Immobilization of Bio-imprinted Phospholipase D and Its Catalytic Behavior for Transphosphatidylation in the Biphasic System

Phospholipase D (PLD) with the higher transphosphatidylation activity was screened from Streptomyces sp. LD0501 basing on the protoplast mutagenesis technology. Then, it was successfully bio-imprinted to form a hyperactivated structure and rigidified by the intramolecular cross-linking, which was immobilized on the nonporous nanoscale silica. Characterization techniques were employed to investigate the structure and physicochemical properties of the catalysts, including Fourier transform infrared (FTIR) spectra and scanning electron microscopy (SEM) analysis. Transphosphatidylation activity and selectivity were improved significantly when immobilized PLD was used. The maximum yield for the production of phosphatidylserine (PS) reached 97% and the side reaction, the hydrolysis, was minimized. These results were further confirmed by the nuclear magnetic resonance (NMR) and mass spectrometry (MS) analysis. The imprint-induced characteristics of PLD was successfully "remembered" even in the present of much water. In addition, this immobilized hyperactivated PLD showed the excellent operational stabilities and environmental tolerances.

Study of Membrane-Immobilized Oxidoreductases in Wastewater Treatment for Micropollutants Removal

The development of efficient strategies for wastewater treatment to remove micropollutants is of the highest importance. Hence, in this study, we presented a rapid approach to the production of biocatalytic membranes based on commercially available cellulose membrane and oxidoreductase enzymes including laccase, tyrosinase, and horseradish peroxidase. Effective enzyme deposition was confirmed based on Fourier transform infrared spectra, whereas results of spectrophotometric measurements showed that immobilization yield for all proposed systems exceeded 80% followed by over 80% activity recovery, with the highest values (over 90%) noticed for the membrane-laccase system. Further, storage stability and reusability of the immobilized enzyme were improved, reaching over 75% after, respectively, 20 days of storage, and 10 repeated biocatalytic cycles. The key stage of the study concerned the use of produced membranes for the removal of hematoporphyrin, (2,4-dichlorophenoxy)acetic acid (2,4-D), 17α-ethynylestradiol, tetracycline, tert-amyl alcohol (anesthetic drug), and ketoprofen methyl ester from real wastewater sampling at various places in the wastewater treatment plant. Although produced membranes showed mixed removal rates, all of the analyzed compounds were at least partially removed from the wastewater. Obtained data clearly showed, however, that composition of the wastewater matrix, type of pollutants as well as type of enzyme strongly affect the efficiency of enzymatic treatment of wastewater.

A review on pectinase properties, application in juice clarification, and membranes as immobilization support

Pectic substances cause haziness and high viscosity of fruit juices. Pectinase enzymes are biological compounds that degrade pectic compounds. Nontoxicity and ecofriendly nature make pectinases excellent biocatalysts for juice clarification. However, the poor stability and nonreusability of pectinases trim down the effectiveness of the operation. The immobilization techniques have gained the attention of researchers as it augments the properties of the enzymes. Literature has reported the stability improvement of enzymes like lipase, laccase, hydrogen peroxidase, and cellulase upon immobilization on the membrane. However, only a few research articles divulge pectinase immobilization using a membrane. The catalysis-separation synergy of membrane-reactor has put indelible imprints in industrial applications. Immobilization of pectinase on the membrane can enhance its performance in juice processing. This review delineates the importance of physicochemical and kinematic properties of pectinases relating to the juice processing parameters. It also includes the influence of metal-ion cofactors on enzymes' activity. Considering the support and catalytic-separation facets of the membrane, the prediction of the membrane as support for pectinase immobilization has also been carried out.

Cellulose supported magnetic nanohybrids: Synthesis, physicomagnetic properties and biomedical applications-A review

Cellulose and its forms are widely used in biomedical applications due to their biocompatibility, biodegradability and lack of cytotoxicity. It provides ample opportunities for the functionalization of supported magnetic nanohybrids (CSMNs). Because of the abundance of surface hydroxyl groups, they are surface tunable in either homogeneous or heterogeneous solvents and thus act as a substrate or template for the CSMNs' development. The present review emphasizes on the synthesis of various CSMNs, their physicomagnetic properties, and potential applications such as stimuli-responsive drug delivery systems, MRI, enzyme encapsulation, nucleic acid extraction, wound healing and tissue engineering. The impact of CSMNs on cytotoxicity, magnetic hyperthermia, and folate-conjugates is highlighted in particular, based on their structures, cell viability, and stability. Finally, the review also discussed the challenges and prospects of CSMNs' development. This review is expected to provide CSMNs' development roadmap in the context of 21st-century demands for biomedical therapeutics.

Deviation of Trypsin Activity Using Peptide Conformational Imprints

In this study, a methodology utilizing peptide conformational imprints (PCIs) as a tool to specifically immobilize porcine pancreatic alpha-trypsin (PPT) at a targeted position is demonstrated. Owing to the fabrication of segment-mediated PCIs on the magnetic particles (PCIMPs), elegant cavities complementary to the PPT structure are constructed. Based on the sequence on targeted PPT, the individual region of the enzyme is trapped with different template-derived PCIMPs to show certain types of inhibition. Upon hydrolysis, N-benzoyl-L-arginine ethyl ester (BAEE) is employed to assess the hydrolytic activity of PCIMPs bound to the trypsin using high-performance liquid chromatography (HPLC) analysis. Further, the kinetic data of four different PCIMPs are compared. As a result, the PCIMPs presented non-competitive inhibition toward trypsin, according to the Lineweaver-Burk plot. Further, the kinetic analysis confirmed that the best parameters of PPT/PCIMPs 233-245+G were Vmax = 1.47 × 10-3 mM s-1, Km = 0.42 mM, kcat = 1.16 s-1, and kcat/Km = 2.79 mM-1 s-1. As PPT is bound tightly to the correct position, its catalytic activities could be sustained. Additionally, our findings stated that the immobilized PPT could maintain stable activity even after four successive cycles.

Hydrolysis of casein from different sources by immobilized trypsin on biochar: Effect of immobilization method

The present study aimed to evaluate the effect of the immobilization method of trypsin on biochar on the hydrolysis of casein from different sources, when compared to the process using trypsin in native form, to obtain bioactive peptides. The modification of the surface of biochar with glutaraldehyde was effective, as shown by the results of FTIR assay and the texture profile of the materials. Both activated and functionalized biochar showed high immobilization efficiency (greater than 87%) and high binding capacity (greater than 91 mg/g). During hydrolysis, the biocatalyst obtained by enzyme immobilization on the functionalized biochar presented a higher hydrolysis capacity for the different caseins when compared to the enzyme immobilized by adsorption, with values of 3.05 and 2.73 U/mg for goat casein, 2.36 and 1.85 U/mg for bovine casein, and 2.60 and 2.37 U/mg for buffalo, casein, respectively, with 60 min of reaction. The results of inhibitory activity in this study ranged from 93.5% and 25.5% for trypsin in its free form and immobilized on functionalized activated carbon, respectively, under the same reaction conditions. The immobilization methods were efficient, presenting high immobilization capacity. The proteolytic activity of trypsin immobilized via covalent binding was higher when compared the immobilization by adsorption. Thus, the functionalized biochar has proven to be potential support for enzyme immobilization, and the biocatalyst can be reused for more than 4 cycles. Despite lower ACE inhibition values of hydrolyzed obtained with the immobilized enzymes compared to free enzymes, biocatalysts present advantage due to the possibility of reuse.

Efficient and Stable Magnetic Chitosan-Lipase B from Candida Antarctica Bioconjugates in the Enzymatic Kinetic Resolution of Racemic Heteroarylethanols

Lipase B from Candida antarctica immobilized by covalent binding on sebacoyl-activated chitosan-coated magnetic nanoparticles proved to be an efficient biocatalyst (49.2-50% conversion in 3-16 h and >96% enantiomeric excess) for the enzymatic kinetic resolution of some racemic heteroarylethanols through transesterification with vinyl acetate. Under optimal conditions (vinyl acetate, n-hexane, 45 °C), the biocatalyst remains active after 10 cycles.

Gold, Silver and Iron Oxide Nanoparticles: Synthesis and Bionanoconjugation Strategies Aimed at Electrochemical Applications

Nanomaterials have revolutionized the sensing and biosensing fields, with the development of more sensitive and selective devices for multiple applications. Gold, silver and iron oxide nanoparticles have played a particularly major role in this development. In this review, we provide a general overview of the synthesis and characteristics of gold, silver and iron oxide nanoparticles, along with the main strategies for their surface functionalization with ligands and biomolecules. Finally, different architectures suitable for electrochemical applications are reviewed, as well as their main fabrication procedures. We conclude with some considerations from the authors' perspective regarding the promising use of these materials and the challenges to be faced in the near future.

Sustainable synthesis of uridine-5'-monophosphate analogues by immobilized uracil phosphoribosyltransferase from Thermus thermophilus

Nowadays enzymatic synthesis of nucleic acid derivatives is gaining momentum over traditional chemical synthetic processes. Biotransformations catalyzed by whole cells or enzymes offer an ecofriendly and efficient alternative to the traditional multistep chemical methods, avoiding the use of chemical reagents and organic solvents that are expensive and environmentally harmful. Herein we report for the first time the covalent immobilization a uracil phosphoribosyltransferase (UPRT). In this sense, UPRT from Thermus thermophilus HB8 was immobilized onto glutaraldehyde-activated MagReSyn®Amine magnetic iron oxide porous microparticles (MTtUPRT). According to the catalyst load experiments, MTtUPRT3 was selected as optimal biocatalyst for further studies. MTtUPRT3 was active and stable in a broad range of temperature (70-100 °C) and in the pH interval 6-8, displaying maximum activity at 100 °C and pH 7 (activity 968 IU/g_support, retained activity 100%). In addition, MTtUPRT3 could be reused up to 8 times in the synthesis of uridine-5'-monophosphate (UMP). Finally, MTtUPRT3 was successfully applied in the sustainable synthesis of different 5-modified uridine-5'-monophosphates at short times. Taking into account these results, MTtUPRT3 would emerge as a valuable biocatalyst for the synthesis of nucleoside monophosphates through an efficient and environmentally friendly methodology.

Fabrication and Optimization of a Lipase Immobilized Enzymatic Membrane Bioreactor based on Polysulfone Gradient-Pore Hollow Fiber Membrane

Enzymatic membrane bioreactors (EMBRs) possess the characteristic of combining catalysis with separation, and therefore have promising application potentials. In order to achieve a high-performance EMBR, membrane property, as well as operating parameters, should give special cause for concerns. In this work, an EMBR based on hollow fiber polysulfone microfiltration membranes with radial gradient pore structure was fabricated and enzyme immobilization was achieved through pressure-driven filtration. Lipase from Candida rugosa was used for immobilization and EMBR performance was studied with the enzymatic hydrolysis of glycerol triacetate as a model reaction. The influences of membrane pore diameter, substrate feed direction as well as operational parameters of operation pressure, substrate concentration, and temperature on the EMBR activity were investigated with the production of hydrolysates kinetically fitted. The complete EMBR system showed the highest activity of 1.07 × 104 U⋅g−1. The results in this work indicate future efforts for improvement in EMBR.

Structural and functional characterization of thermostable biocatalysts for the synthesis of 6-aminopurine nucleoside-5'-monophospate analogues

The present work describes the functional and structural characterization of adenine phosphoribosyltransferase 2 from Thermus thermophilus HB8 (TtAPRT2). The combination of structural and substrate specificity data provided valuable information for immobilization studies. Dimeric TtAPRT2 was immobilized onto glutaraldehyde-activated MagReSyn®Amine magnetic iron oxide porous microparticles by two different strategies: a) an enzyme immobilization at pH 8.5 to encourage the immobilization process by N-termini (MTtAPRT2A, MTtAPRT2B, MTtAPRT2C) or b) an enzyme immobilization at pH 10.0 to encourage the immobilization process through surface exposed lysine residues (MTtAPRT2D, MTtAPRT2E, MTtAPRT2F). According to catalyst load experiments, MTtAPRT2B (activity: 480 IU g^-1_biocatalyst, activity recovery: 52%) and MTtAPRT2F (activity: 507 IU g^-1_biocatalyst, activity recovery: 44%) were chosen as optimal derivatives. The biochemical characterization studies demonstrated that immobilization process improved the thermostability of TtAPRT2. Moreover, the potential reusability of MTtAPRT2B and MTtAPRT2F was also tested. Finally, MTtAPRT2F was employed in the synthesis of nucleoside-5'-monophosphate analogues.