A double-emission molecularly imprinted ratiometric fluorescent sensor based on carbon quantum dots and fluorescein isothiocyanate for visual detection of p-nitroaniline

A novel molecularly imprinted ratiometric fluorescent sensor CQDs@MIP/FITC@SiO2 for the detection of p-nitroaniline (p-NA) was constructed through the mixture of CQDs@MIP and FITC@SiO2 in the ratio of 1:1 (VCQDs@MIP:VFITC@SiO₂). The polymers of CQDs@MIP and FITC@SiO2 were prepared by sol-gel method and reversed-phase microemulsion method, respectively. CQDs@MIP was used as the auxiliary response signal and FITC@SiO2 was used as the reference enhancement signal. The signal was measured at excitation/emission wavelengths of 365/438, 512 nm. The sensor showed good linearity in the concentration range 0.14-40.00 µM (R2 = 0.998) with a detection limit of 0.042 µM for p-NA. The color change of "blue-cyan-green" could be observed by the naked eye under 365 nm UV light, thus realizing the visual detection of p-NA. The sensor presented comparable results compared with high-performance liquid chromatography (HPLC) method for the detection of p-NA in hair dye paste and aqueous samples with recoveries of 96.8-103.7% and 95.8-104.4%, respectively. It was demonstrated that the constructed sensor possesses the advantages of simplicity, excellent selectivity, superior sensitivity, and outstanding stability.

N,Si co-doped GQDs: Facile green preparation and application in visual identifying dihydroxybenzene isomers and selective quantification of catechol, hydroquinone and antioxidants

A green economical procedure for preparing N,Si co-doped graphene quantum dots (N,Si-GQDs) using waste toners and ethylene diamine was reported, which not only minimizes waste and promotes recycling but also offers an alternative method for producing N,Si-GQDs. At a pH of 8.5, hydroquinone and catechol underwent oxidation in the presence of air, resulting in the formation of diquinones, specifically p-phenyldiquinone and o-phenyldiquinone. Resorcinol, on the other hand, was converted into monoquinone. The interaction between diquinones and N,Si-GQDs caused a linear fluorescence quenching effect when catechol and hydroquinone were present. However, this effect was minimal in the case of resorcinol. Furthermore, the antioxidants glutathione (GSH) and ascorbic acid (AA) were observed to disrupt the redox equilibrium of catechol and o-phenyldiquinone, leading to the activation of fluorescence. Conversely, hydroquinone and p-phenyldiquinone, due to the highly stable and symmetrical structure of p-phenyldiquinone, did not exhibit this fluorescence activation. Based on the described "Off-On" sensor system, it was possible to visually identify dihydroxybenzene isomers and selectively quantify catechol and hydroquinone in environmental samples, as well as GSH and AA in human serum. The method detection limits were 0.93, 1.35, 2.34, and 1.37 μM for catechol, hydroquinone, GSH, and AA, respectively. In conclusion, the presented procedure offers several advantages, including environmental friendliness, cost-effectiveness, and a means of recycling waste toners. It also demonstrates the successful synthesis of N,Si-GQDs, as well as the potential for their application in the "Off-On" sensor system for the detection and quantification of various analytes.

Carbon Dots-Types, Obtaining and Application in Biotechnology and Food Technology

Materials with a "nano" structure are increasingly used in medicine and biotechnology as drug delivery systems, bioimaging agents or biosensors in the monitoring of toxic substances, heavy metals and environmental variations. Furthermore, in the food industry, they have found applications as detectors of food adulteration, microbial contamination and even in packaging for monitoring product freshness. Carbon dots (CDs) as materials with broad as well as unprecedented possibilities could revolutionize the economy, if only their synthesis was based on low-cost natural sources. So far, a number of studies point to the positive possibilities of obtaining CDs from natural sources. This review describes the types of carbon dots and the most important methods of obtaining them. It also focuses on presenting the potential application of carbon dots in biotechnology and food technology.

Mesoporous silica imprinted carbon dots for the selective fluorescent detection of triclosan

A molecularly imprinted fluorescence sensor built as a mesoporous structured silica imprinted layer on the surface of carbon dots (CDs@m-MIP) was employed for the selective detection of triclosan (TRI). The fluorescence of this CDs@m-MIP was affected sensitively and selectively by TRI via an electron transfer-induced fluorescence quenching mechanism with a detection limit of TRI at 1.08 nM (range 1.72-138 nM) under the optimum setup (e.g., pH, response time, and CDs@m-MIP dose). This approach was used successfully to detect TRI in real water samples (e.g., sewage, river, and tap water). The recoveries of TRI were satisfactory in spiked river and tap water (in 94.7-99.5 %). The outcome of this research is thus expected to help develop highly efficient fluorescent sensing systems towards diverse hazardous compounds including TRI.

Preparation of solvent-free starch-based carbon dots for the selective detection of Ru3+ ions

A simple, green, and solvent-free pyrolysis method for the preparation of starch-based carbon dots (CDs) was developed. The CDs prepared at 300 °C exhibited a highest quantum yield of 21.0%, which was mainly due to the high degree of graphitisation of the CDs. The CDs were selective for the detection of Ru³⁺ ion solutions.

A simple, green, and solvent-free pyrolysis method for the preparation of starch-based carbon dots (CDs) was developed.

Applications of Graphene Quantum Dots in Biomedical Sensors

Due to the proliferative cancer rates, cardiovascular diseases, neurodegenerative disorders, autoimmune diseases and a plethora of infections across the globe, it is essential to introduce strategies that can rapidly and specifically detect the ultralow concentrations of relevant biomarkers, pathogens, toxins and pharmaceuticals in biological matrices. Considering these pathophysiologies, various research works have become necessary to fabricate biosensors for their early diagnosis and treatment, using nanomaterials like quantum dots (QDs). These nanomaterials effectively ameliorate the sensor performance with respect to their reproducibility, selectivity as well as sensitivity. In particular, graphene quantum dots (GQDs), which are ideally graphene fragments of nanometer size, constitute discrete features such as acting as attractive fluorophores and excellent electro-catalysts owing to their photo-stability, water-solubility, biocompatibility, non-toxicity and lucrativeness that make them favorable candidates for a wide range of novel biomedical applications. Herein, we reviewed about 300 biomedical studies reported over the last five years which entail the state of art as well as some pioneering ideas with respect to the prominent role of GQDs, especially in the development of optical, electrochemical and photoelectrochemical biosensors. Additionally, we outline the ideal properties of GQDs, their eclectic methods of synthesis, and the general principle behind several biosensing techniques.

Red-emissive nitrogen doped carbon quantum dots for highly selective and sensitive fluorescence detection of the alachlor herbicide in soil samples

We report the synthesis of red-emissive nitrogen-doped carbon quantum dots and their applications in the highly selective and sensitive detection of the alachlor herbicide in soil samples.