Molecular anchoring to oxide surfaces in ultrahigh vacuum and in aqueous electrolytes: phosphonic acids on atomically-defined cobalt oxide

In this work, we investigated the interaction of phenylphosphonic acid (PPA, C₆H₅PO₃H₂) with atomically-defined Co₃O₄(111) thin films, grown on Ir(100), under ultrahigh vacuum (UHV) conditions and in the electrochemical environment. In the first step, we employed infrared reflection absorption spectroscopy (IRAS) and followed the formation of a saturated monolayer (380 K) in UHV. We observed that the binding motif changes from a chelating tridentate in the sub-monolayer regime to a chelating bidentate at full monolayer coverages. In the electrochemical environment, we analyzed the interaction of PPA with the same Co₃O₄(111) surface by electrochemical infrared reflection absorption spectroscopy (EC-IRRAS) (0.3 V_RHE-1.3 V_RHE). When adsorbed at pH 10 from an ammonia buffered aqueous solution, PPA binds to the surface in form of a fully deprotonated chelating bidentate. With increasing electrode potential, we observed two fully reversible processes. At low buffer concentration, protons are released upon oxidation of surface Co²⁺ ions and lead to protonation of the anchored phosphonates. At high buffer concentration, most of the protons released are accepted by NH₃. Simultaneously, the surface phosphonate changes its adsorption motif from bidentate to tridentate while adopting a more upright geometry.

Titrating Pt Surface with CO Molecules

Identification and quantification of the surface sites on Pt nanoparticles are essential for developing more active electrocatalysts for many practical devices such as fuel cells and electrochemical fuel generators. In this work, we studied CO adsorption from dissolved CO in an H₂SO₄ electrolyte solution on a polycrystalline Pt film electrode held at a constant potential in the underpotential hydrogen deposition region using in situ attenuated total reflectance-surface-enhanced IR absorption spectroscopy (ATR-SEIRAS). Slowing down the adsorption rate by limiting the CO addition rate to the solution allows the individual CO molecules arriving at the Pt surface to rearrange, move to, and occupy their most energetically favorable sites. By using ATR-SEIRAS spectroscopy to follow the stepwise CO adsorption process, one can identify and quantify the Pt surface sites along with uncovering the CO adsorption energetic sequence. This method of slow CO adsorption on the Pt surface is analogous to the chemical titrations used for quantitative chemical analyses.

Preparation of complex model electrocatalysts in ultra-high vacuum and transfer into the electrolyte for electrochemical IR spectroscopy and other techniques

Model studies at complex, yet well-defined electrodes can provide a better understanding of electrocatalytic reactions. New experimental devices are required to prepare such model electrocatalysts with atomic-level control. In this work, we discuss the design of a new setup, which enables the preparation of well-defined electrocatalysts in ultra-high vacuum (UHV) using the full portfolio of surface science techniques. The setup allows for direct transfer of samples from UHV and the immersion into the electrolyte without contact to air. As a special feature, the single crystal sample is transferred without any sample holder, which makes the system easily compatible with most electrochemical in situ methods, specifically with electrochemical infrared reflection absorption spectroscopy, but also with other characterization methods such as single-crystal cyclic voltammetry, differential electrochemical mass spectrometry, or electrochemical scanning tunneling microscopy. We demonstrate the preparation in UHV, the transfer in inert atmosphere, and the immersion into the electrolyte for a complex model catalyst that requires surface science methods for preparation. Specifically, we study Pt nanoparticles supported on well-ordered Co₃O₄(111) films which are grown on an Ir(100) single crystal. In comparison with reference experiments on Pt(111), the model catalyst shows a remarkably different adsorption and reaction behavior during CO electrooxidation in alkaline environments.