Amperometric determination of hydrazine using a CuS-ordered mesoporous carbon electrode

An electrocatalytic sensor for hydrazine using copper sulfide-ordered mesoporous carbon (CuS-OMC) is described. A facile solvothermal synthetic strategy was adopted for CuS-OMC and the ordered mesoporous carbon was obtained through nanocasting method. The synthesized CuS-OMC was characterized using microscopic and spectrochemical techniques. CuS-OMC was immobilized on GCE and evaluated for its electrochemical sensing of hydrazine using cyclic voltammetry and amperometry. CuS-OMC modified GCE exhibited better hydrazine sensing at an optimized pH 7.4 in terms of oxidation potential and current compared with that of GCE, CuS, and OMC. The observed sensing performance of CuS-OMC was attributed to the presence of Cu (I/II) in CuS dispersed in OMC which acts as an electrocatalytic center for the sensing of hydrazine. Amperometry under optimized experimental condition with an applied potential of 270 mV was employed to obtain a linear calibration plot in the range 0.25 to 40 μM (R² = 0.9908) with a detection limit of 0.10 μM with a sensitivity of 0.915 (± 0.02) μA cm^-2 μM^-1. Real sample analyses were carried out by spiking of hydrazine in different water samples and the recoveries were in the range of 97 ± 2.1% (n = 3). Graphical abstract.

Synthesis of Fe2SiO4-Fe7Co3 Nanocomposite Dispersed in the Mesoporous SBA-15: Application as Magnetically Separable Adsorbent

The mixture containing alloy and oxide with iron-based phases has shown interesting properties compared to the isolated species and the synergy between the phases has shown positive effect on dye adsorption. This paper describes the synthesis of Fe2SiO4-Fe7Co3-based nanocomposite dispersed in Santa Barbara Amorphous (SBA)-15 and its application in dye adsorption followed by magnetic separation. Thus, it was studied the variation of reduction temperature and amount of hydrogen used in synthesis and the effect of these parameters on the physicochemical properties of the iron and cobalt based oxide/alloy mixture, as well as the methylene blue adsorption capacity. The XRD and Mössbauer results, along with the temperature-programmed reduction (TPR) profiles, confirmed the formation of Fe2SiO4-Fe7Co3-based nanocomposites. Low-angle XRD, N2 isotherms, and TEM images show the formation of the SBA-15 based mesoporous support with a high surface area (640 m2/g). Adsorption tests confirmed that the material reduced at 700 °C using 2% of H2 presented the highest adsorption capacity (49 mg/g). The nanocomposites can be easily separated from the dispersion by applying an external magnetic field. The interaction between the dye and the nanocomposite occurs mainly by π-π interactions and the mixture of the Fe2SiO4 and Fe7Co3 leads to a synergistic effect, which favor the adsorption.