Electrorheology of SI-ATRP-modified graphene oxide particles with poly(butyl methacrylate): effect of reduction and compatibility with silicone oil

Electrorheological Fluids of GO/Graphene-Based Nanoplates

Due to their unique anisotropic morphology and properties, graphene-based materials have received extensive attention in the field of smart materials. Recent studies show that graphene-based materials have potential application as a dispersed phase to develop high-performance electrorheological (ER) fluids, a kind of smart suspension whose viscosity and viscoelastic properties can be adjusted by external electric fields. However, pure graphene is not suitable for use as the dispersed phase of ER fluids due to the electric short circuit caused by its high electrical conductivity under electric fields. However, graphene oxide (GO) and graphene-based composites are suitable for use as the dispersed phase of ER fluids and show significantly enhanced property. In this review, we look critically at the latest developments of ER fluids based on GO and graphene-based composites, including their preparation, electrically tunable ER property, and dispersed stability. The mechanism behind enhanced ER property is discussed according to dielectric spectrum analysis. Finally, we also propose the remaining challenges and possible developments for the future outlook in this field.

Core-Shell Structured Magnetite-Poly(diphenylamine) Microspheres and Their Tunable Dual Response under Magnetic and Electric Fields

Core-shell type poly(diphenylamine)-coated magnetite (Fe₃O₄-PDPA) microspheres were designed and adopted as a novel actively tunable smart material which is responsive under both electric and magnetic fields. Their morphology, chemical structure, crystalline structure, and thermal properties were characterized using scanning electron microscopy, transmission electron microscope, Fourier transform-infrared spectroscopy, X-ray diffraction, and a thermal gravimetric analyzer. Their magnetic and dielectric properties were determined using vibrating-sample magnetometer and an LCR meter, respectively. They were dispersed in silicone oil and their electrorheological (ER) and magnetorheological (MR) responses under the electric and magnetic fields, respectively, were examined. The formation of chain structure of Fe₃O₄-PDPA based E/MR fluid under the application of electric field or magnetic field was observed by an optical microscopy and the sedimentation stability was observed by a Turbiscan optical analyzer system. It was observed that the yield stress, ER efficiency, and leakage current density increased with an increase in the particle concentration, while the slope of the electric field-dependent yield stress decreased. Several models such as the Bingham model, Herschel-Bulkley model, and Cho-Choi-Jhon equations were used to describe the shear stress curves of the ER fluid; the curves fitted well. For the dielectric properties, the two types of ER fluids tested displayed the same relaxation time and distribution; however, the one with the higher concentration had a higher dielectric constant and polarizability. The Fe₃O₄-PDPA based MR fluid (10 vol %) exhibited typical MR properties. In addition, the Herschel-Bulkley model matched well with the shear stress curves under a magnetic field.

In-situ Modification of Graphene Oxide by Insoluble Sulfur and Application for Nitrile Butadiene Rubber

Insoluble sulfur (IS) is prepared at low temperature with graphene oxide (GO) as stabilizer and ammonium persulfate as initiator. The FTIR and Raman patterns show that the non-conjugate double bond of GO can couple to the long chain free radicals of IS. The TGA and EDS results show that the mass fraction of IS is 79.75 wt% in particles by refluxing method, much higher than that in particles by hydrothermal method, when the mass ratio in reactants of GO to sulfur was 3: 1. Under constant content of sulfur, the tensile stress and elongation at break of NBR/GO-S(h) and NBR/GO-S(r) composites are higher than those of NBR/Reduced GO composites with the addition of 3 phr GO-S(h), GO-S(r) and Reduced GO particles into NBR. It can provide a new technology for the preparation of IS with lower temperature, little energy consumption and less environmental pollution. It is also a new method for the modification and application of GO in rubber.

Graphene Oxide and Its Inorganic Composites: Fabrication and Electrorheological Response

Composite particles associated with graphene oxide (GO) and inorganic materials provide the synergistic properties of an appropriate electrical conductivity of GO with the good dielectric characteristics of inorganic materials, making them attractive candidates for electrorheological (ER) materials. This review paper focuses on the fabrication mechanisms of GO/inorganic composites and their ER response when suspended in a non-conducting medium, including steady shear flow curves, dynamic yield stress, On-Off tests, and dynamic oscillation analysis. Furthermore, the morphologies of these composites, dielectric properties, and sedimentation of the ER fluids are covered.

Recent development of electro-responsive smart electrorheological fluids

The characteristics of an electrorheological (ER) fluid, as a class of smart soft matter, can be actively and accurately tuned between a liquid- and a solid-like phase by the application of an electric field. ER materials used in ER fluids are electrically polarizable particles, which are attracting considerable attention in addition to further research. This perspective reports the latest ER materials along with their rheological understanding and provides a forward-looking summary of the potential future applications of ER technology.