In Situ Sonoactivation of Polycrystalline Ni for the Hydrogen Evolution Reaction in Alkaline Media

In this investigation, we report on the development of a method for activating polycrystalline metallic nickel (Ni(poly)) surfaces toward the hydrogen evolution reaction (HER) in N₂-saturated 1.0 M KOH aqueous electrolyte through continuous and pulsed ultrasonication (24 kHz, 44 ± 1.40 W, 60% acoustic amplitude, ultrasonic horn). It is found that ultrasonically activated Ni shows an improved HER activity with a much lower overpotential of -275 mV vs RHE at -10.0 mA cm^-2 when compared to nonultrasonically activated Ni. It was observed that the ultrasonic pretreatment is a time-dependent process that gradually changes the oxidation state of Ni and longer ultrasonication times result in higher HER activity as compared to untreated Ni. This study highlights a straightforward strategy for activating nickel-based materials by ultrasonic treatment for the electrochemical water splitting reaction.

Fourier transform infrared spectroscopic studies of methane and liquefied natural gas reforming processes on Ni/CeO2 catalyst

For the first time, a mechanistic study of methane oxy-steam reforming and LNG (OSR-LNG) processes is presented using Fourier transform infrared (FTIR) spectroscopy. The FTIR measurements were carried out in the temperature range of 200–600 °C in the tested processes. The reaction mechanisms of oxy-steam reforming of CH4 or LNG were proposed from the results obtained. It was found that the dissociation of methane into carbon-containing molecules and/or into carbon molecules adsorbed on the catalyst surface is a crucial step in determining the reaction rate. The results can be used to design catalytic systems for natural gas reforming.

Noble Metal Nanoparticles Decorated Boron Nitride Nanotubes for Efficient and Selective Low-Temperature Catalytic Reduction of Nitric Oxide with Carbon Monoxide

Parallel to CO₂ emission, NO_x emission has become one of the menacing problems that seek a simple, durable, and high-efficiency deNO_x catalyst. Herein, we demonstrated simple syntheses of platinum group metal nanoparticle-decorated f-BNNT (PGM = Pd, Pt, and Rh, and f-BNNT stands for -OH-functionalized boron nitride nanotubes) as a catalyst for efficient and selective reduction of NO by CO at low-temperature conditions. PGM/f-BNNT with a low amount of noble metal nanoparticles (0.7-0.8 wt %) presents very efficient catalytic activity for NO reduction as well as CO oxidation during their removal process. The removal efficiencies of NO and CO with Pd/f-BNNT, Pt/f-BNNT, and Rh/f-BNNT catalysts were investigated under various temperatures, flow rates, and reaction times, respectively. For most cases, NO catalytic reduction with CO reaction was >99% at a temperature as low as ∼200 °C. The catalyst robustness and efficiency were also verified by presenting almost 100% conversion of NO using a Rh/f-BNNT catalyst, which was aged under humid air at 600 and 700 °C for 24 h, respectively. The synergic effect of the catalytic efficacy of the well-dispersed noble metal nanoparticles and the excellent surface properties of BNNT are reasons for the high selectivity and catalytic property at a low temperature. On the basis of this investigation, we demonstrated that the noble metal nanoparticle-decorated f-BNNT catalysts are possible to save expensive PGM catalysts, such as Pt, Pd, and Rd, as much as 100 times while presenting similar or better catalytic performance for simultaneous NO and CO removals.

Isolating Contiguous Ir Atoms and Forming Ir-W Intermetallics with Negatively Charged Ir for Efficient NO Reduction by CO

The lack of efficient catalysts with a wide working temperature window and vital O₂ and SO₂ resistance for selective catalytic reduction of NO by CO (CO-SCR) largely hinders its implementation. Here, a novel Ir-based catalyst with only 1 wt% Ir loading is reported for efficient CO-SCR. In this catalyst, contiguous Ir atoms are isolated into single atoms, and Ir-W intermetallic nanoparticles are formed, which are supported on ordered mesoporous SiO₂ (KIT-6). Notably, this catalyst enables complete NO conversion to N₂ at 250 °C in the presence of 1% O₂ and has a wide temperature window (250-400 °C), outperforming the comparison samples with Ir isolated-single-atomic-sites and Ir nanoparticles, respectively. Also, it possesses a high SO₂ tolerance. Both experimental results and theoretical calculations reveal that single Ir atoms are negatively charged, dramatically enhancing the NO dissociation, while the Ir-W intermetallic nanoparticles accelerate the reduction of the N₂ O and NO₂ intermediates by CO.

NO reduction with CO over a highly dispersed Mn/TiO2catalyst at low temperature: a combined experimental and theoretical study

A highly dispersed Mn/TiO₂catalyst, which has high efficiency for NO conversion with CO and almost completed N₂selectivity at a low-temperature range (350-550 K), was investigated using experimental and DFT theoretical calculation. The characterization results illustrated that the catalyst assembled with nanoparticles and the Mn doping into the TiO₂surface lattice led to the formation of Mn-O-Ti configuration, which enhanced the dispersion of Mn on the body of TiO₂. The DFT study mapped out the complete catalytic cycle, including reactants adsorption, oxygen vacancy generation, N₂O intermediates formation, N₂formation in Eley-Rideal (ER), Langmuir-Hinshelwood, and termolecular Eley-Rideal mechanisms. With thermodynamic and kinetic analysis combined with experimental results, the ER reaction process was considered to be the fundamental mechanism over the highly dispersed Mn/TiO₂catalyst. The calculation results indicated that N₂O was a significant intermediate. However, the rapid N₂O reduction process led to high N₂selectivity. The rate-limiting step was the deoxygenation step of NO-MnO_v/TiO₂from N-O bond scission. The active site Mn-O_vpair embedded in Mn/TiO₂was responsible not only for the formation of N-Mn/TiO₂in the ER-1 step but also for the N₂O deoxygenation process to make the final product N₂in the ER-2 step. The synergetic effect between Mn 3d electron and the oxygen vacancy of TiO₂were responsible for the catalytic activity of Mn/TiO₂.

Impact of NaOH Concentration on Deweaving of Cotton Fabric in Aqueous Solutions

In the past decade, there has been increasing attention paid to the recycling of cotton fabric waste. In the present study, different concentrations of sodium hydroxide (NaOH) ranging from 1 M to 4 M were used to thermomechanically deweave cotton fabric. The fabrics treated with 1 M NaOH and 2 M NaOH were partially deweaved, whereas those treated with 3 M NaOH and 4 M NaOH were completely deweaved. Fourier-transform infrared (FTIR) spectroscopy was applied to analyze the chemistry and structure of the cotton fabric. The FTIR spectra indicated that the structure of cotton fabrics treated with 1–2 M NaOH were similar to that of pristine fabric, while the presence of NaOH was observed. In the case of samples treated with 3–4 M NaOH, both the peak positions and the band intensities were changed, in addition to the formation of cellulose II. FTIR spectra for the recycled NaOH-treated cotton fabrics were compared, and no major structural changes were identified. A post-treatment with deionized (DI) water removed excess Na+ ions, with the sample showing a similar molecular structure to that of the pristine material. These results suggest the feasibility of recycling aqueous NaOH for post-washing treatment as a new method for recycling cellulosic fabric waste.