Emerging investigator series: influence of marine emissions and atmospheric processing on individual particle composition of summertime Arctic aerosol over the Bering Strait and Chukchi Sea

Probing Individual Particles Generated at the Freshwater-Seawater Interface through Combined Raman, Photothermal Infrared, and X-ray Spectroscopic Characterization

Sea spray aerosol (SSA) is one of the largest global sources of atmospheric aerosol, but little is known about SSA generated in coastal regions with salinity gradients near estuaries and river outflows. SSA particles are chemically complex with substantial particle-to-particle variability due to changes in water temperature, salinity, and biological activity. In previous studies, the ability to resolve the aerosol composition to the level of individual particles has proven necessary for the accurate parameterization of the direct and indirect aerosol effects; therefore, measurements of individual SSA particles are needed for the characterization of this large source of atmospheric aerosol. An integrated analytical measurement approach is required to probe the chemical composition of individual SSA particles. By combining complementary vibrational microspectroscopic (Raman and optical photothermal infrared, O-PTIR) measurements with elemental information from computer-controlled scanning electron microscopy with energy-dispersive X-ray analysis (CCSEM-EDX), we gained unique insights into the individual particle chemical composition and morphology. Herein, we analyzed particles from four experiments on laboratory-based SSA production using coastal seawater collected in January 2018 from the Gulf of Maine. Individual salt particles were enriched in organics compared to that in natural seawater, both with and without added microalgal filtrate, with greater enrichment observed for smaller particle sizes, as evidenced by higher carbon/sodium ratios. Functional group analysis was carried out using the Raman and infrared spectra collected from individual SSA particles. Additionally, the Raman spectra were compared with a library of Raman spectra consisting of marine-derived organic compounds. Saccharides, followed by fatty acids, were the dominant components of the organic coatings surrounding the salt cores of these particles. This combined Raman, infrared, and X-ray spectroscopic approach will enable further understanding of the factors determining the individual particle composition, which is important for understanding the impacts of SSA produced within estuaries and river outflows, as well as areas of snow and ice melt.

Aerosol Acidity: Novel Measurements and Implications for Atmospheric Chemistry

The pH of a solution is one of its most fundamental chemical properties, impacting reaction pathways and kinetics across every area of chemistry. The atmosphere is no different, with the pH of the condensed phase driving key chemical reactions that ultimately impact global climate in numerous ways. The condensed phase in the atmosphere is comprised of suspended liquid or solid particles, known as the atmospheric aerosol, which are differentiated from cloud droplets by their much smaller size (primarily <10 μm). The pH of the atmospheric aerosol can enhance certain chemical reactions leading to the formation of additional condensed phase mass from lower volatility species (secondary aerosol), alter the optical and water uptake properties of particles, and solubilize metals that can act as key nutrients in nutrient-limited ecosystems or cause oxidative stress after inhalation. However, despite the importance of aerosol acidity for climate and health, our fundamental understanding of pH has been limited due to aerosol size (by number >99% of particles are <1 μm) and complexity. Within a single atmospheric particle, there can be hundreds to thousands of distinct chemical species, varying water content, high ionic strengths, and different phases (liquid, semisolid, and solid). Making aerosol analysis even more challenging, atmospheric particles are constantly evolving through heterogeneous reactions with gases and multiphase chemistry within the condensed phase. Based on these challenges, traditional pH measurements are not feasible, and, for years, indirect and proxy methods were the most common way to estimate aerosol pH, with mixed results. However, aerosol pH needs to be incorporated into climate models to accurately determine which chemical reactions are dominant in the atmosphere. Consequently, experimental measurements that probe pH in atmospherically relevant particles are sorely needed to advance our understanding of aerosol acidity.This Account describes recent advances in measurements of aerosol particle acidity, specifically three distinct methods we developed for experimentally determining particle pH. Our acid-conjugate base method uses Raman microspectroscopy to probe an acid (e.g., HSO₄^-) and its conjugate base (e.g., SO₄^2-) in individual micrometer-sized particles. Our second approach is a field-deployable colorimetric method based on pH indicators (e.g., thymol blue) and cell phone imaging to provide a simple, low-cost approach to ensemble average (or bulk) pH for particles in distinct size ranges down to a few hundred nanometers in diameter. In our third method, we monitor acid-catalyzed polymer degradation of a thin film (∼23 nm) of poly(ε-caprolactone) (PCL) on silicon by individual particles with atomic force microscopy (AFM) after inertially impacting particles of different pH. These measurements are improving our understanding of aerosol pH from a fundamental physical chemistry perspective and have led to initial atmospheric measurements. The impact of aerosol pH on key atmospheric processes, such as secondary organic aerosol (SOA) formation, is discussed. Some unique findings, such as an unexpected size dependence to aerosol pH and kinetic limitations, illustrate that particles are not always in thermodynamic equilibrium with the surrounding gas. The implications of our limited, but improving, understanding of the fundamental chemical concept of pH in the atmospheric aerosol are critical for connecting chemistry and climate.

Simultaneous Optical Photothermal Infrared (O-PTIR) and Raman Spectroscopy of Submicrometer Atmospheric Particles

Physicochemical analysis of individual atmospheric aerosols at the most abundant sizes in the atmosphere (<1 μm) is analytically challenging, as hundreds to thousands of species are often present in femtoliter volumes. Vibrational spectroscopies, such as infrared (IR) and Raman, have great potential for probing functional groups in single particles at ambient pressure and temperature. However, the diffraction limit of IR radiation limits traditional IR microscopy to particles > ∼10 μm, which have less relevance to aerosol health and climate impacts. Optical photothermal infrared (O-PTIR) spectroscopy is a contactless method that circumvents diffraction limitations by using changes in the scattering intensity of a continuous wave visible laser (532 nm) to detect the photothermal expansion when a vibrational mode is excited by a tunable IR laser (QCL: 800-1800 cm^-1 or OPO: 2600-3600 cm^-1). Herein, we simultaneously collect O-PTIR spectra with Raman spectra at a single point for individual particles with aerodynamic diameters <400 nm (prior to impaction and spreading) at ambient temperature and pressure, by also collecting the inelastically scattered visible photons for Raman spectra. O-PTIR and Raman spectra were collected for submicrometer particles with different substrates, particle chemical compositions, and morphologies (i.e., core-shell), as well as IR mapping with submicron spatial resolution. Initial O-PTIR analysis of ambient atmospheric particles identified both inorganic and organic modes in individual sub- and supermicrometer particles. The simultaneous IR and Raman microscopy with submicrometer spatial resolution described herein has considerable potential both in atmospheric chemistry and numerous others fields (e.g., materials and biological research).