Onion husk-derived high surface area graphene-like carbon for supercapacitor electrode material application

In this study, we report the synthesis of graphene-like carbon derived from onion husk, with potential application as an electrode material in energy storage devices. Graphene-like carbon (GLC) was synthesized from onion husk (OH) by preliminary carbonization at 550 °C, followed by thermochemical activation at various temperatures to determine the optimal activation parameters. The surface morphology of graphene-like carbon from onion husk (GLC-OH) samples after carbonization shows distinct thermal exfoliation of the material. This layering upon activation in KOH promotes the formation of highly porous graphene-like carbon flakes. According to the Brunauer-Emmett-Teller (BET) method, the specific surface area at 850 °C was 1924 m2/g. The X-ray diffraction (XRD) and Raman spectroscopy results reveal the emergence of few-layer graphene with a significant amount of structural defects at 850 °C. As the temperature increases, the formation shifts towards multilayer graphene, which leads to a decrease in the specific surface area of the carbon material. The electrochemical characterization of the assembled GLC-OH-based supercapacitor synthesized at 850 °C revealed a markedly higher specific capacitance value of 131 F/g, along with a Coulombic efficiency of 98 % at a gravimetric current density of 1 A/g. Additionally, it exhibited a low charge transfer resistance (RCT) of approximately 1.4 Ω. Our study investigates the influence of structural changes on the electrochemical performance of biomass-derived activated carbon, highlighting the potential of graphene-like carbon from onion husk as a promising and low-cost material for future energy storage devices.

Silica embedded carbon nanosheets derived from biomass acorn cupule for non-enzymatic, label-free, and wide range detection of α 1-acid glycoprotein in biofluids

In this work, we demonstrate the first report on a low-cost, non-enzymatic, label-free electrochemical sensing of alpha-1-acid-glycoprotein (α₁GP) biomarker in biofluids using silica embedded carbon nanosheets (SEC) derived from acorn cupules biomass. The SEC/GCE sensor exhibits low detection limit (LOD) of 30 ng/mL (LOD = 3 s/m) which is far below the lowest physiological concentration of α₁GP and a wide linear detection range from 100 ng/mL to 10 mg/mL which covers entire clinical concentration range reported for various diseases like cancer, sepsis, etc. The sensing mechanism of the sensor relies on the direct electrooxidation of sialic acid from the α₁GP structure which hinder the interfacial electron-transfer process of [Fe (CN)₆]^3-/4- redox probe at the electrode-electrolyte interface. The sensor exhibits excellent selectivity and stability towards detection of α₁GP which is ascribed to the presence of embedded silica nanoparticles on the surface of the carbon nanosheets. The successful determination of α₁GP in the simulated blood serum sample with good recovery percentage (i.e., from ∼94.03% to ∼103.50%) proves the feasibility of the sensor towards clinical applications. The overall efficacy of the sensor proves it as a promising low-cost, sustainable, and non-enzymatic platform for a wide variety of bioanalytical applications.

Zinc oxide rod/peanut shell-derived porous carbon composites for cooperative CO2 chemical fixation

A ZnO/biowaste-derived porous carbon composite exhibits admirable activity and selectivity in the cycloaddition of epoxides with CO₂ under mild conditions.

Jackfruit Seed-Derived Nanoporous Carbons as the Electrode Material for Supercapacitors

Hierarchically porous activated carbon materials from agro-waste, Jackfruit seeds are prepared by a chemical activation method involving the treatment with zinc chloride (ZnCl2) at different temperatures (600–1000 °C). The electrochemical supercapacitance performances of the prepared materials were studied in an aqueous electrolyte (1 M sulfuric acid, H2SO4) in a three-electrode system. Jackfruit seed carbons display nanoporous structures consisting of both micro- and mesopore architectures and they are amorphous in nature and also contain oxygenated surface functional groups, as confirmed by powder X-ray diffraction (pXRD), Raman scattering, and Fourier-transformed infrared (FTIR) spectroscopy, respectively. The surface areas and pore volumes were found to be 1216.0 to 1340.4 m2·g−1 and 0.804 to 1.144 cm3·g−1, respectively, demonstrating the better surface textural properties compared to the commercial activated carbons. Due to the high surface area, large pore volume, and well developed hierarchical micro- and mesoporosity, the optimal sample achieved a high specific capacitance of 292.2 F·g−1 at 5 mV·s−1 and 261.3 F·g−1 at 1 A·g−1 followed by outstanding high rate capability. The electrode sustained 71.6% capacity retention at a high current density of 20 A·g−1. Furthermore, the electrode displayed exceptional cycling stability with small capacitance loss (0.6%) even after 10,000 charging–discharging cycles, suggesting that Jackfruit seed would have potential in low-cost and scalable production of nanoporous carbon materials for supercapacitors applications.

Facile sonochemical assisted synthesis of a hybrid red–black phosphorus/sulfonated porous carbon composite for high-performance supercapacitors

Low-cost novel synthesis of a hybrid red–black phosphorus/sulfonated porous carbon composite for supercapacitor application.

Electrochemistry-related aspects of safety of graphene-based non-aqueous electrochemical supercapacitors: a case study with MgO-decorated few-layer graphene as an electrode material

Composites such as MgO/few-layered graphene can be used as electrode materials in supercapacitors with aqueous electrolytes but not non-aqueous electrolytes.

Rich N/O/S co-doped porous carbon with a high surface area from silkworm cocoons for superior supercapacitors

The synergistic effects of high surface area and abundant heteroatoms make porous carbons superior electrode materials.