Strain manipulation of the polarized optical response in two-dimensional GaSe layers

Strain engineering of hyperbolic plasmons in monolayer carbon phosphide: a first-principles study

Natural and tunable in-plane hyperbolic plasmons have so far been elusive, and hence few two-dimensional hyperbolic materials have been theoretically and experimentally discovered. Here, comprehensive first-principles calculations were conducted to study the electronic and plasmonic properties of biaxially strained monolayer carbon phosphide (β-CP). We found that (i) a compressed β-CP hosts strong anisotropic Dirac-shaped fermions with robust modulated Fermi velocity, (ii) for biaxial strain of -3% an unprecedented ultra-wide hyperbolic window is extended continuously from terahertz (9 THz) to mid-visible (blue light, 693 THz), (iii) the tunable optical Van Hove singularity as the origin of hyperbolic plasmons in deformed β-CP is disclosed, (iv) an elliptic to hyperbolic transition in the σ-near-zero regime is demonstrated in terahertz frequencies (9 THz), (v) the propagation angle of the concave wavefront can be actively tuned using biaxial strains, and (vi) hyperbolic dispersion reorientation from one principal axis to another orthogonal one under compressive strains larger than 8% is observed. This study sheds new light on the unique properties of hyperbolic two-dimensional (2D) materials having exotic optoelectronic characteristics which are promising candidates for anisotropic light control with ultimate dexterity in the flat optics.

Pressure induced structural phase crossover of a GaSe epilayer grown under screw dislocation driven mode and its phase recovery

Hydrostatically pressurized studies using diamond anvil cells on the structural phase transition of the free-standing screw-dislocation-driven (SDD) GaSe thin film synthesized by molecular beam epitaxy have been demonstrated via in-situ angle-dispersive synchrotron X-ray diffraction and Raman spectroscopy. The early pressure-driven hexagonal-to-rock salt transition at approximately ~ 20 GPa as well as the outstandingly structural-phase memory after depressurization in the SDD-GaSe film was recognized, attributed to the screw dislocation-assisted mechanism. Note that, the reversible pressure-induced structural transition was not evidenced from the GaSe bulk, which has a layer-by-layer stacking structure. In addition, a remarkable 1.7 times higher in bulk modulus of the SDD-GaSe film in comparison to bulk counterpart was observed, which was mainly contributed by its four times higher in the incompressibility along c-axis. This is well-correlated to the slower shifting slopes of out-of-plane phonon-vibration modes in the SDD-GaSe film, especially at low-pressure range (< 5 GPa). As a final point, we recommend that the intense density of screw dislocation cores in the SDD-GaSe lattice structure plays a crucial role in these novel phenomena.

Molecular Beam Epitaxy of Layered Group III Metal Chalcogenides on GaAs(001) Substrates

Development of molecular beam epitaxy (MBE) of two-dimensional (2D) layered materials is an inevitable step in realizing novel devices based on 2D materials and heterostructures. However, due to existence of numerous polytypes and occurrence of additional phases, the synthesis of 2D films remains a difficult task. This paper reports on MBE growth of GaSe, InSe, and GaTe layers and related heterostructures on GaAs(001) substrates by using a Se valve cracking cell and group III metal effusion cells. The sophisticated self-consistent analysis of X-ray diffraction, transmission electron microscopy, and Raman spectroscopy data was used to establish the correlation between growth conditions, formed polytypes and additional phases, surface morphology and crystalline structure of the III–VI 2D layers. The photoluminescence and Raman spectra of the grown films are discussed in detail to confirm or correct the structural findings. The requirement of a high growth temperature for the fabrication of optically active 2D layers was confirmed for all materials. However, this also facilitated the strong diffusion of group III metals in III–VI and III–VI/II–VI heterostructures. In particular, the strong In diffusion into the underlying ZnSe layers was observed in ZnSe/InSe/ZnSe quantum well structures, and the Ga diffusion into the top InSe layer grown at ~450 °C was confirmed by the Raman data in the InSe/GaSe heterostructures. The results on fabrication of the GaSe/GaTe quantum well structures are presented as well, although the choice of optimum growth temperatures to make them optically active is still a challenge.