Shear-induced parallel and transverse alignments of cylinders in thin films of diblock copolymers

Developing Anisotropy in Self-Assembled Block Copolymers: Methods, Properties, and Applications

Block copolymers (BCPs) self-assembly has continually attracted interest as a means to provide bottom-up control over nanostructures. While various methods have been demonstrated for efficiently ordering BCP nanodomains, most of them do not generically afford control of nanostructural orientation. For many applications of BCPs, such as energy storage, microelectronics, and separation membranes, alignment of nanodomains is a key requirement for enabling their practical use or enhancing materials performance. This review focuses on summarizing research progress on the development of anisotropy in BCP systems, covering a variety of topics from established aligning techniques, resultant material properties, and the associated applications. Specifically, the significance of aligning nanostructures and the anisotropic properties of BCPs is discussed and highlighted by demonstrating a few promising applications. Finally, the challenges and outlook are presented to further implement aligned BCPs into practical nanotechnological applications, where exciting opportunities exist.

Facilitated Structure Formation in Isoporous Block Copolymer Membranes upon Controlled Evaporation by Gas Flow

The conventional fabrication of isoporous membranes via the evaporation-induced self-assembly of block copolymers in combination with non-solvent induced phase separation (SNIPS) is achieved under certain environmental conditions. In this study, we report a modification in the conventional fabrication process of (isoporous) flat sheet membranes in which the self-assembly of block copolymers is achieved by providing controlled evaporation conditions using gas flow and the process is introduced as gSNIPS. This fabrication approach can not only trigger and control the microphase separation but also provides isoporous structure formation in a much broader range of solution concentrations and casting parameters, as compared to fabrication under ambient, uncontrolled conditions. We systematically investigated the structure formation of the fabrication of integral asymmetric isoporous membranes by gSNIPS. A quantitative correlation between the evaporation conditions (causing solvent evaporation and temperature drop) and the self-assembly of block copolymers beginning from the top layer up to a certain depth, orientation of pores in the top layer and the substructure morphology has been discussed empirically.