The construction of a heterostructured RGO/g-C3N4/LaCO3OH composite with enhanced visible light photocatalytic activity for MO degradation

The construction of a heterojunction and the introduction of a cocatalyst can both promote the transfer of photogenerated electrons, which are effective strategies to enhance photocatalytic efficiency. In this paper, a ternary RGO/g-C₃N₄/LaCO₃OH composite was synthesized by constructing a g-C₃N₄/LaCO₃OH heterojunction and introducing a non-noble metal cocatalyst RGO through hydrothermal reactions. TEM, XRD, XPS, UV-vis diffuse reflectance spectroscopy, photo-electrochemistry and PL tests were carried out to characterize the structures, morphologies and carrier separation efficiencies of products. Benefiting from the boosted visible light absorption capability, reduced charge transfer resistance and facilitated photogenerated carrier separation, the visible light photocatalytic activity of the ternary RGO/g-C₃N₄/LaCO₃OH composite was effectively improved, resulting in a much increased MO (methyl orange) degradation rate of 0.0326 min^-1 compared with LaCO₃OH (0.0003 min^-1) and g-C₃N₄ (0.0083 min^-1). Moreover, by combining the results of the active species trapping experiment with the bandgap structure of each component, the mechanism of the MO photodegradation process was proposed.

Optically Active TiO2:Er Thin Films Deposited by Magnetron Sputtering

Titanium dioxide photoanodes for hydrogen generation suffer from a profound mismatch between the optical absorption of TiO₂ and the solar spectrum. To solve the problem of low solar-to-chemical efficiency, optically active materials are proposed. In this work, TiO₂ thin films containing erbium were deposited by radio frequency RF magnetron sputtering under ultrahigh vacuum conditions UHV. Morphology, structural, optical and electronic properties were studied. TiO₂:Er thin films are homogenous, with uniform distribution of Er ions and high transparency over the visible VIS range of the light spectrum. However, a profound 0.4 eV blue shift of the fundamental absorption edge with respect to undoped TiO₂ was observed, which can be attributed either to the size effect due to amorphization of TiO₂ host or to the onset of precipitation of Er₂Ti₂O₇ nanocrystals. Near-infrared NIR to VIS up-conversion is demonstrated upon excitation at 980 nm, while strong green photoluminescence at 525 and 550 nm occurs upon photon absorption at 488 nm.

A facile aqueous synthesis strategy for hexagonal phase NaGdF4 nanorods

A facile aqueous synthesis method is explored to synthesize hydrophilic β-NaGdF₄ nanorods at 60 °C.

In situ growth of CuS nanoparticles on g-C3N4 nanosheets for H2 production and the degradation of organic pollutant under visible-light irradiation

The solar-to-fuel conversion using a photocatalyst is an ideal method to solve the energy crisis and global warming. In this contribution, photocatalytic H₂ production and organic pollutant removal using g-C₃N₄/CuS composite was demonstrated. Well dispersed CuS nanoparticles (NPs) with a size of about 10 nm were successfully grown on the surface of g-C₃N₄ nanosheet via a facile hydrothermal method. The as-prepared g-C₃N₄/CuS nanocomposite at an optimized loading exhibited a much higher visible light photoactivity, giving up to 2.7 times and 1.5 times enhancements in comparison to pure g-C₃N₄ for photocatalytic H₂ production and methylene orange (MO) degradation, respectively. These enhanced photocatalytic activities are attributed to the interfacial transfer of photogenerated electrons and holes between g-C₃N₄ and CuS, which leads to effective charge separation on both parts. That is, under the visible light irradiation, electrons in the valence band (VB) of g-C₃N₄ can directly transfer to the CuS NPs, which can act as an electron sink and co-catalyst to promote the separation and transfer of photo-generated electrons, thus significantly improving the photocatalytic efficiency.

A novel ternary g-C₃N₄/CuS photocatalyst shows a good photocatalytic H₂ production and methylene orange degradation under visible light.

Visible-to-NIR Photon Harvesting: Progressive Engineering of Catalysts for Solar-Powered Environmental Purification and Fuel Production

Utilization of diffusive solar energy through photocatalytic processes for environmental purification and fuel production has long been pursued. However, efficient capture of visible-near-infrared (NIR) photons, especially for those with wavelengths longer than 600 nm, is a demanding quest in photocatalysis owing to their relatively low energy. In recent years, benefiting from the advances in photoactive material design, photocatalytic reaction system optimization, and new emerging mechanisms for long-wavelength photon activation, increasing numbers of studies on the harnessing of visible-NIR light for solar-to-chemical energy conversion have been reported. Here, the aim is to comprehensively summarize the progress in this area. The main strategies of the long-wavelength visible-NIR photon capture and the explicitly engineered material systems, i.e., narrow optical gap, photosensitizers, upconversion, and photothermal materials, are elaborated. In addition, the advances in long-wavelength light-driven photo- and photothermal-catalytic environmental remediation and fuel production are discussed. It is anticipated that this review presents the forefront achievements in visible-NIR photon capture and at the same time promotes the development of novel visible-NIR photon harnessing catalysts toward efficient solar energy utilization.

Large-scale synthesis and luminescence of GdPO4 hollow microspheres

GdPO₄ hollow microspheres were synthesized by using a novel multi-step route for the first time with polystyrene (PS) spheres as the template, followed by the combination of a facile homogeneous precipitation method, an ion-exchange process, and a calcination process.