Photostability and photocatalytic degradation of ionic liquids in water under solar light

Ionic Liquids in Metal, Photo-, Electro-, and (Bio) Catalysis

Ionic liquids (ILs) have unique physicochemical properties that make them advantageous for catalysis, such as low vapor pressure, non-flammability, high thermal and chemical stabilities, and the ability to enhance the activity and stability of (bio)catalysts. ILs can improve the efficiency, selectivity, and sustainability of bio(transformations) by acting as activators of enzymes, selectively dissolving substrates and products, and reducing toxicity. They can also be recycled and reused multiple times without losing their effectiveness. ILs based on imidazolium cation are preferred for structural organization aspects, with a semiorganized layer surrounding the catalyst. ILs act as a container, providing a confined space that allows modulation of electronic and geometric effects, miscibility of reactants and products, and residence time of species. ILs can stabilize ionic and radical species and control the catalytic activity of dynamic processes. Supported IL phase (SILP) derivatives and polymeric ILs (PILs) are good options for molecular engineering of greener catalytic processes. The major factors governing metal, photo-, electro-, and biocatalysts in ILs are discussed in detail based on the vast literature available over the past two and a half decades. Catalytic reactions, ranging from hydrogenation and cross-coupling to oxidations, promoted by homogeneous and heterogeneous catalysts in both single and multiphase conditions, are extensively reviewed and discussed considering the knowledge accumulated until now.

Cheap and efficient strategy for photocatalytic degradation of ionic liquids by La/Ce-codoped TiO2@PAM composites

Ionic liquids are regarded as green solvents mainly due to their non-volatile and easy regeneration and recycling properties. However, ionic liquids have negative effects on the environment and human health, especially alkyl imidazole ionic liquids are more toxic than traditional organic solutions. Studies on the toxicology, ecotoxicology, and degradation of ionic liquids are rarely found in the literature. Here, we prepared the cheap La and Ce-codoped TiO2@PAM (polyacrylamide) composite microspheres with a simple procedure for the first time to degrade three kinds of imidazole ionic liquids with high efficiency. The experimental results show that the composite La (0.25%) and Ce (0.15%)-codoped TiO2@PAM composite microspheres with calcination temperature of 450 °C had a high photocatalytic activity for 1-butyl-3-methyl imidazolium hexafluorophosphate, 1-hexyl-3-methyl imidazolium hexafluorophosphate, and 1-octyl-3-methyl imidazolium hexafluorophosphate with the concentration of 10 mg/L. The photocatalysis degradation extent of the three ionic liquids is 97.4, 91.2, and 88.5% at 90 min. This work opened a new route for the simple preparation of cheap composite microspheres in the photocatalytic degradation of ionic liquids with a high efficiency.

Fenton and photo-assisted advanced oxidative degradation of ionic liquids: a review

Ionic liquids (ILs) are the class of materials which are purely ionic in nature and liquid at room temperature. Their remarkable properties like very low vapour pressure, non-inflammable and high heat resistance are responsible for their use as a very appealing solvent in a variety of industrial applications in place of regular organic solvents. Because ILs are water soluble to a certain extent, the industrial wastewater effluents are found to contaminate with their traces. The non-biodegradability of ILs attracts the attention of the researchers for their removal or degradation from wastewater. Numbers of methods are available for the treatment of wastewater. However, it is very crucial to use the most efficient method for the degradation of ILs. Advanced oxidation process (AOP) is one of the most important techniques for the treatment of ILs in wastewater which have been investigated during last decades. This review paper covers the cost-effective Fenton, photochemical and photocatalytic AOPs and their combination that could be applied for the degradation of ILs from the wastewater. Theoretical explanations of these AOPs along with experimental conditions and kinetics of degradation or removal of ILs from water and wastewater have been reported and compared. Finally, future perspectives of IL degradation are presented.

Imidazolium ionic liquids as potential persistent pollutants in aqueous environments: Indirect photochemical degradation kinetics and mechanism

Ionic liquids (ILs) with promising application are likely to become ubiquitous contaminants in water environment for their high hydrophilicity, low biodegradability, and especially its potential toxicity. In this work, we have investigated photochemical transformation of six imidazolium ILs for fate prediction and ecological risk assessment. We found that the reaction rates of the ILs with •OH, CO₃^•─ and ¹O₂ enhanced with their increasing alkyl chain and varied slightly with the paired anions. Meanwhile, modelled results under different scenarios indicate that the primary contributors to transformation of the ILs are triplet-stated dissolved matter (³CDOM*), •OH and CO₃^•-. Besides, the overall half-lives of the ILs can reach 670 days, which indicates persistence of these ILs in the environment. Products for ILs in reaction with •OH and triplet-stated sodium anthraquinone-2-sulfonate (³AQ2S*) were probed by UHPLC-Q-TOF-MS/MS and there is a difference between their products: Products by •OH are likely formed by hydrogen abstraction from the side alkyl chain, followed by dehydrogenation, hydroxylation and carbonylation, while one of the products by ³AQ2S* is formed by dihydroxyl-addition of the imidazolium ring. Furthermore, the ILs and its products were estimated to have toxicity and non-readily biodegradability, suggesting potential eco-risk for the environmental water.

Ionic liquids as environmental hazards - Crucial data in view of future PBT and PMT assessment

Ionic liquids (ILs) constitute a large group of chemical compounds. They have gained much attention among scientists and industry due to their unique properties. Due to the fact that ILs are purely ionic compounds, there is the possibility to design an enormous number of cation and anion combinations, making them designer solvents. Thus it also creates the possibility of producing more environmentally benign solvents. However, significant drawbacks related mainly to their toxicity and persistence have already been noticed. Furthermore the interest in these compounds is constantly growing and their impact on the environment should be defined. More and more ILs are produced or imported in the amount higher than 10 tonnes per year and the group of ILs registered in REACH is still expanding. Thus for an increasing number of compounds, it will be necessary to perform a PBT and PMT assessment using the criteria described in REACH. Therefore the data collected in this work thoroughly sort out the information on the toxicity, bioconcentration/bioaccumulation, biodegradation and mobility of ILs in the context of PBT and PMT assessment.

Understanding the Photoexcitation of Room Temperature Ionic Liquids

Photoexcitation of (neat) room temperature ionic liquids (RTILs) leads to the observation of transient species that are reminiscent of the composition of the RTILs themselves. In this minireview, we summarize state-of-the-art in the understanding of the underlying elementary processes. By varying the anion or cation, one aim is to generally predict radiation-induced chemistry and physics of RTILs. One major task is to address the fate of excess electrons (and holes) after photoexcitation, which implies an overview of various formation mechanisms considering structural and dynamical aspects. Therefore, transient studies on time scales from femtoseconds to microseconds can greatly help to elucidate the most relevant steps after photoexcitation. Sometimes, radiation may eventually result in destruction of the RTILs making photostability another important issue to be discussed. Finally, characteristic heterogeneities can be associated with specific physicochemical properties. Influencing these properties by adding conventional solvents, like water, can open a wide field of application, which is briefly summarized.

Cation and anion effect on the biodegradability and toxicity of imidazolium- and choline-based ionic liquids

This work studies the effect of the cation and anion on the biodegradability and inhibition of imidazolium- and choline-based ionic liquids (ILs) using activated sludge. Six commercial ILs, formed by combination of 1-Butyl-3-methylimidazolium (Bmim⁺) and N,N,N-trimethylethanolammonium (Choline⁺) cations and chloride (Cl^-), acetate (Ac^-) and bis(trifluoromethanesulfonyl)imide (NTf₂^-) anions were evaluated, all representative counter-ions with markedly different toxicity and biodegradability. Inherent and fast biodegradability tests were used to evaluate both the microorganism inhibition and the IL biodegradability. In addition, the ecotoxicological response (EC₅₀) of the ILs was studied using activated sludge and Vibrio fischeri (Microtox® test). Bmim⁺ and NTf₂^- can be considered as non-biodegradable, whereas aerobic microorganisms easily degraded Choline⁺ and Ac^-. The biodegradation pattern of each cation/anion is nearly unaffected by counter-ion nature. Moreover, concentrations of CholineNTf₂ higher than 50 mg/L caused a partial inhibition on microbial activity, in good concordance with its low EC₅₀ (54 mg/L) measured by respiration inhibition test, which alerts on the negative environmental impact of NTf₂-containing ILs on the performance of sewage treatment plants.

Understanding the adsorption of ionic liquids onto zeolite ZSM-5 from aqueous solution: experimental and computational modelling

Ionic liquids are considered as emergent pollutants as these compounds possess high persistence in aqueous solution and toxicity toward aquatic organisms. In this work, the adsorption equilibrium of 27 ionic liquids, with different cation head groups, alkyl chain lengths, and anions, onto ZSM-5 was measured experimentally at several compositions and at temperature 298.15 K and 0.1 MPa. The extensive number of ionic liquids studied allows a comprehensive study on the impact of adsorbate chemical structures toward their adsorption process. The gathered experimental results show that the anions have a dominant effect, when compared to the cation head group and the alkyl chain length, in ruling the adsorption of ionic liquids from aqueous solution onto ZSM-5. The adsorption isotherms reveal that the adsorption process is a combination between Langmuir and Freundlich behaviors, with the latter leading the general process. Moreover, computational modelling using COSMO-RS demonstrates the existence of several molecular forces that rule the adsorption process, reinforcing the idea that the ionic liquid anion rules the adsorption. The results collected in the present work provide new understanding on the molecular mechanism for the development of efficient adsorbents for removal and recovery of ionic liquids from aqueous solution.