A novel binary flooding system of a biobased surfactant and hydrophobically associating polymer with ultralow interfacial tensions

Effect of a SILICA/HPAM Nanohybrid on Heavy Oil Recovery and Treatment: Experimental and Simulation Study

The addition of nanoparticles has been presented as an alternative approach to counteract the degradation of polymeric solutions for enhanced oil recovery. In this context, a nanohybrid (NH34) of partially hydrolyzed polyacrylamide (MW ∼12 MDa) and nanosilica modified with 2% 3-aminopropyltriethoxysilane (nSiO2-APTES) was synthesized and evaluated. NH34 was characterized by using dynamic light scattering, Fourier-transform infrared spectroscopy, and thermogravimetric analysis. Fluid-fluid tests assessed its viscosifying power, mechanical stability, filterability, and emulsion behavior. Rock-fluid tests were carried out to determine the nanohybrid's adsorption in porous media, the inaccessible pore volume (IPV), and the resistance (RF) and residual resistance factors (RRF). These tests were conducted under the conditions of a Colombian field. NH34 results were compared with four (4) commercial polymers (P34, P88, P51, and PA2). The viscosifying power of NH34 was observed to be similar to that of the four commercial polymers at a lower concentration, but it exhibits more resistance to mechanical and chemical degradation. The evaluation of the emulsion behavior showed that the nanohybrid neither changed the dehydration process nor altered the crude oil viscosity, favoring its extraction at the wellhead. However, the water clarification treatment must be adjusted because the oil and grease contents and turbidity increase with the residual concentration of NH34. Incremental oil recovery factors obtained by numerical simulation (compared to waterflooding) were P51 (5.5%) > P34 (4.9%) > P88 (4.8%) > NH34 (2.6%) > PA2 (0.9%). The polymers P51, P34, and P88 had a better recovery factor than NH34 and PA2 due to their lower values of residual adsorption and IPV. Few studies have been reported on polymer nanohybrids' emulsion and flow behavior. Therefore, further research is needed to enhance our understanding of the fundamental enhanced oil recovery mechanisms associated with polymer nanohybrids.

Experimental Investigation on Spontaneous Imbibition of Surfactant Mixtures in Low Permeability Reservoirs

Spontaneous imbibition of surfactants could efficiently enhance oil recovery in low permeability sandstone reservoirs. The majority of studies have considered the application of individual surfactants to alter wettability and reduce interfacial tension (IFT). However, a significant synergistic effect has been reported between different types of surfactants and between salts and surfactants. Therefore, this study systematically studied the capability of a binary surfactant mixture (anionic/nonionic) and a ternary surfactant mixture (anionic/nonionic/strong base-weak acid salt) in imbibition enhanced oil recovery (IEOR). The interfacial properties and the cores' wettability were explored by IFT and contact angle measurements, respectively. Subsequently, the imbibition performances of different types of surfactant solutions were discussed. The results suggested that the surfactants' potential to enhance oil recovery followed the order of ternary surfactant mixture > binary surfactant mixture > anionic > nonionic > amphoteric > polymer. The ternary surfactant mixture exhibited strong capacity to reverse the rock surface from oil-wet (125°) to strongly water-wet (3°), which was more significant than both binary surfactant mixtures and individual surfactants. In addition, the ternary surfactant mixture led to an ultralow IFT value of 0.0015 mN/m, achieving the highest imbibition efficiency (45% OOIP). This research puts forward some new ideas on the application of the synergistic effects of surfactants in IEOR from low-permeability sandstone reservoirs.

Highly Ca2+-Ion-Tolerant Biobased Zwitterionic Surfactant with High Interfacial Activity

The wide application of surfactants has a harmful effect on the environment, drawing more attention to the development and application of low-toxicity surfactants. A salt-tolerant and low-toxicity biobased zwitterionic surfactant, N,N-dimethyl-N-[2-hydroxy-3-sulfo-propyl]-N-benzyloxyoctadecanoyl-1,3-propanediamine (SPBOPA), was prepared from the oleic acid extracted from waste oils and anise ether extracted from the tarragon. The final surfactant structure was confirmed using gas chromatography-mass spectrometry (GC-MS), liquid chromatography-mass spectrometry (LC-MS), and ¹H nuclear magnetic resonance (NMR) spectroscopy. The SPBOPA surfactant could reduce the interfacial tension between crude oil and formation brine to ultralow (5.2 × 10^-4 mN/m) at a low dosage without extra alkali. It still had good interfacial properties in NaCl up to 60 g/L, Ca²⁺ up to 2000 mg/L, and temperature up to 100 °C. Furthermore, SPBOPA had strong antidilution and antiadsorption properties with low toxicity as demonstrated by the high LD₅₀ value of >5000 mg/kg·BW. It could also enhance the wetting ability of crude oil surfaces. Meanwhile, it showed a high biodegradability in the environment. All of the results achieved in this work confirmed that the SPBOPA surfactant is a more robust and promising biobased surfactant candidate than traditional surfactants as an eco-friendly surfactant for enhanced oil recovery (EOR).

The optimization of heterogeneous catalytic conditions in the direct alkylation of waste vegetable oil

Alkylated waste vegetable oil is a versatile intermediate product in the synthesis of bio-based materials. Heterogeneous catalytic condition with high conversion rate in the direct alkylation of waste vegetable oil was reported and the deactivation mechanism of catalyst was revealed. The total exchange capacity, elemental composition and pyrolysis product of catalyst before and after the alkylation reaction were analysed by back titration, elemental analysis, electrospray ionization mass spectrometry, gas chromatography mass spectrometry and pyrolysis-gas chromatography/mass spectrometry, respectively. The results indicated that the metallic and non-metallic (C, H) elements contents of the catalyst have very much increased with great changes in pyrolysis product and a slight decrease in the total exchange capacity. The formation of insoluble polymers through Diels-Alder cycloaddition between triglycerides was proved to be the major factor causing the dysfunction of the catalytic centre. The metal ions from corrosion of the reactor were the minor factor causing about 2.56% loss of the catalytic centre. Moreover, the catalyst was able to maintain high catalytic efficiency when replacing the raw materials with other waste vegetable oil having low concentration of polyunsaturated fatty acids, which is significant for producing not only the aryl fatty acids derivatives but also the bio-based surfactants.