FTIR), Raman spectroscopy, dynamic vapor sorption (DVS), and elemental analysis (EA), it is also successfully made directly from the synthesis of SDS through esterification and saponification. Four times the equal proportion of acetone was added into the reaction solution at an interval of 5 min to separate the side product, sodium sulfate, from the mother liquor. The desired novel hydrate form of SDS was then obtained by cooling the filtered mother liquor to 5 °C and aged for 8 h for a preferential growth.