Controlled self-assemblies of polystyrene-block-polydimethylsiloxane micelles in cylindrical confinement through a micelle solution wetting method and Rayleigh-instability-driven transformation

1D Colloidal chains: recent progress from formation to emergent properties and applications

Integrating nanoscale building blocks of low dimensionality (0D; i.e., spheres) into higher dimensional structures endows them and their corresponding materials with emergent properties non-existent or only weakly existent in the individual building blocks. Constructing 1D chains, 2D arrays and 3D superlattices using nanoparticles and colloids therefore continues to be one of the grand goals in colloid and nanomaterial science. Amongst these higher order structures, 1D colloidal chains are of particular interest, as they possess unique anisotropic properties. In recent years, the most relevant advances in 1D colloidal chain research have been made in novel synthetic methodologies and applications. In this review, we first address a comprehensive description of the research progress concerning various synthetic strategies developed to construct 1D colloidal chains. Following this, we highlight the amplified and emergent properties of the resulting materials, originating from the assembly of the individual building blocks and their collective behavior, and discuss relevant applications in advanced materials. In the discussion of synthetic strategies, properties, and applications, particular attention will be paid to overarching concepts, fresh trends, and potential areas of future research. We believe that this comprehensive review will be a driver to guide the interdisciplinary field of 1D colloidal chains, where nanomaterial synthesis, self-assembly, physical property studies, and material applications meet, to a higher level, and open up new research opportunities at the interface of classical disciplines.

Remora-Inspired Reversible Adhesive for Underwater Applications

The remoras are marine species that can effectively move by clinging onto other marine species via a suction disk on their dorsal side, which is composed of complex structures. The inner suction disk could be divided into three large parts, namely, lip, lamella, and spinule. The lamella is deformed actively to generate pressure difference between the inside and outside of the suction disk, and the lip maintains the sealing. The spinule, which is composed of hairs with diameter of 300 μm or less hair, enhances the frictional force. In this study, we easily fabricated polymer-based adhesive inspired by the suction disk of the remora and conducted an experiment to determine its performance. The adhesive exhibited admirable performance with a 26.68 N cm^-2 (266.8 kPa) pull-off strength and a 19.42 N cm^-2 (194.2 kPa) shear strength in water. The durability test result indicated that the adhesion and friction characteristics of the adhesive were well maintained even after multiple uses.

Scalable and continuous fabrication of bio-inspired dry adhesives with a thermosetting polymer

Many research groups have developed unique micro/nano-structured dry adhesives by mimicking the foot of the gecko with the use of molding methods. Through these previous works, polydimethylsiloxane (PDMS) has been developed and become the most commonly used material for making artificial dry adhesives. The material properties of PDMS are well suited for making dry adhesives, such as conformal contacts with almost zero preload, low elastic moduli for stickiness, and easy cleaning with low surface energy. From a performance point of view, dry adhesives made with PDMS can be highly advantageous but are limited by its low productivity, as production takes an average of approximately two hours. Given the low productivity of PDMS, some research groups have developed dry adhesives using UV-curable materials, which are capable of continuous roll-to-roll production processes. However, UV-curable materials were too rigid to produce good adhesion. Thus, we established a PDMS continuous-production system to achieve good productivity and adhesion performance. We designed a thermal roll-imprinting lithography (TRL) system for the continuous production of PDMS microstructures by shortening the curing time by controlling the curing temperature (the production speed is up to 150 mm min-1). Dry adhesives composed of PDMS were fabricated continuously via the TRL system.